solid flow 中文意思是什麼
solid flow
解釋
固態流-
The common character is to change the solid interspace shape of surface soil to build the rainwater converge section ( afflux section ) and crop planting section and force the runoff of converge section flow to crop planting section together with the runoff of crop plant section for crop use
共同的特點是改變地表空間立體微地形下墊面建設匯流區（也叫集流區）和作物種植區，將匯流區的雨水徑流疊加匯集到種植區進行利用，既利用匯流區的來水，又利用集流區的雨水。 -
Solid's flow can be measured by weigh dump.
固體的流量可以由翻斗秤測量。 -
In this thesis, flow regime identification and malfunction diagnosis of fluidization were studied with fractal technology, the presented methods for both flow regime identification and malfunction diagnosis were proved of effectivity. main achievements are as following : 1. fractal brownian motion ( fbm ) was made from gauss noise and compared with pressure fluctuation signal of gas - solid fluidization, which demonstrated the similarity between the fbm and the signal
在通過fbm （分數布朗運動）數據模擬證明了氣固流化床壓力波動信號與分數布朗運動是相似的基礎上，提出了用分數布朗運動來模擬氣固流化床壓力波動信號，並採用r s分析法從信號時間序列中提取出hurst指數，通過分析信號hurst指數值對流化床流型和結塊故障進行了研究。 -
In the previous direct simulation monte carlo ( dsmc ) method used in the dilute gas - solid flow, particle collision probability was calculated by the equation used for rarefied gas molecules. and gas phase was simulated by the laminar navier - stokes equations
已有的應用直接模擬蒙特卡羅（ dsmc ）方法模擬流化床內稀疏氣固兩相流動的研究中，均採用稀薄氣體分子碰撞概率的計算方法計算氣固兩相流中顆粒的碰撞概率，採用層流navier - stokes方程模擬氣相流動。 -
Combination effect of nozzle gas distributor and particle properties on gas - solid flow behaviors in cfb risers
噴管型氣體分佈器和顆粒物性對提升管內氣固兩相流動行為的聯合影響 -
Gas - solid flow simulations in spouted beds on body - fitted coordination
貼體坐標系下噴動床內氣固兩相流體動力特性的數值模擬 -
It was found that the ultra - fine powder can flow smoothly in a spouted bed with a draft tube under some sorts of design parameter and operating condition, thus a new effective method to improve fluidization quality of the ultra - fine powders is obtained ; at higher supplied gas velocity, an increase in the solid circulation rate is observed ; the extent of the distance between the nozzle and the draft tube inlet result in the promotion of the solid circulation rate ; the solid circulation rate increase with increasing the draft tube diameter or the bed mass ; the gas bypassing is nearly zero in the present work ; and the solid flow in the annulus is observed as a moving bed
結果表明：在一定的床層結構和操作條件下，超細粉可以在導向管噴動床中實現平穩流化，從而為改善超細粉的流化質量提供了一種有效的新方法；固體循環速率與噴動氣流量、導向管直徑、導向管底部與噴嘴出口間距以及床層裝填量成正比；氣體則基本上不存在「旁路」現象；環隙區中的顆粒流動表現為一移動床特徵。 -
Visual images and micro - structure of various clusters are also captured using high - speed imaging under the typical operating conditions, which reveals the variability of gas - solid flow pattern under high solid concentration
同時獲得了典型工況下多種流態圖及顆粒團顯微圖片，揭示了循環流化床內氣固流型及其變化規律。 -
Numerical simulation of a 3 - d gas - solid flow in a spouted bed
三維噴動床氣固兩相流數值模擬 -
The hot dry rock geothermal energy is a r. ew clean energy and have excellent development prospects, but is not yet exploited on large - scale in our country then to mankind : the theories and technique of the heat extraction all belong to the new task in the new field, and already have a strong appeal to the international technology worker, and already have obtain certainly achievement, on the basis of study by our predecessors, this paper do the as follows work, acquire the following main result : lx present a many fields coupling mathematics model for solid - flow - heat of 3d blocked medium in hdr
高溫巖體地熱是我國以至人類尚未大規模利用而又極具廣闊開發遠景的新的潔凈能源，對其進行開發利用的理論與技術都屬于新型領域的新型課題，已經吸引了大批的國內外科技工作者的投入，並取得了一定的成果。在前人研究的基礎上，本文做了如下工作，獲得了如下主要成果： 1 、建立了高溫巖體地熱開發的塊裂介質固、流、熱多場耦合數學模型，模型控制方程包括完全耦合的變形方程、滲流方程、熱傳導與對流方程，描述了熱儲層的非線性特性。 -
And the microstructure, the hardness and the wear resistance properties of complicated parts had also been studied and analyzed. the results showed that under the same experiment condition, the semi - solid flow and deformation properties of the composites increased with the increasing of the sic particles " volume fraction which below 12 %, that he composite reinforced with different volume fraction of sic particles were die - cast into complicated parts successfully, that sic particles dispersed even more uniformly in their complicated parts, and that he complicated parts " hardness was better than the composites "
結果表明，在sic顆粒體積含量低於12的情況下， sic顆粒含量越高，復合材料的成型性能越好； sic顆粒增強鋁基復合材料能夠用壓鑄的方法制備復雜壓鑄件； sic顆粒在壓鑄件中分佈更為均勻，且呈單顆粒；壓鑄件的硬度比復合材料鑄錠的硬度高； sic顆粒增強鋁基復合材料的壓鑄件耐磨性高於復合材料鑄錠。 -
We successfully apply the two - fluid model ( tfm ) to the study of two dimensional and three dimensional dense gas - solid flow characteristics. the results show some rules on the particle collisions and gas particle interactive influence of the vertical upward pipe
在對高濃度氣固兩相流的研究中，成功的運用雙流體模型對兩維和三維垂直立管段進行了研究，揭示了垂直立管內的高濃度氣固流動的顆粒碰撞以及氣相和顆粒相的相互影響的一些規律。 -
Stability analysis on particle uniform distribution in cocurrent - up gas - solid flow
氣固併流上行流動中顆粒均勻分佈的穩定性 -
The numerical simulation of the gas - solid flow properties in the air - cushion anti - erosion cascades
氣墊防磨葉柵內固體顆粒運動特性的數值模擬 -
Our work is only an attempt about the study on the dense gas - solid flow and combustion technique of cfb and w - shaped furnace. the results testify the accuracy and efficiency of the numerical simulation method ( or computer aided test method ) on the prediction and validation of the engineering flow and combustion problems
本文的工作是對高濃度氣固多相流研究和流化床和w爐燃燒技術研究的嘗試，所取得的結果表明數值試驗方法在預測和驗證工程流動、燃燒問題方面的準確性和有效性。 -
We successfully apply the two - fluid model ( tem ) and kinetic theory of granular flow studying the two dimensional dense gas - solid flow characteristics in the large scale circulating fluidized beds and the cold experimental system with piv. the results of simulation are in accord with others " simulation and experimental results. in the end, we make the three dimensional simulation for the cold cfb riser, which is closer to the factual operation and this experimental results
在對高濃度氣固兩相流的研究中，根據fluent軟體現有的條件和解決工程實際問題的需要，採用單氣固相雙流體歐拉模型，採用模擬紊流固粒流中普遍接受的方法「顆粒流的運動理論（ kinetictheoryofgranularflow ） 」 ，對大尺度循環流化床進行了二維數值模擬，與他人數值模擬結果和實驗結果進行了對比，檢驗模型的準確性。 -
It is applied in studying the gas - solid flow pattern in the cold circulating fluidized beds ( cfb ) boiler with the particle image velocimetry ( piv )
本文採用自行構建的piv系統對循環流化床冷態流場進行了試驗研究，獲得了不同工況下氣固兩相流動特性。 -
Fluidized behaviors of ultra - fine powder caco3 of mean diameter 5 um in a spouted bed with a draft tube were investigated, studying the effects of geometry and operating parameters on the two - phase fluidized characters such as the initial spouted behavior, the solid circulation rate, the gas flow distribution in the spout and the annulus, and the solid flow in the annulus
本研究以平均粒徑為5 m的caco _ 3超細粉為物料，對超細粉在導向管噴動床中的流化行為進行了系統的實驗研究，考察了床層結構和操作條件對起始噴動行為、固體循環速率、氣體在床層雙區中的分配以及固體顆粒在環隙區中的流動等氣固兩相流動特徵的影響。 -
Our work is only an attempt about the study on the application of piv techniques and numerical simulation in the dense gas solid flow of the circulating fluidized beds. the results show that the accuracy and efficiency of the piv techniques and numerical simulation method on the test and prediction of the hydrodynamics of the gas solid in circulating fluidized beds riser
本文的研究工作是對piv技術應用於循環流化床內氣固多相流動特性測試和數值模擬的嘗試，所取得的結果表明piv技術和數值試驗方法在測試和預測氣固多相流動特性方面的準確性和有效性。 -
On the base of the study of dense gas - solid flow, we make full - scale numerical simulation on the combustion and pollutant emission processes of the 75t / h circulating fluidized bed ( cfb ) which is developed by our institute. we draw the conclusion on the characteristics of flow field, particle track, temperature profiles and species profiles. we also study the characteristics of coal combustion and nox formation and the interactive influence between them
在對高濃度氣固兩相流動的系統研究基礎上，針對我們熱能所研製開發的75t h循環流化床熱電氣三聯供裝置，首次對于流化床燃燒爐內的燃燒和污染物排放進行了較全面的數值模擬，得出了爐內的流場、顆粒軌跡場、溫度場和組份場，研究了煤粉燃燒特性和氮氧化物的排放特性以及影響它們的因素。
分享友人