slope signal 中文意思是什麼
slope signal
解釋
斜率信號-
The synchronous rectifying and low power sampling technology is used to reduce the power consumption, flexible external loop compensation, error amplifier output clamp are adopted for better system large signal response. the piecewise slope compensation technology is employed to minimize the consequence of over compensation. the sensor resistor is externally connected, which realize output voltage programmable. the overheat protection and under voltage protection modules are integrated in the die to allow the reliable operation of the system
同時，電路設計採用同步整流技術、低功耗電流采樣技術降低功耗，提高轉換效率;採用靈活的外部環路補償技術、誤差放大器輸出嵌位技術以實現良好大信號特性;採用分段斜坡補償技術，消除不穩定因素，並最大程度地減小過補償帶來的問題;採用外接輸出采樣電阻的方式，實現輸出電壓的可編程。 -
The paper on the basis of the study on the control of the changing slope curve paving in theory, through the study on the responses of the screed to different input signal in condition of the erected string, the controller of the transverse gradient and the floating beam on the spot experimentations, and through the analyzes the three paving design method in theory and the experimentation, on through the analyzes the three paying design method in theory and the experimentation data, provides some material solving measures to solve the changing slope curve paving
摘要根據彎道變坡攤鋪控制特性的理論研究，在工程實際中採用掛線法、橫坡控制器和浮動均衡梁進行了不同輸入激勵函數下熨平板響應的試驗研究，並通過對這3種攤鋪設計方法的理論和試驗數據的分析，提出了解決彎道變坡攤鋪的具體措施。 -
The readout of a dvd rom disk and of a bd rom disk is simulated. the dependence of the readout data signal of a blue - ray rom disk on the geometry of its information layer ( the slope angle of the pits, in particular ) is analyzed
利用這種混合方法，對dvdrom光盤、藍光rom光盤的光學信號讀取過程進行了模擬，並研究了光盤信息層幾何結構參數（主要是信息坑的坑角）對讀出光信號的影響。 -
In this paper, some investigation and design as following. have been carried out on er - yb codoped phosphate glass waveguide laser first, three primary performance parameters of er - yb waveguide laser pump threshold power ; output power and slope efficiency have been commulated and analysed theoretically based on er ~ ( 3 + ) - yb ~ ( 3 + ) energy configuration ; rate equation of stable state and transmitting equation. the influences of er - yb ions concentration ; enabled waveguide length ; light dot radius of signal light and pump light ; reflectivity of output lens on three above parameters have been researched
首先，從er ~ （ 3 + ） - yb ~ （ 3 + ）能級結構出發，結合激光穩態速率方程與傳輸方程，對鉺鐿波導激光器的三個主要性能參數:閾值功率、輸出功率、斜率效率作了理論計算分析，並研究了鉺、鐿離子濃度、光波導激活長度、信號光與泵浦光光斑半徑比例、輸出耦合鏡反射率對這三個關鍵性能參數的影響。 -
Based on the theory of mfl and a study on the signal characteristics ofac - mfl and ect : on one hand, it expouded the flaw identification model of “ slope ratio ” todetect the defects in panel, rob or pipeline ; on the other hand, the flaw - depth measurementmethod based on the characteristical frequency were used in ac - mfl. the application ofac - mfl was realized, and it showed the accordance of defect detection for these twotechniques
從其檢測原理出發，在與上述渦流檢測信號特點進行比較的基礎上，一方面，利用「斜率比值」識別模型實現了對板材、管材、棒材等表面缺陷的檢測;另一方面，利用交流信號的信息實現了基於拐點頻率的深度測量方法在該技術中的應用。 -
In the time - domain, based on the principle of random sampling of dso. two way ( " time amplifing in dual slope integral " and " time - voltage convert " ) are implemented to measure the time between the system triger and writing clock. thus random sampling interpolate can be done to measure repeated signal in high frequency with the a / d convert and controller which frequency are lower
在時域，根據數字示波器隨機取樣原理，用兩種方法（雙斜率積分時間放大測量方法和時間? ?電壓轉換測量方法）測量數字示波器系統觸發和采樣寫時鐘間時間間隔，用低速a / d轉換器及控制器進行模?數轉換和控制，以此進行隨機取樣內插，從而實現了對高頻率重復信號的測量。 -
We made an improvement in overcoming the defects in speech signal adaptive delta modulation ( abbr. adm ), such as slope overloading and grain noise. in this method, numerical sliding average filtering was used for filtering decoding speech signal. experiments and analyses indicate that the method makes waveforms in good agreement between the decoding of adm and the original pulse coding modulation ( abbr. pcm ) signal, and considerably improves, the playback speech quality in naturalness, legibility and under standability
針對語音信號自適應增量調制（ adm ）方式中斜率過載和顆粒噪聲缺點，提出了一種改進方法，它利用滑動平均方法對解碼后的信號進行數字濾波.試驗和分析表明，該方法使解碼后的信號波形與原脈沖編碼調制（ pcm ）波形具有很好的一致性，使再生語音質量在自然度、清晰度和可懂度方面比改進前均有較大提高 -
First, we classify the multipath mitigation techniques into four categories, and then the presentation of principles and simulation of performances are done of three widely - used techniques of multipath mitigation, which are based on the code tracking loop with the name of narrow - correlator - spacing technique 、 els ( early late slope ) technique and medll technique. from the presentation and simulation, the medll technique is selected as the multipath mitigation algorithm in signal processing ’ s scope.
本章首先對多徑消除技術進行了分類，然後主要對基於碼跟蹤環路的三種技術-窄相關（ narrowcorrelatorspacing ）技術、 els （ earlylateslope ）技術和medll （ multipathestimatingdelaylockloop ）技術-進行原理分析和性能模擬，從中選擇medll技術作為接收機信號處理階段的多徑消除演算法。 -
Moreover, the components of the radial acceleration are theoretically derived, and the processing methods such as the signal sampling, the dynamic marking and storing, the noise removing, the slope comparison and the onset detection of braking operation are described
文中對加速度傳感器信號的組成進行了理論推導，並闡述了傳感器信號的采樣、動態標注和存儲、平滑去噪、斜率比較以及制動起始時刻判定等的處理方法。 -
The slope signal analyses and sinusoidal signal analyses show that the dnl 1 / 2lsb, at 49. 902 mhz input frequency and 100mhz sampling frequency, sfdr is 75. 5db and the or output can detect correctly whether the input signal is overflow and the system has good linearity
輸入頻率為49 . 902mhz的滿幅（ 500mv ）正弦信號，測得adc的無雜散動態范圍（ sfdr ）為75 . 5db ，系統的具有良好的線性度。 -
Then on one hand, author makes researches of anti - jamming against pulse jamming 、 gauss white noise jamming and radio frequency noise jamming from the side of signal processing. author exercises much signal processing knowledge of time - domain sliding window accumulation 、 wavelet analysis 、 time - frequency analysis and linear prediction and carries out many simulation experiments. on the other hand, author proposes the anti - jamming methods of using a sar similar to double - base radar and modulating the amplitude 、 the phase of emission signal and changing the frequency modulation slope from the side of changing sar system model
作者首先提出了合成孔徑雷達抗干擾的定義、分類以及評價抗干擾方法好壞的主客觀標準；然後，一方面從信號處理的角度出發對脈沖式干擾、高斯白噪聲干擾以及射頻噪聲干擾進行了抗干擾研究，其中運用了時域滑動窗口積累，小波分析，時頻分析以及線性預測等信號處理知識，做了大量的模擬實驗；另一方面，本文基於改變合成孔徑雷達系統模式提出了利用類似雙基地雷達來抗干擾，以及對發射信號進行調幅、調相以及改變調頻斜率來抗干擾，同樣做了相應的模擬實驗。 -
For the cell working range ascertainment, the algorithm determines the maximum output load, the minimum output load, the maximum input signal slope and the minimum input signal slope ; for the cell working surface representation, the algorithm inserts the characterization points dynamically. the table optimization algorithm for redundantly characterized points is proposed. its result table can represent the whole parameter surface accurately and concisely
通過計算單元在各測試狀態下的最大、最小輸出負載，輸入信號的最大、最小斜率，演算法能精確計算單元的工作曲面范圍；通過參數測試點的動態插入，演算法能獲得最佳的參數測試點，最大程度地表徵整個參數曲面空間。 -
The basic principle, system structure is analyzed and studied intently. the small - signal models for the switching converters based on current mode control are deducted. system stability and the principle of slope compensation which is used to improve system stability also discussed
本文首先設計了一款基於電流控制模式的pwm升壓控制晶元，並重點分析了它的工作原理、系統結構，建立了系統的小信號模型，分析了系統的穩定性以及採用斜率補償方法改善系統穩定性的原理，並模擬驗證了斜率補償的作用。
分享友人