source electrode 中文意思是什麼

source electrode 解釋
供電電極
  • source : n 1 源頭，水源，源泉。2 根源，本源；來源。3 原因；出處；原始資料。4 提供消息的人。5 血統。vt 〈美...
  • electrode : n. 1. 電極。2. 電焊條。adj. -less 無電極的。
  1. In order to eliminate the influences caused by temperature, electrode - polarization and autoeciousness - capacitance, the traditional instrument has added complicated circuits so that it cause such shortcomings as big error, time - retardation and a relatively small scope. through the problems caused by 2 - probe electrode and ac current source, a new measuring circuit based on the excitation of bi - directional voltage pulse and the sensor of 4 - probe electrode is proposed, using single - chip to achieve auto - temperature compensation

    作者在參閱國內外大量相關參考文獻的基礎上，從電導測試技術的原理性研究出發，分析了採用交流激勵源、兩電導電極為傳感器的傳統電導測試系統所面臨的種種問題，提出並研製了一種基於雙極性脈沖電壓激勵、以四電導電極為探頭、運用單片機進行溫度自動補償的新型電導率測量系統。
  2. Positive electrode and negative electrode that execute spanning crack prevention are simulated as the source point and merged point, so the temperature field owing to the concentration of current around the crack tip is educed at the moment when the current is switch on

    將實施跨越止裂時的正、負電極比擬為電流場中的源和匯，從而導出了在瞬間電流作用下，裂紋尖端附近區域因繞流而形成的溫度場。
  3. It is found that the height of the metal electrode, the distance between the source and drain electrodes, the thickness of the sio

    研究了場效應納電子晶體管構造過程中金屬電極的結構設計，源-漏電極高度sio
  4. The shorter the interval between the two pulses of the current wave, the fewer strikes the varistors can endure. at the same time, the dc ljima changes fast - slowly - fast alone with the experiment continuing. microstructual disorder, such as variations in the height of the electrostatic potential at grain boundaries and electrode protrusions into the zinc oxide varistors, causes substantial temperature rise in a microscopic region around the defect and is the source for failure

    雷電的多重閃擊對雷電過電壓保護器件的影響更加嚴重，本文首次採用不同間歇時間雙脈沖電流沖擊對氧化鋅電阻進行了多次試驗，試驗表明：氧化鋅電阻在雙脈沖電流沖擊下更容易出現老化破壞現象，間歇時間越短，電阻能耐受的沖擊次數越少；此外，直流u _ （ 1ma ）值隨沖擊次數的增加具有快一慢一快的下降過程。
  5. We also studied some characteristics of sidagating effect using mesfet fabricated in planar boron implanted process including photosensitive, hysteresis, influence of sidegating effect on mesfet threshold voltage, influence of drain - source voltage on sidegating threshold voltage, influence of exchanging drain and source electrode on sidegating threshold voltage, relation between sidegating threshold voltage and the distance between side - gate and mesfet, relation between sidegating effect and floating gate, and so on

    本文還採用平面選擇離子注入隔離工藝，開展了旁柵效應的光敏特性、遲滯現象、旁柵效應對mesfet閾值電壓的影響、 mesfet漏源電壓對旁柵閾值電壓的影響、漏源交換對旁柵閾值電壓的影響、旁柵閾值電壓與旁柵距的關系、旁柵效應與浮柵的關系等研究。
  6. The variable polarity power supply circuit uses two stages full - bridge inverter, the former inverter is regarded as a constant - current source with fast dynamic response, and supplys energy for the second one, and the latter one is to produce variable polarity current excellently, and low - frequency pulse current by variable polarity power supply is used to reduce input energy and control the shape of weld bead while welding. a series of high - frequency pulse current is superposed on direct - current - electrode - negative ( dcen ) current through the high - frequency pulse power supply, which is used to compress the arc and improve process of crystallization

    其中變極性電源採用二次全橋逆變結構，一次逆變提供快速的響應速率並給二次逆變提供能量，二次逆變提供良好的變極性性能，使輸出能量最優化，並用其低頻電流特性減小電弧線能量，控制焊縫成形;高頻脈沖電源提供的高頻電流疊加在反極性電流dcen上，利用電流的高頻特性壓縮電弧，改善焊縫金屬結晶過程。
  7. 2 for an impulse source there shall be a peak reading instrument voltmeter connected directly to the electrode head, indicating continually the potential of the electrode with or without a grounded test wire in the chamber

    脈沖火花機，電壓表直接接在試驗電極上，顯示的是測試電線沒有接地的情況下的峰值電壓。
  8. Ni / mh battery is a new type of power source, which adopt hydrogen storage alloy as active material of negative electrode

    Mh - ni電池是採用儲氫合金材料作為負極的新型化學電源。
  9. But there are still several problems concerning the stability and reproducibility of device fabrication. the heavily born doped p - type diamond films synthesized by hot filament chemical vapor deposition with b ( ch3 ) 3 as boron source substituted the metal electrode aluminum

    本文還利用熱燈絲化學汽相沉積（ hfcvd ）法，採用硼酸三甲酯b （ ch3 ） 3為硼源制備了重摻雜p型金剛石膜，作為lppp / alq異質結增強型發光器的電極。
  10. As far as the new technology of selective diffusion, the method of printing is used and the phosphoric paste ( high concentration ) is printed at the electrode - site in silicon. afterwards, a thin layer of phosphoric source ( low concentration ) is sprayed on the surface of the non - electrode - site in silicon

    在選擇性擴散新工藝中，我們採用絲網印刷電極的方法在矽片的電極位置印刷濃度較高的磷漿（摻磷sio _ 2乳膠） ，在非電極區噴塗一層濃度較低的磷源，擴散后形成重摻雜和輕摻雜。
  11. By carrying on experimental study to the ignition performance of the natural gas high speed burners under different conditions, the influence factors are probed such as the type of the gas source, the combustion air pressure, the gas pressure, the proportion of air and gas, gas flow and electrode to the ignition performance of natural gas high speed burner

    摘要在不同的條件下對天然氣高速燒嘴的點火性能進行了實驗研究，探討了氣源種類、助燃空氣壓力、燃氣壓力、空氣與燃氣的比例、氣體流量、點火電極等因素對天然氣高速燒嘴的點火性能的影響。
  12. In the simulation study, the parameters of dipoles were given, it would be considered whether it could be recovered correctly by dllm based on scalp potential sampling with a set of electrode array. it was also examined that how electrode number influenced the recovered quality of dipole parameters. the simulation showed that the number, position and strength of dipole set were greatly close to the original condition ; the shallower the dipoles were, the higher the precision of source localization was ; the optimal depth of dipole layer was greatly close to the ideal position ; the accuracy of source localization was increasing when more electrodes were used

    在模擬研究中，首先設定已知的偶極子數目及其所在的偶極面深度等參數，然後用一定數目的電極抽取正向計算獲得的頭皮電位，考察該模型在上述理想條件下，基於頭皮電位是否能正確獲取偶極子數目及其參數、以及電極數目對結果的影響。
  13. Effect of the auxiliary electrode radius in a vacant circular pipe on ion dose in plasma source ion implantation

    附加電極半徑對空心圓管端點附近離子注入劑量的影響
  14. This paper describes a reconstructive algorithm which is based on network theory for electrical capacitance tomography technic. there are twelve electrodes in the system. the permittivity distribution of flow with two components within a pipeline is reconstructed. assume the permittivity distribution of the region to be reconstructed. then whole measured area is discretized into a network composed of capacitance. the measurement circuit which contains a pair of source electrode and detecting electrode is taken as a four - terminal network. the across admittance of the four - teminal network is proportional to the capacitance between the source electrode and the detecting electrode. modify the distribution of the permittivity according to the difference between the calculated capacitance and measured capacitance. the experimental results show that this algorithm is effective and can coverge

    本文描述了一種用於兩種成份的流體成像的12電極電容層析成像新方法.該方法基於電路的網路理論，首先對重建區域假定一個介電率分佈，用電容網路作為離散化模型，將每一個源電極和探測電極對組成的測量電路看作一個四端網路，該四端網路的跨導與源電極和探測電極之間的電容值是線性關系，這個電容值和測量得到的電容值之間存在誤差，根據這個誤差對修正介電率分佈.通過對不同介質分佈作的模擬實驗結果，證實了該演算法是有效的，收斂的
  15. Stationary source emission. determination of fluoride. ion selective electrode method

    大氣固定污染源.氟化物的測定.離子選擇電極法
  16. According to basic theories for distributing regular of electric field about surface single spot current source and high density resistivity prospecting method in this paper. put forward an installation which use one current electrode or dipole current electrodes and the others prospecting at the same time to realize high density resistivity method by office date processing, such as wenner pole - dipole a, wenner pole - dipole b, wenner alpha, wenner beta, wenner gamma and pole - pole array

    摘要運用地面點電流源電場的分佈規律和高密度電阻率法的基本思想，提出了分別利用單極供電、偶極子供電，其餘電極同時測量，通過室內數據整理實現高密度電阻率法的溫納對稱四機、溫納偶極、溫納微分、溫納三極a 、溫極三極b和二極等裝置。
  17. An electro - discharge machining control comprising first and second current sources of relatively high and low voltage respectively, first switch means for repeatedly connecting said second source to an output for a first duration for connection to an electrode and second switch means for repeatedly connecting said first source to said output only when said second source is connected to said output and for a constant duration which is shorter than the first duration of the connection of said second source to the output

    放電加工控制包括較高和較低電壓的一級和二級電流源，第一個開關意味著用於重復連接第二電源到輸出線，用於第一個持續時間連接一個電極和第二個開關意味著重復連接第一個源到輸出線，只有當第二電源連接到輸出線時，固定時間間隔小於連接第二電源到輸出線的第一個持續時間。
分享友人
分享到 Line

分享到臉書