seat hinge 中文意思是什麼
seat hinge
解釋
活動座鉸鏈-
After an introduction to the research on the software for the design of the variant steel arched girder construction, the creation of the structural model, the structure of the supporting seat, the design of the variant arched girder, and the measures taken to ensure the stability of the plane surface of the arched girder, the thesis goes to study the methods for the hoisting and the angle setting of the long - span arched girders, as well as the bolting of the axle pin in the hinge support
論文首先對變異鋼拱架結構設計可採用的軟體、結構模型的建立、支座構造形式、變異拱梁的設計，以及保證拱梁平面外穩定所採取的措施等進行了研究，然後研究了大跨度變異鋼拱架弧形梁吊裝、角度的調整、鉸支座穿軸銷等的施工方法，最後對施工完成後的位移進行了實際量測。 -
In this study, sts - - the steel construction design module of pkpm, a software program of china " s institute of the construction science - - is employed to create the construction model in order to study the construction of the supporting seat. a mechanical analysis of the variant arched girders was implemented, with the result that consturction documents meeting mechanical requirements were designed for the hinge support, the roller support and the steel girders
本文採用中國建築科學研究院pkpm軟體的鋼結構設計模塊sts ，從結構建模入手，根據規范要求研究了支座的構造形式，通過對變異拱梁的力學分析，設計出符合力學模型的鉸支座、滑移支座和變異拱處鋼梁的施工圖。 -
The unique pacific tilting disc check valve internal disc hanger not only eliminates potential leakage through external hinge pins, but because the hanger shelf is machined parallel to the seating surface, it allows adjustment of the disc / seat if seat repair is ever required
獨特的美國太平洋翻轉式閥瓣止回閥內置閥瓣鉸鏈銷不但消除了穿透閥殼的鉸鏈銷可能出現的泄漏現象，而且由於經過機加工的支架平行於閥座表面，使得維修閥座時，能夠調整閥瓣/閥座。 -
In order to ensure that each valve flap valve seat surface can reach the appropriate location, in valve design hinge agencies, in order to have enough plug valve kai xuan space, and the valve genuine and comprehensive engagement with the valve seat
為了確保閥瓣每次都能到達閥座面的合適位置，閥瓣設計在鉸鏈機構，以便閥瓣具有足夠有旋啟空間，並使閥瓣真正的、全面的與閥座接觸。 -
The entire seat - hinge - pin - disc assembly can be tested outside the valve before placing into the body and seal welding. eliminates pin seal leakage
在安裝到閥體內部和進行密封焊接之前，全部的閥座-鉸鏈-銷釘-閥瓣總裝可以在閥門外部進行測試。避免銷釘密封泄漏。
分享友人