softening point 中文意思是什麼

softening point 解釋
軟化點（玻璃的）
  • softening : 變軟
  • point : n 1 尖頭，尖端；尖頭器具；〈美國〉筆尖；接種針，雕刻針，編織針；小岬，小地角；【拳擊】下巴。2 【...
  1. The lower limit of temperature at which this occurs is known as the softening point or critical temperature.

    呈現這一性質的溫度下限稱為軟化點或臨界溫度。
  2. Testing methods for softening point of epoxide resins

    環氧樹脂軟化點的測試方法
  3. Littleton glass. determination of softening point. littleton point

    玻璃.軟化點的測定
  4. Standard test methods for softening point of resins derived from naval stores by ring - and - ball apparatus

    用環球儀測定從松脂製品中取得的樹脂的軟化點的標準試驗方法
  5. 4 the road asphalt was modified with powder sbr and betonite which reserves abundantly and cheap and organic betonite which was industrialization production firstly. the result show : softening point distinctly increased and penetration decreased

    4 、首次用富產價廉的膨潤土和已經工業化生產的有機膨潤土分別復配粉末sbr對道路瀝青進行改性。
  6. Test method of softening point for rubber antiagers and vulcanizing accelerators

    橡膠防老劑硫化促進劑軟化點的測定方法
  7. Adhesives - determination of the softening point of thermoplastic adhesives ring and ball

    粘合劑.熱塑性粘合劑軟化點的測定
  8. 2 softening point under load 1450

    1耐壓強度2荷重軟化溫度
  9. Note 1 : the technical indexes for 1 # of production we submit confirmatory data are softening point, distillation range and moisture, the other items are only for reference

    注1 ：技術指標軟化點、餾程、水分為1 #產品保證指標，其它項目為參考指標。
  10. The research results show that aggregate gradation and the nominal maximum aggregate size evidently influence the shear resistance of asphalt mixture ; aggregate flakiness content influences the shear resistance of asphalt mixture, and with the increase of aggregate flakiness content the shear resistance of asphalt mixture decreases ; asphalt binder properties, especially penetration, softening point and viscosity influence the shear resistance of asphalt mixture, and the latter increases with the decrease of penetration and the increase of softening point and viscosity ; asphalt content influences shear resistance of asphalt mixture, and with the increase of binder / aggregate ratio the shear resistance of asphalt mixture decreases ; air void influences shear resistance of asphalt mixture, and usually with the increase of air void the shear resistance of asphalt mixture decreases ; homogeneity does not have a direct and obvious relationship with absolute value of shear resistance of asphalt mixture, but does with variation of shear resistance of asphalt mixture

    研究結果表明：集料級配和公稱最大集料粒徑對瀝青混合料抗剪強度有顯著的影響；瀝青混合料抗剪強度受其集料中針片狀含量的影響較大，集料中針片狀含量增大，瀝青混合料抗剪強度減小；結合料的性質，特別是針入度、軟化點和粘度對瀝青混合料抗剪強度有較大的影響，隨著針入度減小，軟化點和粘度增大，瀝青混合料抗剪強度增大；含油量對瀝青混合料抗剪強度有較大影響，隨著油石比的增大，瀝青混合料抗剪強度減小；瀝青混合料抗剪強度受其空隙率的影響較大，一般隨著空隙率的增大，其抗剪強度減小；瀝青混合料均勻性與瀝青混合料抗剪強度絕對數值間沒有明顯的關聯，而與數值間的變異性有著很好的相關性。
  11. Testing of carbon materials ; determination of the mettler softening point ; binding and impregnating materials

    炭素材料試驗. mettler軟化點的測定.粘接材料和浸漬材
  12. Testing methods for paint components - part 2 : component analysis in solvent soluble matter - section 2 : softening point ring and ball method

    塗料成份的試驗方法.第2部分:溶劑溶解物質的成份分析.第21節:軟化點
  13. Standard test method for softening point of hydrocarbon resins by automated ring and ball apparatus

    用自動環球儀測定烴類樹脂軟化點的標準試驗方法
  14. Methods of sampling and test for carbonaceous materials used in aluminium manufacture - electrode pitch - determination of softening point ring and ball method

    制鋁工業用炭素材料取樣與試驗方法.第1部分:電極硬柏油脂.第3節:軟化點測定
  15. Test method for softening point of certain alkali - soluble resins

    某些堿溶性樹脂軟化點的試驗方法
  16. Carbonaceous materials for the production of aluminium. pitch for electrodes. determination of softening point by the ring - ball method

    鋁生產用碳質材料.電極用瀝青.用環球法測定軟化點
  17. Guided by luo yang refractory research in - stitute, we developed alumina - magnesia spinel car - bon bricks. this product possesses such anvantages as high load softening point, low porosity, slag - resis - tance and erosion - resistance, when used in the working linings of lable, its effect is evidently raised, so it is very popular inmetallurgicol enterprises

    我廠在洛陽耐火材料研究院指導下，研製出鋁鎂尖晶石碳磚，具有荷重軟化點高，氣孔率低，抗渣，抗浸蝕性能好等優點，用於鋼包工作襯，效果明顯提高，是目前鋼包用較為理想的產品，深受冶金企業歡迎。
  18. Flat tempered safety glass is kind of high - strength safety glass obtained by heating common glass to softening point and then air cooling it abruptly

    水平鋼化安全玻璃是將普通玻璃加熱至軟化點時，然後急劇風冷所獲得的一種高強度安全玻璃。
  19. Test method for softening point of pitch cube - in - air method

    硬瀝青軟化點的試驗方法
  20. Study on test methods of softening point of asphalt

    瀝青軟化點測試方法的研究
分享友人
分享到 Line

分享到臉書