sliding ratio 中文意思是什麼
sliding ratio
解釋
滑動率-
For sliding contact, the coefficient of kinetic friction uk is defined as the ratio of the frictional force to the normal force.
滑動接觸時，動摩擦系數Uk的定義是摩擦力與法向力的比率。 -
For sliding contact, the coefficient of kinetic friction uk is defined as the ratio of the frictional force to the normal force
滑動接觸時，動摩擦系數uk的定義是摩擦力與法向力的比率。 -
4. axial compressive ratio is advantageous to seismic behavior of staggered joints. it can improve joints first crashing loads, shear resistance capacity and reduce the sliding displacement of beam bars
軸壓比對節點的抗震性能有利，它可以提高節點的初裂荷載、抗剪承載力、減小節點中梁筋的粘結滑移量。 -
The control of lateral - torsional coupled seismic response of structures is discussed. the analysis on unilateral, bilateral and lateral - torsional coupled seismic response of base - isolated structures with sliding friction bearings is carried out. the influence on lateral - torsional coupled seismic response of base - isolated structures due to the excentricity and the uncoupled period ratio of the superstructure is investigated, and the control of lateral - torsional coupled seismic response of structures is discussed
對摩擦滑動支座基礎隔震結構進行了單向及雙向地震反應對比分析，研究了結構平?扭耦聯地震反應，分析上部結構的偏心距及非耦聯周期比對結構的平?扭耦聯地震反應的影響，探討了對結構平?扭耦聯地震反應的控制。 -
By solving the nonlinear schrodinger equation with perturbation method and computer simulations, we have demonstrated that super - gaussian sliding - frequency filters are more effective to reduce timing jitter than conventional sliding - frequency filters without sacrificing the signal - to - noise ratio
通過求解非線性薛定諤方程和數值模擬，我們認為超高斯滑頻濾波器能很好地控制孤子的時間抖動和相互作用。 -
By means of building modelling with the target angular displacement and its sliding model variable structure controller of transmission ratio control electromotor, the parameters of entire controller are defined
通過對速比控制電機目標角位移、角位移滑模變結構控制器的建模，來確定整個控制器的設計參數。 -
To guarantee the stability of the frame in strong earthquake motion, and on the basis of analysis on the concept of “ capacity design ” in the above three countries seismic design provisions, it is advised that the moment amplification coefficients at the bottom sections of columns for the frame structures in some seismic intensity be increased to reduce the possibility of the frame column yielding. taking the above three countries seismic codes as reference, it is recommended that it be added details of seismic design by using diagonal shear reinforcement to safeguard beams against sliding shear failure, when the positive - negative shear forces are reverse and the ratio is high
為了保證在大震作用下框架結構的穩定性，借鑒國外規范「柱-梁承載力級差系數」的思想，本文提出了對部分抗震等級的框架結構的柱端抗彎能力增強系數應予以提高，以降低框架柱屈服的可能性;參照國外有關規范的發展，本文建議對于正、負剪力反向且比值較大的框架梁宜增加交叉斜筋，以防止沿垂直裂縫發生嚴重的剪切錯動。 -
It is found that cyclic loading at high differential stress level will lead to the decrease of felicity ratio, and the value max can be decreased by some crack systems in specimen. there is still a lot of ae during unloading at high differential stress level, which implies that the deformation is dominated by fracturing at low differential stress level, and the deformation by frictional sliding increases greatly at high differential stress level
關于應力方式對巖石破裂的影響，發現較高差應力水平下的多次循環加卸載會使felicity比減小；某些構造能使巖石產生felicity效應的應力門檻值_ （ max ）降低；由高差應力水平下卸載時仍有大量聲發射產生推測：在低差應力水平下，破裂以裂紋尖端的突然擴展為主；在高差應力水平下，沿已有的裂紋面的滑動破裂大量增加。
分享友人