slag temperature 中文意思是什麼

slag temperature 解釋
渣溫
  • slag : n. 1. 礦渣，鐵渣，爐渣，熔渣。2. 火山巖渣。vt. ,vi. （-gg-） （使）起溶渣；（使）成熔渣。 slag cement 【地質學；地理學】溶渣水泥。n. -gy
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. It focuses on the theory of the mineral functional materials " improving the anti - chloride permeability and the chloride binding. the main achievements of this article include : 1 ) use the technology of xrd, sem, bet, laser particle size distributor etc to test the component, the construction, particle size distributor, specific surface etc of micro - silica, ultra - fined slag, high quality fly ash, meta - kaolin clay, four types of the mineral functional material, theoretically analysis the functions which the four mineral functional minerals act on cement concrete, namely pozzolanicity effect, filling effect, micro - aggregate effect, surface adsorption effect and so bring into play the affect of plastification, lowing of temperature, reinforcement, improvement of durability. base on this analysis we can conclude that the proper diameter of the mineral functional material is 5 m - 15 m, that is blain fineness 4500cm2 / g - 7500cm2 / g

    本論文的主要成果包括以下幾個方面： （ 1 ）採用xrd 、 sem 、 bet 、激光粒度分析儀等多種測試手段，探明了以硅灰，超細磨粒化高爐礦渣，優質粉煤灰及偏高嶺土超細粉等4種超細礦物功能材料的組成、結構、粒度分佈、比表面積等基本性質；從理論上分析了礦物功能材料在混凝土中的4種效應，即火山灰效應、填充密實效應、微集料效應、表面吸附效應，並由此發揮出增塑、溫峰削減（降熱） ，增強及耐久性改善等作用；通過相關理論分析，推導出礦物功能材料的合理粒徑范圍在5 m 15 m ，即勃氏比表面積為4500cm ~ 2 g 7500cm ~ 2 g 。
  2. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  3. Cold shots develop from low casting temperature, and dirt spots result from pickup of sand or slag by molten metal

    較低的鑄造溫度會形成冷疤，熔化金屬出現的沙粒或爐渣的累積會導致污點。
  4. Made of compound refractory with high purification and binder free from phosphor. used for slag line and weak section of eaf, strong adhesion, high binding strength at high temperature, erosion resistant, long service life

    採用高純合成材料和無磷結合劑生產的高性能噴補料，適用於各種電爐的渣線及熱點部位的噴補維護.具有附著率高，高溫結合強度好，抗沖刷性能優異，使用壽命長的優點
  5. In order to keep the normal bath temperature and slag forming condition, the charge of pig iron should not be exceeded 10 % on middle and small converter

    中小型轉爐內生鐵塊的加入量不應超過10 % ，使轉爐吹煉過程中保持正常的熔池升溫和成渣狀況。
  6. A device of measuring the crystallization temperature of mold slag based on single thermocouple wire was introdued

    筆者以保護渣結晶溫度為出發點，提出了一種將雙鉑銠熱電偶絲既作為加熱元件，又作測溫元件的熱絲法技術。
  7. But some problems are occurred, such as low bath temperature, difficulty in lime melting, slag overflow at vessel mouth, increase of metal consumption, difficulty in dephosphorization and low hitting rate at the final

    在生產中出現熔池溫度低、廢鋼和石灰不易熔化、爐口溢渣、金屬消耗增加、脫磷困難、終點命中率低等問題。
  8. During the process, the follwing task must be done : ( 1 ) desulphur ( 2 ) temperature control ( 3 ) the fine adjust of chemic analysis ( 4 ) making the steel more clear ( 5 ) slag making in order to implement the following main function, the lf process computer system should be designed : ( 1 ) to dynamic plan lf process according to recived heat schedule

    Lf爐（ ladlefurnace ）即鋼包精煉爐，是鋼鐵生產中主要的爐外精煉設備。它的主要任務是：脫硫溫度調節精確的成分微調改善鋼水純凈度造渣在lf爐生產中建立過程式控制制計算機系統，主要用來解決以下問題：實時接收生產計劃，按照計劃動態組織生產。
  9. It is indicated that the hydration process of cement - based materials with slag, fly ash and silica fume is different in some degree from that of neat cement because of the difference in mineral structure and hydration mechanism. the periods of accelerating, decelerating and terminating are prolonged and hydration reaction decelerates. the second peak of rate curve of the heat evolution could be divided into two small peaks, which are contributed to the hydration of clinkers and mineral mixtures at the temperature of 30 but when temperature comes to 50, the two small peaks combine into one and the reaction accelerates

    結果表明，與硅酸鹽水泥相比，由於礦物摻合料與水泥熟料在活性和水化機理上的差異，水化歷程有較大的改變：多組分體系誘導期、加速期和衰減期延長，水化反應速率明顯降低；低溫時，水化放熱速率曲線上的第二放熱峰細化成分別對應于熟料和礦物摻合料水化的兩個小峰；高溫時，反應速率加快，雙峰合併；進一步研究發現，摻合料的種類與摻量對水化歷程也有較大的影響；建立了適用於多組分水泥基材料不同水化階段的水化動力學方程。
  10. With this model the eaf steel - making process can be simulated, including of scrap melting procedure, the changes of temperature, slag quantity and compositions of steel, slag and off - gas

    該模型可動態地模擬電弧爐冶煉過程中的廢鋼量、爐溫、渣量、鋼液成分、爐渣組成和爐氣成分的變化。
  11. Water cement ratio and mixing fly ash or slag into concrete effect on ability of resisting chloride penetrating that are considered in the model. the effect of environment that include temperature, relative humidity and cumulating of surface chloride concentration of concrete are also considered. moreover, chloride diffusion changing with time is included in this model as well as

    模型中考慮水灰比和混凝土配合比（摻入不同量的粉煤灰和礦渣）變化對混凝土抵抗氯離子侵蝕能力的影響，同時考慮溫度、相對濕度和表面氯離子濃度累積變化等環境因素對氯離子侵入混凝土過程的影響，以及氯離子擴散系數隨時間的變化。
  12. The application of sulfuric acid slag in ceramic coating formed by self - propagating high temperature synthesis

    硫酸渣在自蔓延高溫合成陶瓷塗層中的應用
  13. The result of macro - quality experiments show : mineral admixtures markedly slow the hydrating velocity of cement slurry, decrease and delay the hydrating max - temperature, in which steel slag is more effective ; expansive agents compensate concrete shrinkage, enhance the concrete dense degree, strengthen the interfacial layer between fiber and cement matrix and improve the physical mechanics qualities of acic ; minimal admixtures markedly improve the concrete workability property, increase the concrete later intensity & density and the capability of anti - chemical attack and anti - permeability ; hybrid fiber reinforces the toughness of obviously acic by the means of anti - cracking effect of fiber with different sizes and different properties in the corresponding construction levels

    實驗結果顯示：鋼渣摻合料能顯著減緩水泥漿體水化速率，降低砂漿的水化溫升並延遲最高溫升時間；補償混凝土收縮，提高混凝土密實度，加強纖維與水泥石的界面粘結，增強混凝土力學性能，但不能明顯改善混凝土韌性。混雜纖維通過纖維的不同尺度與不同性質在相應的結構層次上產生阻裂效應，增韌鋼渣防滲抗裂混凝土；增加混凝土的破壞極限能，極大提高混凝土抗彎曲能力和韌性指數，改善混凝土脆性。
  14. Effect of nucleation temperature on properties of glass ceramics based on steel slag

    核化溫度對鋼渣玻璃陶瓷性能的影響
  15. Additions of carbon for improved slag resistance. spinel formation improves hot strength, slag resistance and brick joint erosion. 3 repairing material for bof uses fused magnesia or sintered magnesia as the main raw material and after modifid pitch and special additives are added, it has the following characteristcs than other conventional converter pitch temperature, shorter sintering time, longer service life and less pollution. it is mainly used for repairing converter working face, also for tapping side, tapping hole and bottom

    3 ，轉爐大面補料是採用電熔鎂砂或燒結鎂砂為主要原料，通過加入改性瀝青和特種添加劑使它和傳統瀝青補爐料相比具有高溫附著性好燒結時間短流動性好使用壽命長污染小等特點，主要用於修補轉爐迎鋼面通常稱「大面」也可以用於修補出鋼側，出鋼口及爐底等部位。
  16. Polycrystalline structure of waste slag in aluminum factory at different calcining temperature

    鋁廠污泥在不同煅燒溫度的晶相結構研究
  17. The flow of the molten slag pool determines the temperature distribution and the pool profiles in the electroslag casting process, which finally impact on the quality of ingot casting

    摘要電渣熔鑄過程中熔渣的流動決定了熔鑄體系溫度場的分佈以及金屬熔池的形狀，最終影響熔鑄鋼錠的質量。
  18. High temperature mud is for the construction of various shaped products. different refractory material should be used with different type of high temperature mud in order to get strong sticking, good slag resistance and small gap

    高溫泥漿適用於各種定型製品的砌築施工，不材質的耐火磚選用不同牌號的高溫泥漿配合使用，具有粘結強度高，抗渣性能好，灰縫間隙小等特點。
  19. High temperature mud is for the construction of various shaped products. different refractory material should be used with different type of high temperature mud in order to get strong sticking strength, good slag resistance and small gap

    高溫泥漿適用於各種定型製品的砌築施工，不同材質的耐火磚選用不同牌號的高溫泥漿配合使用，具有粘結強度高，抗渣性能好，灰縫間隙小等特點。
  20. Uniform micro - structure, compacted grain : melting iron is solidified by heavy spin force at right temperature, which effectively avoid the failures like blowhole, slag enclosure, pinholes and etc

    組織均勻，晶粒緻密：溫度精確的合金溶液在上百倍的離心重力作用下凝固成型，得到緻密的組織；並有效克服了氣孔、夾渣、疏鬆等缺陷。
分享友人
分享到 Line

分享到臉書