separation size 中文意思是什麼

separation size 解釋
分級粒度
  • separation : n 1 分離；分類；分開。2 隔開；間隔；脫離。3 （夫婦的）分居。4 分隔物。5 【化學】離析；析出；釋出...
  • size : n 1 大小，尺寸規模身材。2 （鞋帽等的）尺碼，號；（紙張的）開。3 巨大，大量；相當大的分量。4 〈口...
  1. The influence of particle size on separation of diaspore and kaolinite

    粒度對一水硬鋁石和高嶺石浮選分離的影響
  2. There was no difference in other biologic characteristic of mscs between the two separation method, such as cell anchorage ratio and clone formation ratio. ( 2 ) plga film presented uniformity frame with no protuberance and fissure under scanning electron microscopy ( sem ). big aperture with smooth wall and average 400 m i n size running - through each other was observed in porous plga substrate, around the big aperture there were many round micropores about 5 m size. all of the structure were equal and uniform, which satisfied the further research work. ( 3 ) mscs adhesion at earlier time was promoted by biotiegenrafter 3h, cell number was ( 1. 5 0. 18 ) 105 in the plga film coated with biotiegen group, which was significantly higher than that in plga film group ( p < 0. 01 ) and higher than that in coverslip group ( p < 0. 05 ), which cell number was ( 1. 04 0. 21 ) 105. after 6h and 12h biotiegen could not promote cell adhesion, and cell proliferation and alkaline phosphatase ( alp ) activity were not promoted dramatically during 9 days. ( 4 ) cell adhesion was promoted by fibronectin or collagen type i

    G ） i型膠原、纖維粘連蛋白促進細胞增殖，細胞接種后3 、 6 、 gd三個檢測時間點，實驗組細胞均明顯高於對照組。與1型膠原相比，纖維粘連蛋白刺激作用更強。 ） i型膠原、纖維粘連蛋白尚能誘導mscs細胞向成骨細胞分化，不僅表達成骨細胞標志物ocn 、 alp 、 opnmrna ，而且堿性磷酸酶活性明顯增高，堿性磷酸酶及鈣結節7第四軍醫大學博士學位論文一染色均強陽性， i型膠原組mscs細胞堿性磷酸酶活性較fn組更高，有顯著性差異；同時，兔疫組化染色表明，經纖維粘連蛋白作用的mscs1型膠原表達陽性。
  3. " the polish people s republic " ( 1945 - 1989 ) covered the territory similar in size to the poland of the piast dynasty, but the country was dominated by the soviet union. although the fall of communism did not bring any border changes, with the fragmentation of the soviet union, the czecho - slovak separation and german reunification, all of poland s neighbors changed

    第二次世界大戰后，波蘭在西部和北部重新獲得歷史上屬于皮亞斯特第一王朝的領土以及波羅的海南部長達500公里的沿海地帶。波蘭人民共和國（ 1945 1989 ）的疆土面積與皮亞斯特王朝時大小相似。
  4. Nor does metal roller milling exhaust the list of important innovations in grain processing, for we also see continuous improvements in grain - separation technology, faster analysis of mill batches for protein content among other things, and greater control over flour particle size and uniformity

    金屬磙筒只是穀物加工方面眾多重要的發明之一。我們還看到：穀物去殼技術的不斷改進，批量碾磨中蛋白含量的更快速的鑒定，還有對粉狀顆粒大小和均勻性的更有效的控制。
  5. A theory model about wheat grinding and sifting was presented by collection of and study on foreign and domestic documents, which mainly refer to change of ground particle size between input and output, and mathematics description for material separation by a still and inclined sifting surface

    摘要通過對國內外文獻的整理和研究，列出了小麥研磨和篩分分離的基礎理論模型，主要是研磨顆粒輸入與輸出粒度的變化和靜止傾斜篩面物料分離的數學描述。
  6. The petroleum chemical industry with the activated charcoal evengrain - size distribution, the high benzene adsorption dynamics, wear - resisting, resists corrosion, the selective adsorption performance isoutstanding, mainly uses in the petroleum, the natural gas and thecarbonificated industry vapor phase live pressure adsorption, theliquid phase separation, the solvent recovery, the liquid and the gasproduct purifies, and is mad in the fluid product organic sulfideremoveing

    均勻的粒度分佈，高的苯吸附力，耐磨、耐蝕，選擇吸附性能優異，主要用於石油、天然氣及煤化工業的汽相變壓吸附，液相分離，溶劑回收，液體及氣體產品凈化，及氣液產品中的有機硫化物的去除。
  7. Aim : to analyze the mechanism, thermadynamic theoretical basis, dynamic mechanism and influencing factors of thermally induced phase separation ( tips ) in order to completely grasp the factors affecting the size, distribution and form of pores, so that the adjusted range of pore can be widened and the preparation of porous membrane can be repeated and controlled. methods : considering from the structural characteristics of tissue engineered materials, the methods of preparing porous membrane using tips technique, the hermadynamic theoretical basis, dynamic mechanism and influencing factors were analyzed, the problems and investigative directions in the future were also analyzed. tips technique is a process of phase separation of polymer homogenous solution under quenching, and it is suitable for diameter and structural form of the micropore materials prepared using tips are closely correlated with the kind and dispensing proportion of polymer attrnuant, polymer concentration and polymer molecular mass, etc. conducted, including determination of polymer - solvent system phase diagram, study of form and appearance of porous membrane of different thickness, study of form and appearance of porous membrane prepared with systems of different x, which is the parameter of polymer - solvent interaction

    目的:分析熱致相分離成膜過程的機理、熱力學理論基礎、動力學機制以及影響因素，以便充分掌握影響孔度大小、分佈、形態的因素，使孔度調控范圍得以拓寬，使多孔膜的制備能重復可控.方法:從組織工程材料結構特點出發，分析熱致相分離聚合物多孔膜的制備方法及該法成膜的熱力學理論基礎、動力學機制以及影響因素.並分析實驗中存在的問題及今後的研究方向.結果:以熱致相分離法可制備聚合物多孔膜.熱致相分離法制備多孔膜是高聚物均相溶液在淬冷條件下發生相分離的過程，它適用於上臨界共溶溫度型聚合物一稀釋劑二元體系.熱致相分離法成膜的過程，可以認為是旋節線機理佔主導地位.熱致相分離法制備的微孔材料，其孔隙率、孔徑大小、結構形態與聚合物稀釋劑的種類、組成配比、聚合物濃度、聚合物分子量等因素密切相關.結論:可採用熱致相分離技術制備多孔膜，通過改變不同的成膜條件可獲得一系列不同孔徑尺寸和孔徑分佈的多孔膜材料.對熱致相分離成膜過程中聚合物-溶劑體系的相圖測定，不同厚度的多孔膜形貌研究，不同x （聚合物-溶劑相互作用參數）體系所制備的多孔膜形貌等需深人研究
  8. Secure print, proof print, saved print, personal print, job completion notification, edge - to - edge printing, booklet printing, negative and mirror images, scaling, auto fit, watermarks, custom size paper, cover pages, collation, remote printing, separation pages, n - up printing, image smoothing, pdfdirect printing, saved job repository, mailinx e - mail alerts requires hard disk operating

    安全列印校樣列印存儲列印個人列印作業完成通知邊到邊列印小冊子列印負片圖像與鏡像縮放自動匹配水印定製尺寸紙張封面頁分頁遠程列印分隔頁多張合一列印圖像平滑處理pdf直接列印列印作業磁盤存儲mailinx電子郵件提醒須有硬盤。
  9. Based on one dimension flow theory and lagrange method, the correlation of speeding rate of particles under gas flow drag with the size of particles and the length of laval nozzle used for the gas and solid two - phase separation test apparatus was studied

    摘要採用一元流動理論和拉格朗日方法，研究了用於氣、固兩相分離試驗裝置的縮放噴管內，被氣流拖曳的顆粒加速率與顆粒大小和縮放噴管長度的關系。
  10. Superstrength emulsification, dehydration and degassing system. adopted big - cubage, reinforced three - dimension flash evaporating tower and membrane evaporation technology and big - size multiple - level separation technology of oil, water and gas to remove water content, gas and lightweight hydrocarbon efficiently and quickly

    超強破乳化脫水脫氣系統，採用大溶積增強型立體閃蒸塔和薄膜蒸發技術及大面積多層次油水氣分離技術，能高效迅速除去油中的水分氣體輕質烴。
  11. Properties of filler ( such as carrier ' s shape, particle diameter, pore size, surface area, as well as surface coverage, carbon content and bonded types of the bonded group ) and filling of chromatographic column shall directly affect retention behavior and separation effect of the articles to be tested

    填充劑的性能（如載體的形狀、粒徑、孔徑、表面積、鍵合基團的表面覆蓋度、含碳量和鍵合類型等因素）以及色譜柱的填充，將直接影響待測物的保留行為和分離效果。
  12. Due to the hierarchical porous structures with pore size ranging from nanometer to micrometer scale, these materials have potential applications in many fields such as heterogeneous catalysis, adsorption / separation, exhaust gas treatment and so on

    由於具有豐富的分級多孔結構和優良的機械性能，生物形態材料在催化、分離與吸附和高溫尾氣處理等領域具有廣泛的應用前景。
  13. By using atomic force microscopy ( afm ) investigation on the membrane surface, different separation properties can be explained very well according to the data of pore size. increasing temperature or nmmo concentration of coagulation bath or decreasing concentration of casting solution leads to larger skin pore size, wider pore size distribution and higher values of the roughness parameters

    用原子力顯微鏡（ afm ）對膜表面形態的分析表明：膜表面孔徑隨著鑄膜液濃度的降低、凝固浴溫度和濃度的升高而逐漸變大，且孔徑分佈變寬。
  14. Pneumatic and automatic separator of injector valve and orifice is based on pneumatic measurement and 8051 mcu, which is used for data processing and control. it can automatically separate injector valve and orifice, whose nominal size is 6 and tolerance is + 10u, with the interval of 1u, accuracy of 0. 5u and speed of twenty pieces per minute around. the automatic separation system of injector valve and orifice has low cost, high separation accuracy, high separation speed and easy operation

    使用氣動噴油嘴偶件針閥、針閥體自動分選系統能實現對公稱尺寸為6 、公差為10的噴油嘴偶件針閥、針閥體按1分選間隔、 0 . 5分選精度的自動分選，分選時的速度可達每分鐘20件左右。
  15. The relation of fft size and the length of reverberation in bss implementation in frequency domain and its influence on the performance of separation are investigated. 2. a new fixed - point ica algorithm is introduced into bss for audio mixtures, and an algorithm of bss based on fir matrix algebra with block implementation is given

    本文嘗試將一種新的定點ica演算法用於分離多通道混合語音信號，給出了一種基於fir矩陣代數技術的時頻域的新演算法，實驗證明了演算法的有效性和較快的收斂速度。
分享友人
分享到 Line

分享到臉書