slag process 中文意思是什麼

slag process 解釋
造渣過程
  • slag : n. 1. 礦渣，鐵渣，爐渣，熔渣。2. 火山巖渣。vt. ,vi. （-gg-） （使）起溶渣；（使）成熔渣。 slag cement 【地質學；地理學】溶渣水泥。n. -gy
  • process : n 1 進行，經過；過程，歷程；作用。 2 處置，方法，步驟；加工處理，工藝程序，工序；製作法。3 【攝影...
  1. Separation of iron alum slag on zinc hydrometallurgy process

    濕法煉鋅中礬渣的分離
  2. Abstract : the alkaline digestion - granulating process for producing sodium stannate direct from waste tin slag is simple and less strict to equipment, and the direct tin recovery is more than 96 % and quality of sodium stannate product reaches standard issued by the ministry of commerce

    文摘:採用堿渣堿熔-水淬法用錫渣廢料直接生產錫酸鈉，流程簡單，對設備要求低，錫的直收率大於96 % ，錫酸鈉產品質量達到商業部標準。
  3. With the very low water to cement ratio, rpc has ultra - high strength high ductility and low permeability. in this paper, the compressive strength of rpc can reach to a high point with the number approximately 135mpa. as illustrated from the study results, we can approve some fundamental conclusions : there are big effects on rpc with deferent kinds and properties of raw materials and deferent curing conditions ; stress - strain curve shows the process of destroy with rpc samples ; x - ray diffraction analysis indicates that heat treatment at temperatures 90 accelerate the hydration of rpc sharply, therefore, mechanical and microstructural properties of rpc are highly dependent on heat treatment ; it is believed that rpc materials have excellent resistance to chloride permeability ; during the heat treatment, the shrinkage of rpc developed quickly because of chemical reactions ; the rpc with slag mostly has the advantage of rpc without slag about resistance to solutions corrosion

    研究結果表明：通過對rpc各組分摻量變化的研究，可以找到rpc的最優配合比；試件成型后的熱養護制度對rpc的性能影響巨大； rpc的抗壓應力?應變曲線可以反映出試件受破壞時微裂紋的擴展情況，剛纖維的摻入可以大幅改善rpc的韌性； rpc在成型后存在較大的收縮，而其中的化學收縮要遠遠大於乾燥收縮； rpc具有很強的抗氯離子滲透性能，漿體的密實度很高；通過x射線衍射實驗，可以發現rpc的膠凝體中ch晶體已經幾乎不存在，膠凝體主要由c - s - h凝膠和未水化水泥顆粒組成；在抗溶液侵蝕的實驗中，摻礦渣rpc的抗溶液侵蝕性能在絕大多數情況下要好於不摻礦渣試件，酸、堿溶液和浙江工業大學碩士學位論文摘要一些鹽溶液都會對rpc的結構產生侵蝕作用，但是機理各有不同。
  4. Research on the influence of the depth of slag pool on the depth of metallic bath using fem in the process of electroslag casting

    電渣熔鑄中渣池深度對金屬熔池深度影響的有限元模擬
  5. During the process, the follwing task must be done : ( 1 ) desulphur ( 2 ) temperature control ( 3 ) the fine adjust of chemic analysis ( 4 ) making the steel more clear ( 5 ) slag making in order to implement the following main function, the lf process computer system should be designed : ( 1 ) to dynamic plan lf process according to recived heat schedule

    Lf爐（ ladlefurnace ）即鋼包精煉爐，是鋼鐵生產中主要的爐外精煉設備。它的主要任務是：脫硫溫度調節精確的成分微調改善鋼水純凈度造渣在lf爐生產中建立過程式控制制計算機系統，主要用來解決以下問題：實時接收生產計劃，按照計劃動態組織生產。
  6. Abstract : based on the previous results of dephosphorization of stainless steel and new developments of eaf steelmaking process, dephosphorization technology of stainless steel is discussed. a weak oxidizing dephosphorization technology is proposed in which c ( carbon ) is added into slag to control furnace atmosphere and slag activity

    文摘:基於不銹鋼脫磷的有關研究結果及電弧爐煉鋼工藝的最新進展，對不銹鋼脫磷工藝進行了分析討論，提出了向渣中加碳控制氣氛及爐渣反應性能，從而實現弱氧化脫磷的工藝方案。
  7. Based on the previous results of dephosphorization of stainless steel and new developments of eaf steelmaking process, dephosphorization technology of stainless steel is discussed. a weak oxidizing dephosphorization technology is proposed in which c ( carbon ) is added into slag to control furnace atmosphere and slag activity

    基於不銹鋼脫磷的有關研究結果及電弧爐煉鋼工藝的最新進展，對不銹鋼脫磷工藝進行了分析討論，提出了向渣中加碳控制氣氛及爐渣反應性能，從而實現弱氧化脫磷的工藝方案。
  8. It is indicated that the hydration process of cement - based materials with slag, fly ash and silica fume is different in some degree from that of neat cement because of the difference in mineral structure and hydration mechanism. the periods of accelerating, decelerating and terminating are prolonged and hydration reaction decelerates. the second peak of rate curve of the heat evolution could be divided into two small peaks, which are contributed to the hydration of clinkers and mineral mixtures at the temperature of 30 but when temperature comes to 50, the two small peaks combine into one and the reaction accelerates

    結果表明，與硅酸鹽水泥相比，由於礦物摻合料與水泥熟料在活性和水化機理上的差異，水化歷程有較大的改變：多組分體系誘導期、加速期和衰減期延長，水化反應速率明顯降低；低溫時，水化放熱速率曲線上的第二放熱峰細化成分別對應于熟料和礦物摻合料水化的兩個小峰；高溫時，反應速率加快，雙峰合併；進一步研究發現，摻合料的種類與摻量對水化歷程也有較大的影響；建立了適用於多組分水泥基材料不同水化階段的水化動力學方程。
  9. Results show that basic parameter can determinate content of c3s in steel - making slag powder ; however, it can not determine cementitious property of steel - making slag. cementitous property of steel - making slag powder is determined by mineral composition calculated from chemical composition and treating process, which means intrinsic cementitous property of steel - making slag is determined by total content of active mineral composition, c2s, c3s, c4af and c3a, and content of ca ( oh ) 2 marking loss of active mineral

    研究結果表明，堿度僅能反映鋼渣中c _ 3s的含量，並不能完全反映鋼渣的膠凝性能；鋼渣的膠凝性能取決于由化學組成計算出的礦物組成及鋼渣的處理方式，即鋼渣中活性礦物c _ 2s 、 c _ 3s 、 c _ 4af及c _ 3a的總量及表徵活性損失礦物ca （ oh ） _ 2的量決定著鋼渣本身的膠凝性能。
  10. Effect of process factors on slag - splashing in converter

    工藝因素對轉爐濺渣護爐效果的影響
  11. The two - year practices at some plants have proved that using the sound - level detecting slagforming state contributes to not only the control and optimization of steelmaking process, but also the assessment of the effect of spattering slag during spattering lining protection

    兩年的工廠實踐證明，利用音平檢測爐渣狀態，不僅有助於煉鋼過程的監控和優化，而且有助於判斷濺渣護爐時的濺渣效果。
  12. The flow field of the molten slag pool in the electroslag casting process was simulated by the finite element analysis software ansys, the simulated result was in accordance with the physical simulation results very well

    採用大型通用有限元分析軟體ansys ，對電渣熔鑄體系渣池流場進行了模擬研究，所得結果與物理模擬實驗結果完全一致。
  13. With this model the eaf steel - making process can be simulated, including of scrap melting procedure, the changes of temperature, slag quantity and compositions of steel, slag and off - gas

    該模型可動態地模擬電弧爐冶煉過程中的廢鋼量、爐溫、渣量、鋼液成分、爐渣組成和爐氣成分的變化。
  14. The flow of the molten slag pool determines the temperature distribution and the pool profiles in the electroslag casting process, which finally impact on the quality of ingot casting

    摘要電渣熔鑄過程中熔渣的流動決定了熔鑄體系溫度場的分佈以及金屬熔池的形狀，最終影響熔鑄鋼錠的質量。
  15. The improvement technique of the single - slag manner smelting steel of arc furnace has been put forward, with details of discussion about suitable conditions and range of such technique and analysis of process characteristics and effect mechanism

    摘要提出了電弧爐單渣法煉鋼的改進工藝，針對單渣法熔煉的工藝內容，較為詳細地討論了其工藝適應條件和范圍；分析了藝流程特性和工藝行為的作用機理。
  16. Abstract : the separation of magnetic materials from converter vanadium - bearing slag in the process of pretreatment of it for hydrometallurgical vanadium recovery has been researched and moreover, the feasibility and optimization of magnetic separation and screen separation are discussed as well

    文摘:對攀鋼轉爐釩渣水法提釩預處理工藝中磁性物的去除進行了研究，並對磁選及篩選的原理、可行性、優化方案等進行了探索。
  17. Using electro - slag melting process of cast molten iron to produce ductile cast iron

    電渣精煉鑄造鐵水生產球墨鑄鐵
  18. Calculated results of activity factor show that activity of soudu steel - making slag powder is highest, activity of wuhan steel - making slag powder is higher and activity of shanghai steel - making slag powder is lowest because of its treating process

    活性因子計算結果表明，首鋼鋼渣粉活性最高，其次是武鋼鋼渣粉，上鋼鋼渣粉由於處理方式的原因活性相對較低；總體而言鋼渣粉的活性明顯高於一級粉煤灰。
  19. The single - slag steel melting method affected by the main process parameter of arc furnace

    電弧爐主要工藝參數對單渣法煉鋼的影響
  20. The intermediate magnesium - clad slag guard wire is produced through advanced process of non - cement pouring featuring corrosion resistance, high temperature resistance, good heating stability and long service life etc

    中間包鎂質檔渣堰採用無水泥澆注的先進工藝，具有耐侵蝕、耐高溫、熱震穩定性好、使用壽命長等特點。
分享友人
分享到 Line

分享到臉書