sine method 中文意思是什麼

sine method 解釋
正弦法
  • sine : n 【數學】正弦〈略 sin〉。 sine curve 正弦曲線。 sine wave 正弦波。〈拉丁語〉 無。 sine die 無限...
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. In the circuit, using the way of step - by - step magnify, a normal sine wave signal through former circuit export for the next circuit, and this signal that have been magnified push the next step. the main magnify circuit use the method of high power dynatron that is parallel connection

    在迴路中採用逐級放大的方法，將一個標準的正弦波信號通過前級放大，輸出給后級，推動后級放大迴路，主要的功率放大迴路中採用大功率三極體並聯實現功率放大輸出。
  2. The generalized difference method to the sine - gordon equation

    方程的廣義差分法
  3. The identification results of step and sine steering angle input showed that the proposed identification method is not only practical, but also with high accuracy

    通過方向盤角階躍輸入和正弦輸入的識別結果表明，這種識別方向盤角輸入的方法是可行的，並且具有識別精度高、運算速度快等優點。
  4. Fourier analysis is the mathematical method used to break sounds down into sine waves

    傅里葉分析是將聲音分解為正弦波的數學方法。
  5. Abstract : bridge function and generalized bridge function are all three - valued function, and are made by initial sequence according as copied or shifted ways. they include some familiar orthogonal function of non - sine, such as walsh function. this paper briefly introduced some research advance on this subject, emphasized to introduce the copy theory and generalized copy method. the process of making ( generalized ) bridge function, its property and application, were introduced briefly

    文摘:橋函數和廣義橋函數均為三值函數系，都是將初始序列經復制方式和移位方式變換后而形成的.它們包括了一些常見的非正弦正交函數，如沃爾什函數和方波函數等.簡要介紹了近10年來北京航空航天大學通信與電子系統博士點在非正弦正交函數方面研究的一些新進展，重點介紹了復制理論和廣義復制方法，橋函數、廣義橋函數的復制生成方法、性質及其應用等專題
  6. We call above two mechanization algorithm as jacobian function expension method. the jacobian function expension method is an effective method than the sine - consine method and the sn - cn method

    稱之為雅可比橢圓函數擴展法，它是一種比sine - cosine方法和sn - cn函數法，雙曲函數法更有效和簡單的方法。
  7. Least square method based measurement of sine wave total harmonic distortion

    基於最小二乘法的正弦波諧波失真度測試
  8. 3 using current injecting frequency modulation method and modulating sine wave around the resonator point, the lock - in phenomena is observed in a comparatively short period of time. this has achieved the basic goal for a closed loop r - fog

    3 、採用電流注入法，在諧振點附近進行正弦調制，實現了對諧振點的短時間鎖定，達到了閉環光纖陀螺設計的首要基本要求。
  9. In this section, with time _ sharing method and the symmetry of sine wave, the look - up table needed to generate three - phase sine wave is reduced to one twelfth of the table before, and the optimization will have no any effect on precision, at the same time, the generation way of the monopolar spwm is improved

    在這一部分，還對產生二相正弦波的正弦表進行了優化，利用分時復用和正弦波的對稱性，把所需的正弦表減少為原來的1 / 12 ，並保持優化后的精度不變。同時改進了單極性spwm的產生方法。
  10. This paper put forward a method of using amending sine value in the spwm sine table. this method can correct the distortion of the output voltage waveform, which resulted from the dead time used to the voltage type whole bridge main circuit. the inverter system adopts digital fuzzy controller with feed forward correction and which proportion coefficient and integral coefficient is changeable, so dynamic response is improved

    本文提出了一種採用修補spwm正弦表值的方法，用以改善電壓型全橋逆變主電路因上下橋的功率器件切換時先關斷后導通的死區時間而引起的輸出電壓波形畸變；逆變系統採用帶前饋校正的變比例變積分系數的模糊控制器，提高了系統的動態響應指標；系統設計了完善的保護措施，並具有市電電網的故障診斷功能。
  11. The method to get the parameters for each basic waveform was given by choosing the sine window function waveform as the basic waveform, and based on the srs time - history synthesis principle

    依據沖擊響應譜時域合成的一般原則，選擇合成小波中的正弦窗波作為基本波形，給出了確定各基本波形的波形參數的方法。
  12. A novel sine - triangle modulation method based on equivalent circuit model for three - level pwm voltage source inverter

    基於等效電路模型的新型三電平逆變器載波調制方法的研究
  13. The paper gives two ways to solve the phase synchronization, which is a key technology to bistatic sar, namely direct synchronization and indirect synchronization. meanwhile, the paper also studies the affection of linear phase error, quadratic phase error and sine phase error which are engendered by the method mentioned of the paper upon imaging

    相位同步問題是雙站sar的一個關鍵技術問題，本文提出用直接同步法和間接同步法解決，並著重討論了兩種方法中可能出現的一次相位誤差、二次相位誤差、正弦相位誤差對成像的影響。
  14. Based on chaos critical state detection method, two approaches are used : one is that making a pretreatment on dsss signal to take out the period information of the signal. the other is that starting from the analysis of the sensitivity of duffing system to ambi - polar square wave modulated by sine signal, the

    通過兩種途徑:對信號進行預處理，提取出其中的周期信息，轉化為單頻信號檢測;從研究duffing振子對方波調制信號的敏感性出發，全面分析其中的間歇混沌現象，實現信噪比- 20db以下dsss信號的檢測。
  15. Using dsp of ti inc. - - - - - - - tms320f240 this thesis develops a general ac variable - speed system, and then carries out the research on various new control strategies for induction motor based on it. this paper explains sine pulse width modulation ( spwm ), space - vector pulse width modulation ( svpwm ), and new pulse width modulation method - hybrid space vector pulse width modulation ( hsvpwm ) aiming at a inherent problem of dead time in the common pulse width modulation

    本文闡述了正弦脈寬調制（ spwm ）控制技術；電壓空間矢量（ svpwm ）控制技術；以及針對常用脈寬調制方法中存在的一個固有問題? ?逆變器開關器件死區時間的影響，提出了一種新的脈寬調制方法：混合空間矢量脈寬調制控制技術。
  16. In this paper, the foundamental principles of fd _ bpm ( finite - difference beam propagation method ) used to simulate and calculate the process of beam propagation is first introduced. then ， the theory of boundary condition is carefully presented. based on those theories mentioned above, a new kind of fd _ bpm arithmetic is brought forward. compared with the traditional arithmetic, this one has much more advantages. in virtue of the new arithmetic, author accomplished the whole simulating designs with two kinds of optical splitter ( stright y - junction optical splitter and sine - type optical splitter ), including propagation field simulating, vital parameter calculating, acquired some optimized waveguide parameters ， and finished the template by those results at last

    本文主要藉助這種改進的fd _ bpm演算法，對兩種結構的光分路器（直y型光分路器，上升正弦型光分路器）進行了器件設計的軟體模擬，包括對兩種結構光分路器傳輸場進行模擬，並對兩種結構光分路器的重要參數，如波導寬度，分叉角，縱橫比，損耗進行了模擬計算；得到了一些有價值的優化波導結構參數值，根據這些優化值設計製作了光刻模板。
  17. We propose a chaos - based generation of the random ppm - ps signals, design and implement a generator of the ppm - ps signals. we introduce an if sampling technique and simulate the performances of digital demodulation techniques of using hilbert filters, sine filters, bessel filters and poly - phase filters. the poly - phase filtering method can achieve the higher mirror - frequency rejection ratio by using the low order filters

    介紹了中頻采樣技術，並對希爾伯特濾波法、辛格內插函數修正、貝賽爾函數插值法及多相濾波法等數字解調演算法進行了計算機模擬和性能比較，指出多相濾波法能以較低的階數實現較高的鏡頻抑制比。
  18. Variable frequency speed regulation system based on the voltage space - vector is researched in this paper, the principle of the voltage space - vector is presented, and the third part " s software strategy of voltage space - vector is analyzed, the method of the third part " s software of voltage space - vector is imitated with simulink. at the same time, the duty time and duty order of the two zero - vector are analyzed and showed that the voltage space - vector pwm is actually a modulated method by adding the harmonic to the sine wave

    本文對基於空間電壓矢量的變頻調速系統進行了研究，敘述了空間電壓矢量的原理，對ti公司第三方軟體的對稱空間電壓矢量的演算法進行了分析，並用simulink對該方法進行了模擬，對兩個零矢量的作用時間和作用順序進行了分析，指出空間電壓矢量pwm實質上是一種諧波注入的調制方法。
  19. And then swept - sine method is introduced. at last the comparison results are discussed. finally, the extended “ nose - to - nose ” calibration technology is introduced emphatically

    其次，介紹了掃頻源法;最後，介紹了兩種方法的比對結果。
  20. At last the reflection and its removing method are introduced. thirdly, the results of " nose - to - nose " calibration technology and swept - sine method are compared

    第三、介紹了「 nose - to - nose 」校準技術與掃頻源法的比對。
分享友人
分享到 Line

分享到臉書