size specification 中文意思是什麼

size specification 解釋
尺寸表
  • size : n 1 大小，尺寸規模身材。2 （鞋帽等的）尺碼，號；（紙張的）開。3 巨大，大量；相當大的分量。4 〈口...
  • specification : n. 1. 詳細說明，逐一登記，詳記。2. 〈pl. 〉規范，規格。3. 清單，明細單。4. 【法律】（申報新發明時的）設計說明書。5. 【法律】用來料加工製成新產品所取得的權利。
  1. Specification for eyepiece and screen graticules for the determination of the particle size of powders

    粉末粒度測定用目鏡和網格分度鏡規范
  2. 13a, ; rectangular connectors for frequencies below 3 mhz ; part 7 : detail specification for a range of connectors with polarized guides or jackscrews and size 16 round contacts ; removable crimp contact types with closed crimp barrels, rear insertion front release, with assessed quality

    頻率低於3mhz的矩形連接器.第7部分:一系列矩形連接器的詳細規范:具有評定標明極性式插孔，螺紋尺寸為16
  3. The size and specification can be customized to suit treatments oaf various types of wastewater and volume

    大小規格依據處理水質、水量進行設計製作，性能數據去除率可達
  4. Sensitive switches, single - break contacts, subminiature size, detail specification for

    超小型單斷接點組靈敏開關的詳細規范
  5. For confirming the results, a full - size model ( dj / dj = 0. 6, t / t = 1. 5 ) was analyzed by means of strain gauge test. the reliability of finite element analysis was proved because the results basically accorded with that of the test. secondly, in this paper, in order to carry out a fair assessment of the reinforcement design on spherical shell with transnormal nozzle, a comparison of reinforcement method was done between jb4732 - 1995 steel pressure vessels ? esign by analysis appendix a4 and hg20582 - 1998 specification for stress calculation of steel chemical vessels

    為了驗證ansys分析結果的可靠性，對其中一組參數下（開孔率0 . 6 、厚度比1 . 5 ）的模型容器，採用電測法進行了應力測試，並將得到的實驗結果與有限元結果進行了比較，二者在應力分佈狀況和大小上均基本吻合，證明此種結構運用ansys進行分析，其結果是完全可靠的。
  6. Standard specification for a size 10 x 4 - 5 smooth - tread friction test tire

    尺寸10 x 4 - 5平滑螺紋摩擦試驗輪胎的標準規范
  7. Lastest size specification

    最新的尺寸表
  8. The specification & type of explosion - proof will be also changed according to requirement of design institues and customers on the spot such as number of terminals and size of go - line port

    防爆接線箱的規格、型號也可根據設計院及用戶的現場要求進行改型確定。如端子數的多少、進出線口的大小等。
  9. Consumer safety specification for full - size and non - full - size baby crib corner post extensions

    全尺寸和非全尺寸的嬰兒床角柱延伸件的消費者安全規范
  10. Specification : metal ingot, mechanically polished, the detailed specification can be customized in size according to your request

    形狀：金屬錠，機械拋光，每塊大小可按您的要求。
  11. Specification high elastic average size suitable for everyone

    本品為高彈性均碼，適用於所有人群頭部尺寸
  12. 2. specification : offer the size according to the demanding party

    2 .規格：按需方提供尺寸
  13. Sensitive switches, single - break contacts, sub - subminiature size 7a, detail specification for

    超超小型7a單斷接點組靈敏開關的詳細規范
  14. Warning c6523 : invalid size specification : parameter

    警告c6523 ：大小規格無效:未找到參數
  15. Wheel label and ordering information : specification and size specification

    砂輪標示與訂購方法：規格與尺寸
  16. Warning c6525 : invalid size specification : property value may not be valid

    警告c6525 :大小規格無效:屬性值可能無效
  17. Warning c6522 : invalid size specification : expression must be of integral type

    警告c6522 ：大小規格無效:表達式必須為整型
  18. Warning c6521 : invalid size specification : operator can only be applied to pointer types

    警告c6521 ：大小規格無效: *運算符只能用於指針類型
  19. Warning c6526 - invalid size specification : expression must be of array or pointer type

    警告c6526 ：大小規格無效:表達式必須為數組類型或指針類型
  20. Size specification of the stop - check used on the boiler system is usually done by the architect or engineer, but it should be possible for the nibco salesman to assist the wholesaler or contractor in selecting the right valve if there is some doubt

    鍋爐系統所採用的截止止回閥的通徑選擇通常由建築師或工程師決定，但是如果批發商或建築承包商在選擇正確的閥門時有疑問，美國尼伯科銷售人員可能可以提供一些幫助。
分享友人
分享到 Line

分享到臉書