series impedance 中文意思是什麼

series impedance 解釋
串聯阻抗
  • series : n 〈sing pl 〉1 連續;系列。2 套;輯;叢刊;叢書。3 【生物學】區;族。4 【植物;植物學】輪;列;...
  • impedance : n. 【物理學】阻抗。 acoustic impedance聲阻抗。
  1. Electrical conductivities of quartz, olivine, dunite, iherzolite, pyroxenite, and megaaugite were measured by virtue of the new system ; whereas, the electrical conductivity of gabbro was measured by means of the old one. an interesting outgrowth of the present study is the measurement of the complex impedance of a series of quartz plates with different orientations

    石英(人造水晶) 、橄欖石、純橄欖巖、輝石巖、二輝橄欖巖、巨晶輝石的電導率測量是在新的測量系統下獲得的,而輝長巖的電導率測量是基於lcr儀為測量儀器的測試系統下獲得的。
  2. The way of taking one nth out of capacitor ' s the first harmonic capacitive reactance as its nth harmonic impedance is verified whit the data from tang7c. according to the approximately estimating method, the first harmonic impedance of 220kv system is calculated. on the basis of the models, this paper gives the harmonic equivalent circuit of substation and gives the b ( n ) function of the harmonic time n. when the capacitors has different combination, b ( n ) ' s value will also change, with the inputting local measurement data, the paper studies the series and parallel resonance at the substation, and deduces that the reason the capacitor ' s fuse of tang6c is frequently interrupted is that its capacitor current contains a large number of 5th harmonics, and that the reason the discharging pt of tang7c capacitor being exploded is also that the 7th and 9th harmonic currents are amplified

    據此,對該站進行了串聯諧振分析和並聯諧振分析,並結合測試數據和有關變電站的運行記錄,指出了導致該站電容器湯6c頻繁燒保險的主要原因是5次諧波電流含量偏高,引起湯7c放電pt爆炸也是因為7次和9次諧波電流被放大。針對這些導致湯陰變電站補償電容器故障的原因,提出了相應的諧波治理措施,包括針對湯6c電容器5次諧波電流含量偏高的原因,提出了停運湯6c電容器或者通過把湯sc電容器的部分容量併入湯6c電容器(湯sc其餘部分停運)以增加湯6c諧波承受能力的措施;針對# 2變低壓側7次和9次諧波電流被放大的現象,提出了在湯7c電容器上加裝一定百分比的串聯電抗器的措施。
  3. The theoretic calculating method of the maximum and the minimum water level in the differential surge tank has been derived firstly. also the explicit method of calculating surges in the differential surge tank has been deduced firstly by use of thaler series expansion. the calculating method of section of the well and the effective impedance hole in the surge tank has been gived

    根據差動式調壓室的基本微分方程,首次推導出了差動式調壓室涌浪幅值的理論計算公式;並同樣利用泰勒級數展開方法推導出了差動式調壓室水位波動的顯式計算式;導出了差動式調壓室大井面積和有效阻抗孔面積的計算方法。
  4. Abstract : according to the continuative condition of the tangential fields on the slot aperture which is the inclined narrow - slot on the broadwall of a sectoral waveguide, the moment method is used to calculate the magnetic current coefficient and distribution. then the scattering field, the scattering parameter and the equivalent impedance are obtained. leting only the te11 dominant mode propagates in the waveguide, the scattering parameters and the normalized equivalent series impedance in the x - band are computed. the basis disigned the slot antenna and the slot array is offered

    文摘:根據縫隙口面切向場的連續條件,採用解析數值法矩量法,對扇面波導寬壁上窄的斜縫進行了計算,解得了磁流系數及其分佈,並得到散射場、等效散射參量及等效阻抗等重要參數.假定波導中僅有te11主模傳輸,在x波段計算了散射參量和歸一化等效串聯阻抗,給出計算結果,為縫隙天線和縫隙陣列設計提供了依據
  5. For the first time, the coaxial ridge - disk - loaded cylindrical waveguide as sws is presented. its dispersion equation and the expression of coupling impedance are given by application of the field matching method. a series of numerical results show that the influence of structure dimensions on the dispersion characteristics and interaction impendance

    三、創造性地提出脊加載同軸膜片圓波導慢波結構,並對其採用嚴格的場匹配法,詳細推導了色散方程和耦合阻抗表達式,並得到一系列有關系統結構參量與色散和耦合阻抗之關系的數值模擬結果。
  6. The impedance matching criterion that the sum of all the radiating slot normalized conductances is equal to 2 for the inner feed, and also the sum of all the coupling slot normalized impedances for the series - shunt inner feeder is equal to 2 are verified by using microwave network theory

    採用微波網路理論,在內部饋電情況下,分別對一條輻射波導上輻射裂縫的歸一化導納和為2的匹配設計準則,以及對串並形式饋電裝置,對耦合裂縫的歸一化阻抗和為2的匹配設計準則進行了證明。
  7. A series of experiments were conducted to research on electrode according to the principle of energy - storage materials, electroly tes, preparation techniques with the aids of the measure methods such as cyclic voltammetric measurements ( cv ), constant charge / discharge measurements, impedance spectrum, x - rays diffraction ( xrd ), transmission electronic microscope measurements ( tem ), and so on

    本文採用了循環伏安、恆電流充放電、交流阻抗、 x射線衍射、透射電子顯微鏡等實驗方法和測試手段對超大容量電容器的電極活性物質材料及電極製作工藝、電解質溶液的選取等問題展開了一系列研究。
  8. Aerospace series - cables, electrical, aircraft use - test methods - transfer impedance

    航空航天系列.飛行器用電纜.試驗方法.轉移阻抗
  9. The minimum requirement for sensitivity shall be such that a succession of not less than 20 breakdowns of the spark gap shall cause the fault indicator to register neither more nor less than one cunt per breakdown when the spark gap is open and is of the length shown above, with the current limiting impedance in series with the gap

    在最底靈敏度測試的時候,應先接入上述要求的人工擊穿裝置,啟動人工擊穿裝置,使金屬板與金屬針間的火花間隙被連續擊穿20次,要求火花試驗機的擊穿計數器應記錄20次,對每次擊穿都應準確無誤地計數,不應多計也不應少計。
  10. The minimum requirement for sensitivity shall be such that a succession of not less than 20 breakdowns of the spark gap shall cause the fault indicator to register neither more nor less than one count per breakdown when the spark gap is open and of the length shown above, with the current limiting impedance in series with the gap

    在最底靈敏度測試的時候,應先接入上述要求的人工擊穿裝置, ,啟動人工擊穿裝置,使金屬板與金屬針間的火花間隙被連續擊穿20次,要求火花試驗機的擊穿計數器應記錄20次,對每次擊穿都應準確無誤地計數,不應多計也不應少計。
  11. Owing to weak output signals integrated amplifier is designed, which is characteristics of shorter wires, higher input impedance, higher common mode rejection ratio and series mode rejection ratio, smaller zero shift and temperature shift

    由於輸出信號微弱,採用短線路傳輸,高輸入阻抗,共模抑制比和串模抑制比高,溫漂和零漂小的集成運放電路。
  12. It is considered that, the physical process of generating quasi - isentropic compression on target via flier - plates with graded wave impedance can be stated as follows : a series of hungoniot curves with different original state forms the p - v relation of the target when impacted by a flier - plate with graded wave impedance

    梯度飛片撞擊靶板獲得的p - v線是一組通過靶材料不同起始狀態點的hugoniot線的連線,這條連線可以近似看作是由小段小段等熵線連接而成的「準等熵線」 。
  13. The physical process of generating quasi - isentropic compression on target via flier - plates with graded wave impedance might be considered as the successive overlap of a series of small shock loading waves generated by the transition layers in the flier - plate. as a result, the p - v curve of the target was a quasi - isentropic compression curve, which consisted of small hugoniot curves ( similar to isentropic curves ) from different original states, and was located between the hungoniot curve and isentropic curve but closer to the latter

    波阻抗梯度飛片對靶板的壓縮過程是一系列弱沖擊加載波相繼發生作用疊加的結果,靶板由此獲得的p - v線是一組通過不同起始狀態點的hugoniot線的連線,這條連線可以近似看作是由小段小段等熵線連接而成的準等熵線。
  14. Aerospace series - elements of electrical and optical connection - test methods - part 708 : electrical elements - measurement of surface transfer impedance of couplers

    航空航天系列.電氣及光學連接元件.試驗方法.第708部分:電氣元件.耦合器的表面傳輸阻抗的測量
  15. Aerospace series - elements of electrical and optical connection ; test methods - part 708 : electrical elements ; measurement of surface transfer impedance of couplers ; german and english version en 2591 - 708 : 2001

    航空航天系列.光電連接件.試驗方法.第708部分:電氣元
  16. Aerospace series - cables, electrical, aircraft use - test methods - part 807 : transfer impedance

    航空航天系列.飛機電纜.試驗方法.第807部分:傳輸阻抗
  17. Aerospace series - cables, electrical, aircraft use ; test methods - part 807 : transfer impedance ; german and english version en 3475 - 807 : 2002

    航空航天系列.航空用電纜.試驗方法.第807部分:傳輸阻
  18. Aerospace series - elements of electrical and optical connection - test methods - part 701 : electrical elements - measurement of open circuit impedance of couplers

    航空航天系列.電氣及光學連接元件.試驗方法.第701部分:電氣元件.耦合器開路阻抗的測量
  19. Aerospace series - elements of electrical and optical connection ; test methods - part 701 : electrical elements ; measurement of open circuit impedance of couplers ; german and english version en 2591 - 701 : 2001

    航空航天系列.光電連接件.試驗方法.第701部分:電氣元
  20. The results show that, the process of quasi - isentropic compression on target can be seen as the successive overlap of a series of small shock loading waves generated by the transient layers. the design for flier - plates with graded wave impedance should conform to the parabolic or cubic function relationship between the impedance and the thickness

    波阻抗按高冪次函數(冪次在二次至三次之間)分佈的梯度飛片能夠獲得波形較好的準等熵壓縮波,並且靶板的厚度不宜太小也不宜太大。
分享友人