simulated signal 中文意思是什麼

simulated signal 解釋
模擬信號
  • simulated : 偽裝的,模仿的
  • signal : n 1 信號,暗號;信號器。2 動機,導火線 (for)。3 預兆,徵象。adj 1 暗號的,作信號用的。2 顯著的...
  1. Then following reality constituent of engine and connecting component interface, a nonlinear signal cylinder engine model has been created, though fire interval and fire order, a control - oriented four cylinders engine is build. following dynamometer is seen as load, performance of engine is simulated and researched under the condition of constant torque and speed, validation of the math and simulation model have been confirmed by comparison result between simulation with test result of engine performance simulation software dyno

    按照發動機的實際組成,根據各部件的介面類型連接模型庫中的部件,建立了單缸發動機非線性模型,在此基礎上,依據發動機實際發火間隔和順序,建立了面向控制的四缸汽油機模型,並以測功器為負載,通過恆轉矩和恆轉速方式進行了發動機性能模擬和研究,模擬結果和發動機動力性能模擬軟體dyno測試結果的對比驗證了數學模型和模擬模型的正確性。
  2. With the established rf front - end system simulation platform, adding the digital modulated baseband signal, this paper simulated the multifold digital modulated signal ’ s transmission, such as 2ask, qpsk, and 16qam. then researches of power compression and phase noise of local oscillation influence the bit error ratio for different modulated system. the designing is satisfied multifold functions request with the high - powered and integrated broadband rf front - end

    隨后在建立的寬帶射頻前端通用模擬平臺上,加入基帶數字調制信號,對多種數字調制格式的信號在該通用平臺上的傳輸作了研究,模擬了2ask 、 qpsk和16qam等調制格式信號的發射與接收,研究了功率壓縮和本振相位噪聲對不同調制的誤碼率影響,實現了滿足多種功能要求的寬帶高性能綜合射頻前端的設計。
  3. The three - order modulator has a 2 - 1 cascaded structure and 1 - bit quantizer at the end of each stage, the modulator is implemented with fully differential switched - capacitor circuits. and then, the discussion will begin by exploring the design of various circuit blocks in the modulator in more detail, i. e., ota, switched - capacitor integrator, quantizer, two - phase non - overlapping clock signal, etc., at the same time, these circuits will be simulated in spectre and hspice. at last, the whole cascaded modulator will do behavioral level simulation by matlab soft and simulink toolbox

    本論文中,首先介紹模數轉換器的各種參數的意義,以及一階sigma - delta調制器和高階sigma - delta調制器的原理;給出解決高階單環sigma - delta調制器不穩定性的方案,引入級聯結構調制器,特別針對級聯結構調制器中的失配和開關電容積分器的非理想特性進行詳細的討論;本設計的sigma - delta調制器採用2 - 1級聯結構和一位量化器,調制器採用全差分開關電容電路實現;同時對整個調制器的各個模塊進行了電路設計,包括跨導放大器、開關電容積分器、量化器、兩相非交疊時鐘等,並利用hspice和spectre模擬工具對這些電路進行模擬測試;最後,利用matlab軟體和simulink工具對整個級聯調制器進行行為級模擬。
  4. In order to combine the study of the ds - ss communication system ’ s availably jamming, the whole ds - ss communication system is modeled and simulated, including the modulation of the ds - ss signal, channel transmission, synchronal demodulation of signal and statistic of the bit error rate ( ber )

    為結合直擴通信系統的有效干擾研究工作,建立了直擴系統從信號的調制產生,通道傳輸、信號同步解擴解調和誤碼率統計的全過程模擬系統。
  5. The emphasis in this composition is windshear signal processing technology. some processing methods are introduced in detail, they are suppressing clutter, extracting windshear parameters, computing hazard factor and etc. the signal processing simulation is accomplished on computer, it includes simulating microburst echo signal, simulating ground clutter echo signal, filtering clutter, estimating wind speed and calculating hazard factor. from the simulated results, a dangerous windshear is detected 5o ~ 78s, so the radar performance meets the certification requirements proposed by faa and nasa

    本文重點研討了風切變信號處理技術,對雜波抑制技術、風切變特徵參數提取技術及危險因子計算方法等內容進行了深入的研究,並進行了計算機模擬,包括微下擊暴流回波信號模擬、地雜波回波信號模擬、雜波抑制、風速提取和危險因子計算。
  6. The signal format of gps is analyzed, the principle models and mathematical models are established, the ber performance is analyzed in a channel interfered with wide - bandwidth awgn, narrow - bandwidth awgn, transmitted signal, single - tone signal respectively. based on the results above interference methods are discussed and simulated. then the performance of code acquisition and code trace of a digital gps receiver are discussed. the modem of linkl 1 and link4a are modeled and their ber performances are analyzed and simulated in channel s interfered with awgn, single - tone signal and multi - tone signal respectively

    建立了jtids的收發終端的數學模型,分析它在噪聲干擾、相關干擾、互相關干擾下的誤碼性能,提出較佳的干擾方法和干擾碼型,並進行模擬模擬;分析了gps的信號格式,建立了gps的原理框圖模型、信號數學模型,並對其在寬帶噪聲干擾、窄帶噪聲干擾、轉發干擾、單頻干擾等情形下的誤碼性能進行了分析比較,提出相對較佳的干擾方法,並做了計算機模擬,針對一數字式gps接收機中擴頻碼捕獲與跟蹤環的特性進行分析;建立了link11和link4a數據鏈調制解調數學模型,對它們在噪聲干擾、單音干擾、多音干擾等下的誤碼性能進行分析,最後對干擾情況進行了模擬模擬。
  7. To the single pulse angle measuring, phase comparison and phase sum - difference angle measuring method are discussed and compared. sum - difference channel modeling and simulation are made. based on system research and signal processing discussed above, some basically jamming methods are discussed and simulated

    對于單脈沖測角方法,研究了相位比較法和相位和差單脈沖測角方法,對兩種方法進行了比較並給出了和差通道方向圖的模擬。
  8. And i had made simulation with matlab. the next part of my paper, i analyzed elements which affecting the signal in superhigh optical networks, and simulated the loss - managed network

    本文就100fs的孤子在nldc中傳輸控製做了研究,用一控制脈沖來控制信號孤子的傳輸方向,並用matlab做了模擬。
  9. Analyze the linear dipole array with uniform element spacing using the method of moments ( mom ), derive the analytical expression for the recovered signal with the direct data domain method, demonstrate the effect of the mutual coupling on the performance of the antenna array by examples, the degradation of the system caused by the mutual coupling is simulated and analyzed in two different electromagnetic environments such as the weak and strong interference

    用矩量法計算了幾個信號同時照射時對稱陣子均勻直線陣的電流分佈,用直接數據域演算法推導了此接收陣列的恢復期望信號的表達式,舉例說明了互耦對陣列天線性能的影響,數值模擬了在弱干擾和強干擾下,互耦造成系統性能下降的情況並分析了原因。
  10. Then, the connected flying, stage separation, signal being sheltered process is simulated in computer, the influences imposed by working conditions and interfering factors for separation process are analyzed. furthermore, if the missile is controlled non - rolling, the stage separation process is simulated in another model. some of conclusions derived from above analysis are checked in theory

    本文就某些可選分離方案進行了對比分析,對地空導彈一體飛行、級間分離、信號遮擋過程進行了計算機模擬,分析了影響條件和干擾因素對分離過程帶來的影響,進一步研究導彈若受控無滾時的級間分離過程,並從理論基礎出發驗證上述研究的部分結論。
  11. Second, research and analyze the feature of signal of pulse compression radar, and discuss the principle and characteristic of pulse compression technique, that are linear frequency modulation and phase coding. the above two mathematic model is constructed, and shift - frequency noise is imposed on the models, and anti - nose ability is evaluated and simulated

    通過對脈沖壓縮雷達的信號特徵的研究和分析,通過研究線性調頻和相位編碼脈沖壓縮技術的原理和特點,建立了這兩種雷達的數學模型,並對此進行移頻干擾和相位編碼雷達干擾,並進行干擾性能的評估和模擬研究。
  12. Finally, a tem antenna was simulated. the coupling of two antennas and the tail of the reflected signal of the antenna are reduced. furthermore, the antenna was tested with the gpr

    最後對tem加載喇叭天線進行了模擬,減小收發天線之間的耦合及信號拖尾,並在探地雷達上進行了實測。
  13. Moreover, the signal processing method of high range resolution based on inverse discrete fourier transform is analyzed. the synthetic high range resolution of the several scatters is simulated

    此外,本文還闡述了頻率步進信號的逆傅立葉變換合成距離高分辨的處理方法,並對多散射點目標的合成距離高分辨效果進行了計算機模擬。
  14. And still signal being sheltered model and deflection separation model when the missile is controlled non - rolling are built, separation process are digitally simulated to check the stability during it

    提出信號傳輸遮擋模型,建立受控無滾轉時的偏差分離模型,實現導彈分離過程數值模擬和穩定性分析。
  15. The optical channel models for airborne submarine laser communication are built. the multipath time spreading of signal pulse is studied. the waveform of received signals in receiver in submarine laser communication system is analyzed and simulated

    通過蒙特卡羅方法的模擬研究,建立了機載激光對潛通信的光脈沖傳輸模型,研究了信號光脈沖的時間擴展,分析並模擬了接收面上的接收波形。
  16. From the simulation result, the serial port updating module are working normally. the simulated signal of illegal attack is defended while the background monitoring works effectively

    通過測試結果,得出:機頂盒軟體串口升級運行正常;模擬對正常信號的非法攻擊得以屏蔽,后臺監控正常。
  17. Then the thesis analyzed noise ’ s influence on angle precise of simulated signal and gave some primary principles which should be followed in the system design

    進而分析噪聲對信號模擬角度精度的影響,提出了模擬器系統設計中應遵循的一些基本準則。
  18. Finally we measured the performance of the system, analyzed phase error ’ s influence on angle precision of simulated signal and gave the solution

    最後對模擬器系統的性能進行了測試,分析了系統中相位誤差對信號模擬角度精度的影響,並給出了解決辦法。
  19. Hardware controller uses the at89c51 monolithic integrated circuit, a / d transformation uses 12 bit transformations chips max187, has completed the design of a front channel for sampling and processing the simulated signal

    其中硬體單片機採用at89c51單片機, a / d轉換採用12位轉換晶元max187 ,完成了模擬信號從采樣到處理的整個前向通道設計。
  20. The simulated signal is taken into the system and analysed using the method aforementioned as an example. according to the analysis results, the conclusions for evaluating the quality of final drive can be drawn more rapidly and rationally

    主減速器振動信號分析方法可以替代現階段在生產線上,利用熟練工人用耳聽主減速器齒輪嚙合聲響來進行判斷的方法,大大提高主減速器質量評估的速度和科學性,具有較強的現實意義。
分享友人