shear-compression failure 中文意思是什麼

shear-compression failure 解釋
剪壓破壞
  • shear : vt vi （sheared 〈古語〉 shore; shorn sheared）1 剪（羊毛等）；修剪（樹木）；剪（呢絨的）長毛。2 ...
  • compression : n. 1. 壓縮；壓緊；濃縮，緊縮。2. 加壓；壓抑。3. （表現的）簡練。4. 應壓試驗。
  • failure : n 1 失敗 （opp success）; 不及格。2 不足，缺乏；衰退；【醫學】衰竭。3 不履行，玩忽。4 破產，倒閉...
  1. The shear mechanism, failure mode, deformation capacity, bearing capacity and the reliability of the anchored angle steels of the wrapped steel concrete cast - in - site frame typical story exterior joints under the middle and high axial compression ratio ( n = 0. 3, 0. 5, 0. 6 ), the working performance, failure mode, and the shear capacity of top story joints under the crack moment, the hysteresis characteristic and the dissipation energy capacity of the test joints are all analysed based on the 1 / 4 model pseudo - static tests of five specimens of wrapped steel concrete cast - in - site frame exterior joints, which varied in axial compression ratio, distribution of the beam angle steels and the stirrup ratio

    基於上述分析，本次試驗通過五個外包鋼混凝土邊節點1 4比例模型的偽靜力試驗，以柱的軸壓比、梁角鋼布置形式、配箍率等為主要參數，分析外包鋼混凝土現澆框架一般層邊節點在中高軸壓比（ n = 0 . 3 、 0 . 5 、 0 . 6 ）條件下，節點的抗剪機理、破壞模式、變形能力、承載能力和角鋼錨固的可靠性；分析了頂層邊節點在張開彎矩作用下的工作性能、破壞模式和抗剪承載力；分析了試驗節點的滯回性能和耗能能力。
  2. Saturated sand are testes in the laboratory under the undrained cyclic loading condition with static - dynamic dual purpose triaxial compression test apparatus, which is designed under the cooperation of hohai university and marui co. ltd japan. the results indicate that the stress path approaches from a initial stress point to the failure lines as cyclic loading goes on, and eventually converges on a certain limiting stress path in the vicinity of the failure lines. the stress - strain curve, however, does not converge on a closed hystersis loop ; the shear strain rapidly increases in looser sand or gradually and continually increases in denser sand

    利用河海大學與日本圓井株式會社共同研製的新型的多功能靜動三軸儀進行了飽和砂土循環扭剪不排水試驗，研究表明，對于松砂，剪應變幅度快速地由微小增加到百分之幾甚至百分之十幾，對于緊砂，剪應變幅度逐漸地由微小增加到百分之幾甚至百分之十幾；經試驗初步研究表明用初始有效平均正應力歸一化的有效應力路徑很好的一致性。
  3. Abstract : based on the data obtained from field observations and deformation monitoring, this paper deals with the deformation and failure of a double - decked slope composed of soft rock strata in its lower part and hard - brittle rock strata in its upper part. it is demonstrated that the deformation of this kind of slopes is always initiated by the non - homogeneous rheological compression of the lower soft rock strata, leading to the tension fracture and toppling of the upper hard rock strata, and at last the sliding of the whole deformed body will be caused by the shear failure along the stress - concentration zone in the lower soft rock mass under the actions of the gravitational loading and infiltration water

    文摘:以現場考察和變形監測資料為依據，探討一個下部有軟弱基座，上部為硬脆性坡體的「二元結構」邊坡的變形破壞問題，揭示這類邊坡的變形總是以下部軟弱巖體的不均勻壓縮流變為先導，進而引起上部硬脆性坡體的拉裂與傾倒，最終通過滲入水的作用，使下部承載狀況已進一步惡化了的軟弱巖體，沿剪應力集中帶發生剪切破壞而導致整個變形坡體的下滑。
  4. Finally, an applied formula of beam ' s shear resistance is advanced when the beam ' s shear failure model is the shear - compression failure

    最後把剪壓破壞范圍內的理論抗剪公式進行簡化，提出一實用的抗剪計算公式。
  5. Make using of the critical point of the arch failure transiting to the tooth failure ( which is also the point when the non - stirrup beam ' s shear bearing capacity arrives to its minimum ) which is advanced in the arch - tooth theory of beams without shear reinforcement by g. kani and the critical point of the diagonal - tension failure transiting to the shear - compression failure which is advanced in the anti - theory, the minimum shear resistance of general bea ms which is destroyed in the range of shear - compression failure is advanced

    利用g . kani提出的拱?齒理論中的無腹筋梁的拱齒破壞的分界點（也就是無腹筋粱的最小抗剪承載力點） ，再結合前述理論中所提出的梁剪壓破壞和斜拉破壞的分界點，提出了梁在延性的剪壓破壞范圍內的最小抗剪承載力，並與混凝土結構設計規范gb50010 - 2002比較，結果吻合較好。
  6. The minimum shear resistance of beams in the paper is close to the one in the code for design of concrete structures " gb50010 - 2002 '. according to the actual project, the destroy of 448 kinds of beams are analyzed by computer by taking account of the effective coefficient " " of the strength of concrete confined by hoops, the relationship with the section property of beams, the critical point of the arch - rib failure transiting to the shear - compression failure which is advanced in the anti - theory, and the contribution to the beam ' s shear resistance of the concrete in the shear - compression zone

    引用箍筋約束混凝土的有效系數，利用其與梁截面特性的關系並結合理論分析中提出的梁剪壓破壞與斜壓破壞的分界點，同時考慮了剪壓區混凝土的抗剪貢獻，從工程實際出發，編程擬算了448種梁構件的破壞情況，計算結果表明，梁發生在剪壓破壞范圍內的最大抗剪承載力值比混凝土結構設計規范gb50010 - 2002值略高。
  7. Standard test method for creep and time to failure of adhesives in static shear by compression loading wood - to - wood

    用壓縮負荷靜剪切法法測定膠粘劑蠕變和老化時間的標準試驗方法
  8. Coupling beams " failure mode, shear distortion, ductility and energy dissipation were impacted by different shear - compression ratio from 0. 15 to 0. 20

    是一種值得推薦的抗震聯肢墻小跨高比洞口連梁的配筋形式。
  9. Numerical analysis of rock joint failure under compression - shear stress

    巖石節理壓剪破壞的數值分析
  10. It is found by comparison that as the structural forms of special - shaped columns and short - shear walls are used, the structures should be arranged reasonably so as to meet the needs of lateral stiffness, and axial compression ratio should be controlled strictly so as to meet the needs of constructional reinforcement to prevent the probably curling and shear failure for the purpose of meeting the needs of the construction of small high - buildings

    對比討論發現：採用鋼筋混凝土異形柱和短肢剪力墻的結構形式時，應當進行合理的結構布置以滿足結構整體抗側移剛度的要求，同時嚴格控制豎向構件軸壓比並滿足配筋構造以防止構件可能出現的翹曲和剪切破壞，這樣才能同時滿足小高層住宅對建築和結構的需要。
  11. Also the failure modes and the cracking torque, original stiffness, ultimate torsion strength and ductility are discussed in this case. the factors affected torsion bearing capacity of high - strength concrete frame column is analyzed too. the seismic performances of normal - strength and high - strength concrete frame column subjected to biaxial eccentric compression, shear and reversed torque are studied

    以軸壓比和相對偏心距為主要研究參數，揭示高強鋼筋混凝土構件在單向、雙向偏壓剪單調、反復扭矩作用下的破壞特徵、開裂扭矩、剛度、強度、延性等特性，分析了影響高強混凝土框架柱抗扭承載力的因素。
  12. Making use of the " truss + arch " mechanical model, the range of the three shear failure models ( shear - compression failure, diagonal - tension failure and arch - rib failure ) is divided quantitatively, and the theoretical formula of shear resistance of beams and columns is educed

    利用修正的桁架+拱抗剪力學模型，定量的劃分了樑柱構件受剪破壞三種狀態（剪壓破壞、斜拉破壞和斜壓破壞）的范圍，並由此推得樑柱構件抗剪的理論公式。
  13. By tests of 9 specimens subjected to biaxial eccentric compression, shear and reversed torque, the failure modes and the varying laws of cracking torque, original stiffness, ultimate torsion strength and ductility are discussed, with the change of axial stress level and relative eccentricity. then, the cracking bearing capacity, the ultimate capacity and the deformability of the specimens are obtained

    通過9根承受雙向偏壓、彎、剪構件在反復扭矩作用下的試驗研究，以軸壓比和相對偏心距為主要研究參數，揭示鋼筋混凝土構件中雙向偏壓剪反復扭矩作用下的破壞特徵、開裂扭矩、剛度、強度、延性等特性和耗能性能，從而確定其開裂承載能力和極限承載能力及變形性能。
分享友人
分享到 Line

分享到臉書