solid-liquid-solid growth 中文意思是什麼

solid-liquid-solid growth 解釋
固-液-固生長
  • solid : adj 1 固體的；實心的，實質的，密實的。2 【數學】立體的，立方的，三維的。3 結實的，堅強的，堅固的...
  • liquid : n 1 液體。2 【語言學】流音〈如 [l] [r]〉 adj 1 液體的，液態的，流動的。2 清澄的，透明的。3 易變的...
  • growth : n. 1. 生長，成長，發育，發展。2. 栽培，培養。3. 生長物，產物；【醫學】瘤，贅生物。4. 【經濟學】（資本價值與收益的）預期增長。
  1. Controlling solid - liquid interface configuration during crystal growth of cdznte by vertical bridgman method

    晶體時固液界面形狀的控制
  2. A white solid that is in organic solvents such as ethanol and acetone and the like, easy to be deliquescent : its solution is colorless transparent liquid, primarily utilized as fungicides additives to prevent the growth of microbe and algae

    0 . 01物化性質：無色或微帶黃色結晶或結晶興粉末，具吸濕性，易溶於水乙醇甲醇和丙酮，熱至160以上分解。
  3. All the hairy roots of a. ficoidea cv. " ruliginosa " could have a rapid autonomous growth on phytohormone - free liquid or solid ms medium

    紅龍草毛狀根能在無激素的固體或液體培養基上快速自主生長。
  4. The results showed that the growth of root tips in liquid medium was better than that in agar - solidified medium and solid - liquid two phase medium, for that increasing agar concentrations in medium will reduce the root growth ; darkness was beneficial for fraxinus mandshurica root tip culture in vitro ; as the carbon sources, sucrose was better than glucose and maltose as the carbon sources, and 3 % sucrose was best for the root tip growth of fraxinus mandshurica

    結果表明，不添加瓊脂的液體培養基對根尖的生長較添加瓊脂的固體培養基和固液培養基好，原因是增加瓊脂的量會抑制根的生長；暗培養比光培養更有利於水曲柳離體根尖的培養；蔗糖作為碳源的效果較果糖和麥芽糖好，其中以3 %的蔗糖對離體根尖的生長效果最好。
  5. In the model, many processes or phenomena such as crack friction and growth, heat conduction, phase transformation of oxidant particulates, heat generation by viscous liquid layer, chemical reactions of gases in cracks, heat and mass exchange between phases of gas and solid, are described

    模型描述了裂紋滑移擴展、熱傳導、含能顆粒相變、液化層粘性加熱、裂紋內氣相反應、氣相固相質量能量交換及與裂紋擴展耦合等過程。
  6. Considering the mass balance law for solute, and combining with the populance balance model and the mccabe ' s l law, a linear crystal growth rate model was presented for potassium nitrate aqueous system. the test variables of both the liquid and solid for kinetic parameter estimations were given on this model, and the experimental apparatus were also set up

    基於粒數衡算模型，以kno _ 3 - h _ 2o為模型研究體系，根據結晶過程中溶質質量守恆和mccabe定律，首先建立了晶體線性生長動力學模型，並確定出動力學參數估計所需要表徵的固液兩相物理參數，進而建立了實驗表徵方法和測定裝置。
  7. In order to study these questions, we researched three topics in this paper mainly : 1. we prepared zno nanowires using chemical vapor deposition ( cvd ) method based vapor - liquid - solid ( vls ) mechanism. our object was getting arrayed and controllable growth of zno nanowires through integrating the controllable ability of vls mechanism and merits of cvd and controlling the technique conditions of preparation

    針對以上存在的問題，本文主要在以下三個方面進行了初步的探索: 1 .採用基於氣-液-固（ vls ）生長機理的化學氣相沉積（ cvd ）法制備zno納米線，結合vls機理對生長過程的控製作用以及cvd方法的優點，通過對催化劑、源溫度、生長溫度和反應氣氛等工藝條件的控制，得到納米線的陣列化生長。
  8. As a result of the unparalleled levels of population and economic growth hong kong has experienced since the late 1960s, and the heavy reliance on marine waters as the receiving medium for liquid, and some solid, wastes, there has been a progressive deterioration in hong kong s marine water quality

    吸納能力的資產海水的吸納能力自六十年代末期開始，人口及經濟急劇增長，日益增加的液體及部分固體廢物不斷排入海域，引致本港海域水質日趨惡劣。
  9. The high resolution transmission electron microscopy ( hrtem ) and energy - dispersive x - ray ( edx ) suggested that the two steps growth pattern overcame the shortcomings of templet - confined reaction mechanism, catalytic reaction growth based on vapor - liquid - solid ( vls ) mechanism and oxide - assisted growth mechanism, which would introduce contaminates unintentionally

    高分辨電鏡（ hrtem ）和能譜分析（ edx ）說明合成的gan納米材料純度非常高。兩步生長模式克服了模板限制工藝、基於vls機制的催化生長工藝和氧化輔助生長工藝無法避免引入雜質的缺點，有助於一維高純gan納米結構光電特性的研究。
  10. The thermodynamic conditions of decomposition of the foaming agent tih2, homogeneous and heterogeneous nucleation in high - temperature solid and liquid, growth and movement were achieved to demonstrate the trend of pore evolvement in this paper. moreover, according to the characteristics of in - situ gas foaming, the equations of the height change of foaming samples with heating time were primarily established to study the behavior of foams and to guild the experiment processes

    另外，論文通過大量的熱力學分析，得出了發泡過程中發泡劑分解以及氣孔在固液態時的均勻形核和非均勻形核、氣孔的生長和運動等熱力學條件，揭示了氣孔演化的趨勢；論文還根據內生氣源發泡的特點，初步建立了高溫熔體中氣體發泡高度隨時間變化的方程，為進一步深入的研究發泡機理奠定了一定的基礎。
分享友人
分享到 Line

分享到臉書