saturation mode 中文意思是什麼

saturation mode 解釋
飽和狀態
  • saturation : n. 1. 浸透，浸潤。2. 充滿；飽和。3. 【化學】飽和（狀態）。4. 飽和劑。5. 【物理學】磁性飽和。6. 【色】濃度，章度。7. 【商業】（市場的）飽和供應，足量供應。
  • mode : n 1 法，樣，方法，方式。2 模，型；樣式，體裁，款式；習慣。3 風尚；〈the mode〉流行，時髦。4 【語...
  1. Testing on logs in laminated shaly sands it demonstrates that the model can be applied in laminated shaly sands. testing on effects of rdc. and vdc representing clay resistivity and fraction or dry clay resistivity and fraction on water saturation calculated by the model it proves that it is very reasonable for rdc to be clay resistivity and vdc to be dry clay fraction, so the mode l derived from the paper can be used to evaluate shaly sands

    通過一組層狀泥質砂巖測井資料解釋，表明該模型適用於層狀泥質砂巖地層解釋；通過考察rdc 、 vdc代表粘土或干粘土電阻率及含量對該模型計算含水飽和度的影響，說明rdc代表粘土電阻率，而vdc代表干粘土含量是合適的，因此，使用文中給出的電阻率模型能更好地解決泥質砂巖問題。
  2. Point to above problems, under the financial support of the national natural science foundation ( exploration of high tech and new concept and new conceive ), the excellent young teachers program of ministry of education and national excellent doctoral dissertation special foundation, the static and dynamic real - time computation of elasticity - plastic mechanics, solving method of fuzzy finite element and other problems were studied in this paper. and some achievement was gained as following : ( 1 ) based on the positive definiteness of system stiffness matrix of finite element that was modified and the form of potential energy function of elastic body, the linear system of saturation mode ( lssm ) was introduced into the neural computation of finite element, by which the no - error solving of finite element neural net computation was realized in theory

    針對上述問題，在國家自然科學基金（高技術新概念新構思探索） 、教育部優秀青年教師資助計劃、高等學校全國100篇優秀博士學位論文作者專項基金等的資助下，本文對彈塑性力學問題的動靜態的實時計算、模糊有限元的求解方法等問題進行了系統和深入的研究，取得了以下成果： （ 1 ）根據有限元總剛矩陣經修正後具有正定性的特點以及彈性體勢能函數的具體形式，將飽和模式的線性系統（簡稱為lssm系統）引入到有限元的神經網路計算中，在理論上實現了有限元神經網路計算的無誤差求解。
  3. Solid astra luoyang fire of anti - corrosion materials engineering limited, founded in 1993, is the collection of china ' s famous anti - corrosion materials research and production and fire at the scene for the construction of an integrated enterprise, in addition to fire anti - corrosion coating production, but also professional cathodic protection system for the production of various sacrificial anode and supporting materials, products including magnesium - based, zinc - based, aluminum sacrificial anodes, with magnesium, magnesium rod, with zinc, titanium / mixed metal oxide anode zone, a titanium, astm265, high silicon anode cast iron, steel or cement testing poles, various reference electrode welding mode and flux, mandatory current cathodic protection act by magnetic saturation potentiostatic yee

    洛陽固雅特種防腐防火材料工程有限公司成立於1993年，是國內著名的集防腐防火材料科研生產和現場施工為一體的綜合性企業，除生產防腐防火塗料外，還專業生產陰極保護系統所需的各種犧牲陽極和輔助材料，產品包括鎂基、鋅基、鋁基犧牲陽極、鎂帶、鎂棒、鋅帶、鈦/混合金屬氧化物陽極帶、一級鈦、 astm265 ，高硅鑄鐵陽極、鋼制或水泥測試樁，各類參比電極、焊模和焊劑，強制電流法陰極保護用磁飽和恆電位儀等。
  4. The threshold and saturation voltage are important technology parameters in lcd. in this paper, by linearization method of the continuum theory of nematic liquid crystal, we show the analyzed results of threshold and saturation voltage of ips mode with tilt angle and weak surface anchoring conditions

    在液晶顯示器中，閾值電壓和飽和電壓是液晶顯示器的重要工藝參數，本文從連續體理論出發，同樣利用線性化處理的方法，給出弱錨定邊界條件下，有預傾角的ips型盒的閾值和飽和電壓的解析結果。
  5. Then according to the essential trial of electric drive system in electric vehicles ( evs ), it is built that the simulation model of induction motor drive system of evs in efficiency optimization control ( eoc ), which suits different motors for simulation and research concerning the running condition of evs. taking nonlinear saturation problem into consideration, simulation study on eoc is proceeded by using an actual motor acting as an example, comparison of eoc with classical u / f control mode is completed at the same time. it is analysed that the variation of losses and their distribution causing by eoc

    聯系實際的應用背景，提出了電動車的最大效率控制問題。然後，從電動車電驅動系統的基本特性出發，建立了電動車工況下最大效率控制的感應電機驅動系統模擬模型，通過實例在飽和非線性的條件下進行了最大效率控制的模擬計算。針對感應電機損耗將最大效率控制產生的損耗變化及分佈規律進行了研究，對鐵心損耗的影響進行了分析。
  6. The common - mode feed back ( cmfb ) circuit is realized by mos differential pairs which operated in saturation region so as to improve the loop gain of the cmfb

    共模反饋電路採用工作在飽和區的mos差分對來實現，提高了共模反饋迴路增益，加強對共模輸出電壓的控制。
  7. Secondly, basing on the theory of on - off gain of small signal, the raman gain coefficient for frequency shift between 0. 5 and 20 thz of standard sigle mode optical fiber is measured by pump - probe method through a super luminescent diode ( sld ) as a broadband small signal probe source. thirdly, numerical simulation analysis of gain characteristic of raman fiber amplifier for c band wdm signal light is made according to the raman gain coefficient of the fiber measured before through target and four rank runge - kutta method. at the invariability of wavelength and maximum power of each of two pumps, schematic of powers of two pumps for best flatness on c band wdm optical gain was found out, at the same time, the factors of resulting in gain saturation is analyzed, too

    本文首先應用經典的電磁理論對拉曼光纖放大器的工作機制進行了分析，然後，根據小信號理論推導出的開關增益求出了光纖拉曼增益系數的表達式，採用泵浦-探測波的方法，利用超輻射激光二極體（ superluminescentdiode簡稱sld ）作為探測光源，測量了所用標準單模光纖頻移為0 . 5 - 20thz的拉曼增益系數，之後根據所測得的光纖的拉曼增益系數譜對應用該類光纖構成的放大c波段wdm光信號的拉曼光纖放大器的增益特性採用打靶法和四階龍格- - -庫塔進行了數值計算，在給定了兩個泵浦光源的波長和最大功率后，找出了反向泵浦情況下使c波段wdm光源增益最平坦的兩個泵浦的各自最佳功率，同時也分析了導致信號光飽和的原因。
  8. The simulation results show that to start the oscillation, the length of the resonance cavity must be well matched with the radial span of the cavity ; mismatch of them will greatly affect the microwave development ; the output power of the microwave in rtto is affected by the microwave mode obviously. under the same conditions, the output power for temooi mode is the highest, and its start and saturation time of oscillation are the shortest. the results also show that the output power will decrease with the increase of the size of the extract window ; the operating state of rtto has great close relationship with the operating current, and there exists an optimum current value

    結果表明，束電壓一定時，諧振腔腔長和徑向間距必須良好匹配微波才能起振，匹配不佳會極大地影響微波產生；微波模式對微波產生功率影響很大，同等條件下， tem _ （ 001 ）模式的微波功率最高，起振時間和飽和時間最短；微波輸出功率隨提取口的增大而減小； rtto工作狀態與工作電流的大小關系密切，存在一個最佳工作電流值。
  9. The comparison between synthetic seismograms of different models indicates that the detail change of porosity and the mode of saturation changing with porosity are more complicated than assumed before

    而不同模型的地震合成記錄比較說明孔隙度的詳細變化以及飽和度隨孔隙度變化的模式要比以前假設的情況復雜的多。
分享友人
分享到 Line

分享到臉書