solution feed 中文意思是什麼

solution feed 解釋
液加
  • solution : n. 1. 溶解；溶液，溶體，溶劑。2. （補輪胎用的）橡膠水；〈美國〉藥水。3. 解決，解答 （of; for; to）; 解釋；（數學等的）解法，解式。4. 免除，解除。5. 【醫學】消散，消退。
  • feed : feed1fee 的過去式及過去分詞。vt 1 給…飲食，給…東西吃；給（嬰兒）餵奶。2 喂養，飼養，使吃草，放牧...
  1. The model 625 analyser is designed to monitor the dissolved oxygen concentration in boiler feed-water and other aqueous solution.

    625型分析儀用來監視鍋爐進水和其它水溶液中溶解氧的濃度。
  2. Raw solution flows into the bowl through feed pipe i and intothe distributor 2 it undergoes acceleration until it reaches the bowlrotating speed

    物料通過進料管道（ 1 ）進入分配器（ 2 ）在這里被加速直至達到轉筒的轉速。
  3. Safety of transgenic feed and solution

    豬飼養環境的福利問題與安全豬肉生產的對策
  4. In order to improve the utilization efficiency of energy and equipment, a general steady simulation model of complex cross - feed multi - effect evaporation was established for the purpose of in - depth research on rule of multi - effect evaporation. in this model, the energy - saving measures, including extra steam being led off to preheat material liquid, the condensation water flash and solution flash, were adopted, and the solid separation was also considered in the process of evaporation

    為了提高多效蒸發系統能量與設備的利用效率以及深入研究多效蒸發過程的規律，建立了帶有冷凝水閃蒸、溶液閃蒸和引出額外蒸汽預熱原料液等節能措施並考慮蒸發過程有固相析出的復雜錯流多效蒸發穩態模擬通用模型。
  5. The results of carp ' s growth performance indicated : the mixed nutrient solution of psb could improve the increase of carp ' s weight than other three groups ( carp ' s diet of juxing, flavomycin, " yixubao " ), they are 9. 5 %, 9. 6 %, 15. 4 % respectively. and it could decrease the feed consumed / gain of carps than others, they are 2. 6 %, 6. 3 %, 4. 8 % respectively. all those showed that the mixed nutrient solution of psb could enhance the growth performance of carp

    光合細菌復合培養物作為飼料添加劑應用於鯉魚生產試驗，在飼喂35天後試驗組總增重分別比某公司魚飼料組、添加黃黴素組（ 3ppm ） 、 「益畜寶」組提高9 . 5 、 9 . 6 、 15 . 4 ，料肉比降低了2 . 6 、 6 . 3 、 4 . 8 ，說明光合細菌可以提高鯉魚的生產性能。
  6. A feed solution initially containing one or more solutes is thoroughly mixed with an immiscible solvent having a different density. the mixing provides a large interfacial area so that efficient mass transfer of the desired solute can occur between the two immiscible liquids

    在此離心力場中，多相混合液因為其密度不同，所受的離心力亦不同，固而產生分層現象，從而達到萃取或分離的目的。
  7. To prepare the functionally gradient materials ( fgm ) of polysilane - polyacrylate, the method of solution preparation was performed. based on the results of the back - scattered electron images and linear scanning of the polysilane - polyacrylate film ' s cross section, the dependence of polysilane - polyacrylate film ' s structure on molecules of polysilane and polyacrylate, pmma / pmts feed ratio and component concentration were investigated

    通過測試有機硅聚合物-聚甲基丙烯酸酯樹脂膜的結構，分析了聚有機硅（ pmts ） 、聚甲基丙烯酸酯（ pmma ）的分子量、 pmma pmts體系配比、組分濃度等因素對有機硅聚合物-聚甲基丙烯酸酯樹脂膜結構的影響。
  8. When nals was used as the collector in the process, the optimal conditions were the ph of feed solution 5. 0 - 6. 0, air flow rate 100ml / min, the liquid column depths 20cm, the surfactant concentration determined by its cmc and feed concentration. under this condition, the 3 can be above 20. also, the optimal ph ( 5. 0 ) was calculated theoretically for the recovery of the cu ( ii )

    對以十二烷基硫酸鈉為捕集劑的泡沫吸附分離過程的工藝參數進行了研究，並得出本分離系統所確定的最佳工藝參數為： ph5 . 0 6 . 0 ，氣體流量100ml min ，液位高度20cm ，最佳表面活性劑濃度由其臨界膠束濃度和原料液濃度確定，此時（濃縮比）可達20以上；同時還從理論上推算出泡沫吸附分離銅的最佳ph值范圍為5 . 0左右。
  9. The factors, such as feed solution concentration, stirring speed, strip solution concentration and the ph value of feed solution, have been discussed when the membrane phase only contained membrane solvent

    當膜相中不含載體時，分別考察了攪拌速度、料液相濃度、反萃取液濃度和料液相ph值等因素對滲透系數的影響。
  10. In this paper, concentrated sulfuric acid and titanium dioxide are used to prepare the tios04 solution that test later required under long time heat. the influences of reaction time and reaction temperature to yield of tioso4 are discussed. in the experiment of preparing tio2 powder, reaction temperature, ph values, material ratio, operation way, velocity of feed, calcining heat and time are researched by the principle of nucleation and growth in thermodynamics and kinetics

    在制備tio _ 2粉體實驗中，根據成核生長的熱力學和動力學原理，深入分析了沉澱反應時環境的溫度、 ph值、反應物配比、操作方式、加料速度等因素對ti （ oh ） _ 4粒度的影響，以及焙燒溫度和保溫時間等因素對制得的納米tio _ 2粉體性能的影響，得出了制備銳鈦型納米tio _ 2粉體的優化工藝條件。
  11. The effects of the mole ratio of anhydride to amino group of chitosan in the feed solution on the solubility, intrinsic viscosity and molecule weight of the product were studied

    研究了投料物質的量比對產物的溶解性、特性黏度和相對分子質量的影響。
  12. The influence of the temperature of durene solution, the height from airway nozzle to liquid level, the temperature and feed rate of air on the vapor phase concentration of durene were studied with the self - made adjustor

    摘要利用自製的高熔點物料氣相濃度調控儀，研究了均四甲苯溶液的溫度、導氣管管口距離均四甲苯液面的高度、空氣進氣溫度和進料量等對均四甲苯氣相濃度的影響。
  13. As a result, the temperature of the durene solution and the feed rate of air had a greater influence on the vapor phase concentration of durene, whilethe influence of the height from airway nozzle to liquid level and the feed air temperature on the vapor phase concentration was small

    實驗結果表明：均四甲苯溶液的溫度、空氣進料量對均四甲苯氣相濃度影響較大，而導入管距離液面的高度和空氣溫度影響較小。
  14. Material balance and energy balance equations of complex multi - effect evaporation system were expressed in matrix equation, which has the advantages of clear structure and high modularization. by holding or omitting correlation block - matrix in matrix equation, matrix equation could be used to describe the difference of forward - feed, back - feed and cross - reed multi - evaporation system with or without solid separation, extra steam being led off to preheat material liquid, condensation water flash, or solution flash. the models include design and operation

    該模型利用矩陣方程具有結構清晰和高度模塊化的特點，將復雜多效蒸發系統的物料及熱量衡算方程組以矩陣形式表達，通過保留或舍棄矩陣中特定功能模塊，模型就能代表有或無固相析出、有或無引出額外蒸汽預熱原料液、有或無冷凝水閃蒸、有或無溶液閃蒸等不同情況以及各種情況任意組合的併流、逆流、錯流多效蒸發過程，從而實現模型的通用性。
  15. This paper demonstrates how to generate variable pwm waveform based on standard cpld device, the proposed circuit is incorporated with mcu to provide simple and effective solution for high - performance pwm converters. in the brushless model, the igbt ( isolated gate bipolar transistor ) switch state period table is gained by mc33035 which analyzes the signal of position feed - back

    這部分功能在cpld器件中用vhdl語言開發實現，其isp （在系統編程）方式使得設計與維護都比傳統方法方便靈活，由於逆變器開關元件的觸發信號是由硬體來產生的，因此更容易實現準確的高速實時控制。
  16. Has analyzed the existing thermal power plant boiler superheat vapor temperature governign system control strategy, proposed exports the vapor temperature using the boiler the rate of change and the chamber exports the haze temperature to take the forward feed signal, the solution superheat vapor temperature adjustment hysteresis quality

    分析現有熱電廠鍋爐過熱蒸汽溫度調節系統的控制策略，提出利用鍋爐出口蒸汽溫度的變化率和爐膛出口煙氣溫度作為前饋信號，解決過熱蒸汽溫度調節的滯后性。
  17. 4. more than 95 % np can be adjusted to np ( v ) if no was bubbled into 1af feed solution. various experiments ( tube cascade test, mini - mixsettler test, and bench scale warm test ) show that, 95 % - 98 % np flows into 1aw under the selected process parameters

    在不同條件下的試管串級實驗、微型混合澄清槽實驗和全流程臺架溫實驗結果表明，在選定的工藝條件下，多數情況下可使98的np進入高放廢液（ 1aw ）中，最低也使大於95的np進入1aw 。
  18. Under the conditions of operation pressure about 0. 5mpa and feed temperature 25c, the rejection performance of nacl feed solution ( 500ppm ), is about 36 %, while the flux is about 40. 3ml cm - 2 h - 1

    在本研究中，利用溶膠一凝膠法制備出平均孔徑約為15nm 、水通量為7oml ? 。 m一2 ? h一1 、性能較好的5102 / a12o3無機復合超濾膜。
  19. Under the conditions of operation pressure about 0. 8mpa and feed temperature 20 ?, the rejection performance of er feed solution is about 98 %. ftir and sem are used to analyses the structure and component of membranes

    結果表明， 5102 / a120 :無機超濾膜一聚乙烯醇/ 510 :一a1203復合納濾膜混合膜分離體系對紅黴素的提取率可達98 % 。
  20. Under the conditions of operation pressure about 0. 5mpa and feed temperature 25 c, the rejection performance of nacl feed solution ( 500ppm ), is about 35 %, while the flux is about 45ml cm - 2 h - 1. the pa membranes were prepared by interfacial polymerization, usingl, 3, 5 - benzenetricarbonyltrichlori2, 4 - dichloroterephthalaldehyd e, 1, 3 - phenylenediamine as monomers

    研究結果表明， 5102 / a12o :無機復合超濾膜的研製原料正硅酸乙酷、乙醇、水、 n ， n一二甲基甲酸胺（ dcca ）和hno3之間的配比、塗膜過程、熱處理溫度等直接影響著溶膠的質量和膜的性能。
分享友人
分享到 Line

分享到臉書