rotational shear 中文意思是什麼

rotational shear 解釋
旋轉剪切
  • rotational : adj. 1. 旋轉的；輪流的，循環的。2. 【農業】輪作的。
  • shear : vt vi （sheared 〈古語〉 shore; shorn sheared）1 剪（羊毛等）；修剪（樹木）；剪（呢絨的）長毛。2 ...
  1. The equations of motion governing the axisymmetric elastic deformation of finite orthotropic cylindrical shells, involving the effect of transverse shear and rotational inertia, are derived. by applying the reverberation method, the displacement and the resultant forces of the shell in the phase space are expressed. then the transient waves in the finite orthotropic cylindrical shell subjected to the axisymmetric impact are obtained by using inverse laplace transforms. furthermore, the transient solutions are decomposed to the generalized ray integrals and computed numerically

    分析了計及剪切變形和轉動慣性的有限長正交異性圓柱殼中彈性瞬態波的傳播問題，採用回傳矩陣法，在相空間中給出了位移和內力的表達式。再利用laplace逆變換，得到正交異性圓柱殼受軸對稱沖擊作用時彈性瞬態波解，然後將其分解為若干廣義射線積分之和，並用數值方法求解之。
  2. Thecalculating results show that the composite action between concrete floor and steel beamsgreatly influence the bending bearing capacity and initial rotational stiffness of joints, it shouldbe considered in practical engineer. reinforcement ratio of lengthways reinforcing bar andthe stiffener of web have great influencer on the behavior of connections, while the thicknessof end - plate and degree of shear connection have a litter influence on its behavior

    分析計算結果表明:樓板與鋼梁的組合作用對節點的抗彎承載力及初始轉動剛度的影響非常大，實際工程中節點設計應當考慮這種組合作用;樓板內縱向鋼筋配筋率與柱腹板加勁肋對節點性能影響顯著，而連接端板厚度及剪力連接程度的影響則不是太顯著。
  3. It is also pointed out that the shear stress along the flow - in direction existing near the junction of straight and curve edges is one of the major components of drawing pressure, and it is very important in the calculation of drawing load of non rotational symetrical drawing

    並且指出，法蘭直、曲邊交界附近存在的流入方向剪切力是拉深力的主要成分之一，在非回轉對稱拉深載荷的計算中非常重要。
  4. Theoretical research on the rotational dispersion coefficient of fiber in the turbulent shear flow of fiber suspension

    纖維懸浮剪切湍流中纖維旋轉擴散系數的理論研究
  5. Some results acquired by computer calculation show that the rigid garnet pophyroblasts can rotate as their matrix flow, and the rotational degree depends on the shear force, ratio of poephroblasts to matrix and the locations of porphyroblasts in the model

    計算結果表明：剛性的石榴石斑晶會隨著基質的流動而產生旋轉運動，旋轉量的大小取決于剪切力的大小斑晶的密集度以及斑晶在剪切帶中的位置。
  6. The whole building can be equivalent to a cantilever bar, and the structural total displacements can be divided into parallel displacement and rotational displacement based on the harmonize condition of displacement, and the parallel shear and the rotational shear of the elements can be accordingly obtained by selecting the renegade body from top to bottom in turn

    根據位移協調條件，將結構的位移分解成平動與轉動成分，得到相應的結構平動時構件所承擔的剪力與結構轉動時構件所承擔的剪力，再根據力的平衡條件，推導出雙向地震作用下考慮構件抗扭剛度時結構的線彈性扭轉角，並對構件的剪力及變形進行了修正。
  7. Paints, varnishes and similar coating materials ; determination of viscosity at high shear rates using rotational viscometers

    油漆清漆和類似塗層材料.用旋轉式粘度計測定在剪切
  8. Plastics. polymers resins in the liquid state or as emulsions or dispersions. determination of viscosity using a rotational viscometer with defined shear rate

    塑料製品.液態或乳濁態或分散態聚合物樹脂.用確定的剪切速率旋轉粘度計測量粘度
  9. Plastics - polymers resins in the liquid state or as emulsions or dispersions - determination of viscosity using a rotational viscometer with defined shear rate

    塑料.液體或乳液或分散型聚合物樹脂.第2部分:用規定剪切速率回轉粘度計測定粘度
  10. Plastics - polymers resins in the liquid state or as emulsions or dispersions - determination of viscosity using a rotational viscometer with defined shear rate iso 3219 : 1993 ; german version en iso 3219 : 1994

    塑料製品.液態或乳液或漂移的聚合物樹脂.使用規定剪
分享友人
分享到 Line

分享到臉書