sliding friction 中文意思是什麼

sliding friction 解釋
滑動磨擦
  • sliding : adj. 滑動的；易變的，不穩定的。n. 滑動。
  • friction : n. 1. 摩擦，阻力。2. 傾軋，沖突，不和 （between）。3. 擦熱皮膚。
  1. Stabilities of dryly sliding friction behavior of ti3sic2 system materials

    2系材料干滑動摩擦的穩定性
  2. Dry sliding friction characteristics of vermicular graphite iron

    高速干滑動下材料摩擦學性能的研究進展
  3. The control of lateral - torsional coupled seismic response of structures is discussed. the analysis on unilateral, bilateral and lateral - torsional coupled seismic response of base - isolated structures with sliding friction bearings is carried out. the influence on lateral - torsional coupled seismic response of base - isolated structures due to the excentricity and the uncoupled period ratio of the superstructure is investigated, and the control of lateral - torsional coupled seismic response of structures is discussed

    對摩擦滑動支座基礎隔震結構進行了單向及雙向地震反應對比分析，研究了結構平?扭耦聯地震反應，分析上部結構的偏心距及非耦聯周期比對結構的平?扭耦聯地震反應的影響，探討了對結構平?扭耦聯地震反應的控制。
  4. And also, the wear resistance at ambient temperature and of za27 alloyed with mn when lightly loaded is desirable but becomes worse at high temperature. the wear mechanism of the one mixed with both adhesive and abrasive wear under sliding friction conditions ( at high temperature )

    Si的加入量為1 - 3時， za27合金的磨損量最少，高溫摩擦性能最好；加入mn后， za27合金在低溫輕載下耐磨性能較好，高溫耐磨性能不理想；在滑動摩擦條件下（高溫）的磨損以粘著磨損和磨料磨損兩種方式共同存在。
  5. But when heavyly loaded, the former is far better than the latter. the wear resistance of za27 alloyed with mn is no obviously better than that of common za27 alloy. under the sliding friction conditions, the wear resistance at high temperature of za27 is improved by alloyed si and reaches the highest level when the content of si is 1 - 3wt. %

    裂紋主要始於脆性相si相和mn相，裂紋沿晶界擴展；在滑動摩擦條件下（常溫） ，含si的za27合金在載重較小時，耐磨性與普通za合金相比沒有明顯提高，但在載荷較大的情況下，其耐磨性遠高於普通za27合金材料；加mn的za27合金與常規za27合金相比，耐磨性沒有明顯提高；在滑動摩擦條件下， si的加入提高了za27合金的高溫摩擦性能。
  6. Study on response computation of a vibration system with variable coefficient of sliding friction using equivalent linearization technique

    非恆定滑動摩擦系數振動系統等效線性化計算方法研究
  7. Wearing characteristic of ti6al4v in high dry sliding friction

    高速干滑動摩擦磨損特性研究
  8. Sliding friction is independent of the area of surface in contact

    滑動摩擦力于表面接觸的面積無關。
  9. Dry sliding friction wear of cast iron

    鑄鐵的干滑動摩擦磨損
  10. If we halve the mass carried, sliding friction is also halved

    如果我們將質量減半，滑動摩擦力也會減半。
  11. Sliding friction coefficient of granular and powder mixture in inclined tube

    顆粒和粉體混合物沿斜滑道的滑動摩擦系數
  12. In order to develop and consummate the analysis theory and calculation method of base - isolated structures, based on the research on restoring force model of isolation systems and the analysis on the nonlinear seismic response of base - isolated structures, the analysis on multi - dimensional and lateral - torsional coupled seismic response of base - isolated structures is developed in this paper. according to the mechanical performance of isolation systems, detailed analysis and improvement of the present research, an unilateral and a bilateral coupled visco - elastic hysteretic model for rubber bearings, an unilateral and a bilateral coupled visco - elasto - plastic differential hysteretic model for lead rubber bearings, an unilateral and a bilateral coupled modified visco - plastic differential hysteretic model for sliding friction bearings are proposed

    為進一步發展和完善基礎隔震結構分析理論和計算方法，本文以隔震系統恢復力模型研究及基礎隔震結構非線性地震反應分析為基礎，對基礎隔震結構的多維地震反應及平?扭耦聯地震反應開展了以下幾方面的研究工作：根據隔震系統力學性能的特點，在現有研究成果的基礎上，對隔震系統恢復力計算模型進行了改進和創新，提出了普通疊層橡膠支座單向及雙向耦合粘彈性恢復力計算模型，鉛芯疊層橡膠支座單向及雙向耦合粘彈塑性微分型恢復力計算模型，摩擦滑動支座單向及雙向耦合修正粘塑性微分型恢復力計算模型。
  13. The substitution of rolling friction for sliding friction results in a very considerable reduction in friction

    用滾動摩擦代替滑動摩擦，結果使摩擦大大減少。
  14. The right undersdanding of sliding friction force and static friction force is stressed by an explaination about a typical topic

    摘要通過對一道典型題的解答，強調對滑動摩擦力和靜摩擦力的正確理解。
  15. The value of sliding friction depends on nature of the two surfaces which touch each other

    華東摩擦力的大小取決于兩接觸面的自然屬性。
  16. Microstructure of the composite layer was analyzed with help of optical microscope, scanning electronic microscope ( sem ), electronic probe microanalysis ( epma ) and x - ray diffraction ( xrd ). the compacting of the billet and the forming mechanism of the carbide reinforcement were studied based on thermodynamics and kinetics of reaction, sintering theory and the result of dta. at the same time, the wear - resistance of the composite layer was studied under condition of dry sliding friction

    利用光學顯微鏡、掃描電子顯微鏡、電子探針以及x -射線衍射儀，分析了表面復合層的基體組織結構；運用反應熱力學、動力學、粉末燒結理論和燃燒合成理論，結合差熱分析結果，探討了表面復合層壓坯的燒結緻密化原理和碳化物增強相的形成機理；利用坯塊在真空燒結爐不同溫度下的燒結出來的顯微組織分析，模擬出坯塊的燒結過程中的化學反應過程。
  17. In actual engineering applications, its wear resistance reduces due to the high temperature resulted from the continuous and heavy load service, which cannot fit the demand of engineering applications. based on the recent research throughout the world, in order to improve mechanical properties and wear resistance at high temperature of za27 alloy, si and mn are added to modify its microstructure. its microstructure and mechanical properties are tested and the sliding friction at ambient temperature and sliding friction at high temperature of znalsi and znaimn are studied

    本文研究了za系合金中應用最廣泛的za27合金，針對企業在工業應用過程中發現za27在中低速重載連續工作時，因溫升造成耐磨性下降，難以滿足工況要求的實際情況，為進一步提高其力學性能和高溫耐磨性，結合國內外研究現狀，在za27合金基礎上，添加si 、 mn合金元素調整合金的組織，通過顯微組織分析和常溫機械性能測試，以探索znalsi及znalmn合金常溫及高溫滑動摩擦條件下的摩擦特性。
  18. If we do so we find that sliding friction between the surfaces in also doubled

    如果我們這樣做了，會發現兩接觸面間的滑動摩擦力也加倍了。
  19. This shows that sliding friction is proportional to the reaction between the surface in contact

    這說明滑動摩擦力與接觸表面的作用力成正比。
  20. The force which must be overcome to keep one surface moving over another in known as sliding friction

    而保證一個平面沿著另一個平面相對移動的力稱為滑動摩擦力。
分享友人
分享到 Line

分享到臉書