signal distortion 中文意思是什麼

signal distortion 解釋
信號畸變, 信[符]號失真
  • signal : n 1 信號，暗號；信號器。2 動機，導火線 （for）。3 預兆，徵象。adj 1 暗號的，作信號用的。2 顯著的...
  • distortion : n. 1. 歪扭，扭曲。2. 【電學】（信號、波形等的）失真；【物理學】（透鏡成像產生的）畸變；【醫學】扭轉，變形。3. 竄改，歪曲，曲解。adj. -al
  1. In the design and application of electronic engineering, both in open circuit and in closed circuit, signal is certainly affected by environment, the status of the transport network and the change of the parameters of the components applied. then the characters of useful information will be changed more or less and the change is generally called as distortion, namely so - called signal distortion

    =在電子工程的設計和應用中，信號無論在開路傳輸或閉路傳輸中都受到環境、傳輸網路的工作狀態和應用的元器件參數變化的影響，從而會或多或少地改變有用信息的性質，這種變化就是所謂的信號畸變現象，通常稱作失真。
  2. Tacholess order tracking filtering for run - up or coast down vibration signal of rotating machinery based on zero - phase distortion digital filtering

    無轉速計旋轉機械升降速振動信號零相位階比跟蹤濾波
  3. In the digital mobile communication, with the effect of modulation, transmission channels and demodulation, the received signal ineluctably has some distortion. frequncy offset is one of them

    在移動通信系統中，信號經過調制發射、通道傳輸和接收解調的過程中，不可避免的會引入一些干擾，使得有用信號受到影響。
  4. Since the envelope of modulated signal fluctuates, these methods generate unwanted intermodulation distortion ( imd ) products in a nonlinear radio frequency ( rf ) power amplifier ( pa ). so it is necessary to use linearization technique to reduce the adjacent channel interference ( aci )

    但包絡變化的調制信號經過非線性射頻功放后會產生交調分量，因此必須採用線性化技術來減少由此產生的鄰道干擾。
  5. Computer simulation results show that the proposed algorithm reduces the signal distortion and the reverberation which are caused by misadjustment errors in the adaptive filter and the correlated component of the speech in the reference signal compared with a conventional adaptive noise canceller ( anc )

    模擬結果證明nanc演算法有效克服了影響傳統自適應噪聲抵消系統（ anc ）性能的一些瓶頸，如兩輸入中的非相關噪聲，參考輸入中的信號成分與自適應濾波器失調誤差而產生的信號失真、回響等情況。
  6. The mathematic models of sampling and reconstruction are analysed respectively, and an important conclusion is got, that oversampling can decrease high frequence distortion of d / a output signal and the difficulty of designing lowpass filter. as a result the signal quality is improved

    分析了采樣和重構的數學模型，得出了一個重要結論:過采樣可以減少d / a輸出信號的高頻端衰減失真，可以降低低通濾波器的設計難度，從而提高波形質量。
  7. Signal distortion includes three kinds of distortion : frequency, phase and waveform

    信號的失真分為頻率失真、相位失真和波形失真等三種。
  8. Therefore a most important task is how to solve the problem of waveform distortion named signal integrality preservation in order to confirm the high speed in this test module

    為實現數字信號在片內、板內和板間的高速傳輸，必須解決這些畸變，這就是大家通常所說的信號完整性。
  9. This dissertation only considers the signal ’ s distortion by interconnect, such as delay, reflection, discontinuity of microstrip, crosstalk and simultaneous switching noise, and so on. nowadays, there are some simulation software in pcb level, but they are lack of the well ability of modeling. in order to simulate the interconnect accurately, we have to make use of three - dimension full wave analysis method, whose disadvantage is low speed in computing, but is competent for developing rules in high - speed designs

    目前也有一些針對這些噪聲的高速pcb板級模擬軟體，但它們都缺乏詳盡的建模能力，特別是當頻率逐漸提高和電路板日益復雜后，更是顯得無能為力，要精確地對互連結構進行分析，三維全波模擬器似乎不可缺少，其缺點就是速度慢，對整板模擬很難實現，但非常適用於規則開發，而這正好是本文除了建模與模擬方法研究外另一個重點。
  10. Under the research of the characteristic of three classical analog filter with simulation software - matlab, this paper devised lowpass circuit that not only can keep the useful signal out of distortion but also benefits the following sample tache and filter tache

    用matlab分析了三種經典模擬濾波器的濾波性能，設計出了能保持有用信號不失真又有利於後面的采樣和數字濾波環節的低通電路。
  11. Frequency response, quantization noise, reconstruction error and its sensitivity to mismatch among adcs are studied at length in prqmf banks adc system, and the theoretic results include : ( 1 ) the distortion / aliasing functions of hybrid filter banks adc system is similar with that of switch capacitor filter banks adc system ; ( 2 ) for wide or narrow band input signal, the effective resolution of the two adc systems is 0. 51og2m bits higher than their adc ; ( 3 ) reconstruction error ' s sensitivity to mismatch among adcs of the two adc systems is reduced effectively than time interleaved adc system

    2對prqmf濾波器組adc系統的頻響、量化噪聲特性、重建誤差特性以及重建誤差對adc間的失配敏感性進行了理論分析研究，所得到的理論結果為： （ 1 ）混合濾波器組adc系統與開關電容濾波器組adc系統的失真/混迭函數一致； （ 2 ）無論輸入寬帶還是窄帶信號，這兩種adc系統的有效解析度均比其adc提高了0 . 5log _ 2m比特； （ 3 ）這兩種adc系統的重建誤差對其adc間的失配敏感性均明顯低於時間交織adc系統。
  12. The reasons of the signal distortion are analyzed, and the relations of receiving bandwidth with distortion degree is discussed, for the more a steady point in the amplitude modulation signal is given by the method of the statistics. looking at the point as the timing reference point of the receiver, the stability of the receiver is less than 100us

    分析了接收信號失真和受干擾的原因所在，論述了接收帶寬和失真程度的關系，並在此基礎上，利用統計的方法在調幅信號的下降沿上找到了一個較為穩定的特徵點，將其作為接收機的定時參考點，定時不確定度可以達到數十微秒量級。
  13. Signal distortion and countermeasure in a pwm type audio power amplifier

    脈寬調制音頻功率放大器信號失真分析與對策
  14. ( 4 ) signal intergrity is discussed to avoid high speed signal distortion when designing the hardware

    （ 4 ）通過分析信號完整性理論，解決高速信號在pcb設計中的失真問題。
  15. This paper proposes a new adaptive noise canceller ( nanc ) with low signal distortion for speech enhancement after presenting an overview, in a unified perspective, for a number of the speech enhancement algorithms

    論文首先介紹了各種語音增強演算法。然後，重點提出了一種低信號失真的新的自適應噪聲抵消（ nanc ）語音增強演算法。
  16. Elements of electrical and optical connection - test methods - electrical elements - measurement of signal distortion of couplers

    電氣和光學連接元件.試驗方法.電氣元件.耦合器的信號失真測量
  17. Given the multicast request, the optimal object of the problem is to minimize total number of conversions required. in wavelength assignment, we should consider the requirements that the number of needed converters along the path from multicast source node to any member cannot be larger than specified value because of the signal distortion introduced by wavelength converters. at last, we present several dynamic programming to get the exact optimal wavelength assignment scheme under session blocking policy and destination blocking policy

    考慮到波長轉換器引入的信號失真和噪聲，引進了失真約束，即要求從組播源結點到每個組播成員的路徑上使用的波長轉換器數目均在指定的范圍之內;對于給定的組播需求，優化目標是在滿足失真約束的基礎上使整個組播樹上使用波長轉換器的數目最少;並使用動態規劃給出了sbp和dbp兩種連接建立策略下精確的最優波長分配演算法。
  18. Based on current max - rwa model, the extended max - rwa model is presented by introducing limited - range wavelength conversions. considering signal distortion introduced by wavelength conversions, we propose a new optimization objective, which is to establish the maximum number of connections with the least number of wavelength conversions

    ?在現有max - rwa模型的基礎上提出了波長轉換范圍受限條件下的擴展的max - rwa模型，在考慮了波長轉換器對信號傳輸造成的損傷的基礎上改進了優化目標，新的優化目標要求網路建立的連接數最大並使用盡可能少的波長轉換器。
  19. Aerospace series - elements of electrical and optical connection - test methods - part 702 : electrical elements - measurement of signal distortion of couplers

    航空航天系列.電氣及光學連接元件.試驗方法.第702部分:電氣元件.耦合器的信號失真的測量
  20. Aerospace series - elements of electrical and optical connection ; test methods - part 702 : electrical elements ; measurement of signal distortion of couplers ; german and english version en 2591 - 702 : 2001

    航空航天系列.光電連接件.試驗方法.第702部分:電氣元
分享友人
分享到 Line

分享到臉書