snapline 中文意思是什麼

snapline 解釋
彈線
  1. Controls and move it close to the other, until they are almost touching. note the snapline that appears between them

    控制項，將其朝靠近另一個控制項的方向移動，使兩個控制項幾乎相互接觸。
  2. Specifies the relative importance of the snapline

    指定對線的相對重要性。
  3. Specifies the relative importance of a snapline

    指定對線的相對重要性。
  4. Gets a value indicating the relative importance of the snapline

    獲取指示對線的相對重要性的值。
  5. Specifies the orientation and relative location of a snapline

    指定對線的方向和相對位置。
  6. A horizontal snapline typically aligned to the top edge of a control

    通常與控制項的上邊緣對的水平對線。
  7. Note the snapline that appears at the text baseline of both buttons, and note that the control you are moving snaps to a position that is exactly level with the other control

    請留意出現在兩個按鈕的文本基線處的對線，您會發現所移動的控制項會貼合到與另一個控制項完全平的位置。
  8. The snapline defining the sum of the margin values is longer and that the control snaps to a greater distance from the other control. change the

    定義邊距值之和的對線變長，該控制項對時與另一控制項之間的距離變大。
  9. Control until a snapline appears. move the

    控制項右邊框的方向移動，直到出現對線。
  10. Note that a snapline appears to indicate alignment

    此時會出現一條對線來指示對位置。
  11. Will allow snapline alignment during a drag operation

    是否允許按對線對。
  12. That represents the priority category of a snapline

    表示對線優先級類別的
  13. A vertical snapline typically aligned to the left edge of a control

    通常與控制項的左邊緣對的垂直對線。
  14. A horizontal snapline typically aligned to the bottom edge of a control

    通常與控制項的下邊緣對的水平對線。
  15. Gets the programmer - defined filter category associated with this snapline

    獲取與此對線關聯的由程序員定義的篩選器類別。
  16. A vertical snapline typically not associated with an edge of a control

    通常不與控制項的邊緣關聯的垂直對線。
  17. A horizontal snapline typically not associated with an edge of a control

    通常不與控制項的邊緣關聯的水平對線。
  18. A single offset can describe the position of a snapline, because vertical snaplines may have only a nonzero x - axis offset, whereas horizontal snaplines may only have a nonzero y - axis offset. the offset

    單個偏移量可以描述對線的位置，因為垂直對線可以只有一個非零的x軸偏移量，而水平對線可以只有一個非零的y軸偏移量。
  19. Class and related types help support the snapline mode

    類及其相關類型幫助支持「對線」模式。
分享友人
分享到 Line

分享到臉書