split test 中文意思是什麼

split test 解釋
開裂試驗
  • split : n 斯普利特〈前南斯拉夫港市〉。vt （split;splitting）1 劈開，切開，割裂，扯裂；剖分。2 使分裂，使...
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  1. A hundred and ninety - four test pieces are tested which involved six kinds of slenderness ratios and five cubic contents, and studies are done on the influence of cubic content and slenderness ratio to compressive strength, split strength and flexural strength of concrete, which lays the foundation of further study

    完成了涉及6種長徑比和5種體積摻量的194個試件的試驗，對短切玄武巖纖維體積摻量、長徑比等因素對混凝土抗壓、劈拉、彎拉強度的影響進行研究，積累了大量的數據，為進一步研究奠定了基礎、積累了經驗。
  2. Analog test study of nozzle width and split type ' s influence on pneumatic efflux element switching performance

    深寬比及劈高對氣動射流元件射流切換影響模擬試驗研究
  3. In this research, the lime - fly - ash bound macadam was joined with steel fibers, glass fibers and polypropylene fibers with the contents of the lime, the fly ash and the macadam fixed in lab tests. the study focuses mainly on the split strength, compression strength, and modulus of compressive resilience and shrinkage property of the lime - fly - ash bound macadam enhanced by different kinds of fibers. based on the test, a detail theoretical analysis was made on the relation of mechanical property, dry shr inkage with the variety and the quantity of fibers, applying the theories of strength, dry shrinkage and the methods of statistics, curve mimesis and variance analysis

    本論文主要是研究在同一種二灰碎石混合料（石灰、粉煤灰、集料的含量及比例相同）中分別摻入不同數量的鋼纖維、玻璃纖維、聚丙烯纖維，通過室內試驗對其抗拉強度、抗壓強度、抗壓回彈模量和乾燥收縮性能與纖維摻量和纖維品種之間的關系加以分析和研究，並在此基礎上根據二灰碎石強度形成機理、乾燥收縮機理和數理統計、曲線擬合、方差分析的方法分析纖維品種和纖維數量對二灰碎石的力學性能和乾燥收縮性能的影響，最後得出纖維對二灰碎石的強度、抗壓回彈模量、乾燥收縮有很顯著的影響，並提出了相應的建議。
  4. During blasting test of rock split in advance using double factors test method, the work is reduced and predigested

    在預裂爆破試驗中，採用雙因素試驗方法，減少了試驗的工作量。
  5. Test for strongest, untwist and split impatient of the ferro - concrete products

    強化混凝土的最大強度，耐彎折和耐裂度測試
  6. By using 5000kn pressure - bent testing machine, the specimens of boulder concrete and crushed stone concrete were tested through three - point - bending method and wedge - split tensile method, the scale division of the index dial of pressure - bent testing machine is larger, whereas the predicted test - load is lesser, so the velocity of exerted load is controlled through observing the reading of the multimeter which is connected with the collecting systerm in order to continuously exert test - load

    本文使用5000kn壓彎實驗機，對不同強度等級的卵石混凝土和碎石混凝土試件分別進行了三點彎曲試驗和楔入劈拉試驗。試驗過程中，由於實驗機噸位較大，而試驗荷載預計較小，為了能夠有效地控制加載大小和加載速度，採用通過觀察與荷載傳感器相連的萬用表讀數控制加載速度的方法，連續加載。
  7. Footwear - test methods for outsoles - determination of split tear strength and delamination resistance

    鞋靴.外底試驗方法.剝層撕裂強度和剝離阻力測定
  8. Footwear - test methods for outsoles - determination of split tear strength and delamination resistance ; german version en 12774 : 1999

    鞋靴.外底試驗方法.剖層撕裂強度和分層阻力測定
  9. Test - retest reliability, split - half reliability, internal concordance coefficient ( cronbach a coefficient ), content validity, construct validity and index validity of the mental self - supporting questionnaire of university students were good

    對自編的《大學生心理自立問卷》進行了盡可能多角度、多指標的信效度檢測。
  10. Split - half coefficient and internal concordance coefficient ( cronbach a coefficient ) were used to test reliability of the questionnaire. coefficient of all the factors was significant that shows the questionnaire has good internal concordance and high split - half reliability

    （ 2 ）本研究用分半信度和內部一致性系數（ cronbacha系數）檢驗問卷的信度，信度系數均達到顯著水平，說明中學校風問卷具有較好的信度。
  11. The specific research methods include : the reliability and validity of the scale ( cronbach ’ s of the scale, split - half reliability, the reliability of each dimension, discriminant validity, convergent validity ) ; the factor analysis method to get the dimensions of internal service quality ; the independent - samples t - test and paired - samples t - test method to analyze every discrimination of internal service quality ; the comparison of means to evaluate the sequence of every dimension

    具體的研究方法包括:對量表進行信度和效度分析，包括整個表的cronbach系數、分半信度、各維度的信度、區別效度和收斂效度的分析;使用因子分析的方法測量內部服務質量包含的維度;採用兩獨立樣本的t檢驗和兩配對樣本的t檢驗的統計方法對內部服務質量各差距進行分析;通過對樣本均值的比較，分別得出各維度在員工和管理者心目中的重要性排序。
  12. 3. reliability : l ) split - half reability computers the split - half correlation coefficient of the scale with the date of the 142 effective cases. 2 ) test - retest reliability : selects 30 cases to calculate person correlation coefficient after a month later

    3 、信度檢驗： （ 1 ）分半信度：利用正式施測的有效樣本142例，計算量表的按因素分半的相關系數。
  13. The 3 batches with 7 groups of prism concrete test specimens and the 3 batches with 22 groups of cube ones were used in mechanical properties test, and a series of parameters of rpc was acquired such as prismatic strength, the cubic strength, split and pull strength, deformation module, peak strain, poisson ' s ratio

    進行三批7組稜柱體試件和三批22組立方體試件的力學性能試驗，測定了rpc200稜柱體抗壓強度、立方體強度、劈拉強度、彈性模量、峰值應變、泊松比等參數，並建立了變形模量和峰值應變的擬合公式。
  14. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - tests - screen testing of ceramic alignment split sleeve by stress application - section 24 screen testing of ceramic alignment split sleeve by stress application

    纖維光學互連器件和無源元件.基本試驗和測量程序.試驗.用施加應力進行陶瓷準直套管篩選
  15. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - part 2 - 24 : tests - screen testing of ceramic alignment split sleeve by stress application

    光纖互聯裝置和無源部件.基本試驗和測量步驟.第2 - 24部分:試驗.對陶瓷校直夾板套筒加負荷的篩析試驗
  16. Some conclusions are drawn as following through analysis and research : 1. through rectifying finest sand character and concrete mix ratio test, anti - split capability of structure concrete is strengthen ; 2. heighten ratio of fly ash in finest sand concrete is beneficial to temperature control of huge volume concrete

    本文通過分析研究，得出以下成果: 1 .通過混凝土配合比試驗及特細砂混凝土改性研究，特細砂混凝土強度達到普通混凝土強度，且混凝土28天齡期極限拉應變為1 . 10xl0一4 ，高於普通混凝土29 . 4 % ，具有良好的抗裂性能。
  17. Water hydraulic pressure servo loading system can be used to execute static presses test, the tired test, the sum settle strength test, the resilience split test, static structure strength test, the structure pieces design experiments among others. it has a very extensive application in the aerospace field

    水壓伺服加載系統可用來對負載結構件進行靜力抗壓測試、疲勞測試、額定強度、斷裂韌度、結構靜強度、操作容限設計等試驗，在航空航天領域有著十分廣泛的應用。
  18. This paper presents five main contents which numerical well test studied, that are parameter matching method, accuracy control of numerical analog, net work split technology, combination with traditional well test methods and how to extend the scope of well test interpreta tion

    文中提出了數值試井研究的五個主要內容，即參數擬合方法、數值模擬的精度控制、網格剖分技術、與常規試井方法的結合、如何拓寬試井解釋的范疇。
  19. The main research work include : rock split in advance by the blasting ; the rock objection explored wit ultra sonic and quality evaluation ; a new technique of excavation of a protection layer once time ; deep hole steps explosion test research ; blasting material lest ; the blasting technique research of underground engineering

    主要研究工作有：預裂爆破試驗研究；聲波巖體探傷及質量評價；保護層一次開挖新技術；深孔梯段爆破試驗研究；爆破材料試驗；地下工程開挖爆破技術研究。
  20. Then this paper formulates a classification method of traffic modes, which accords to relation that different traffic modes affect mutually while moving. based on that classification of various traffic modes, this test proposes a combined modal split and trip distribution model of multinomial modes

    並根據各種交通方式運行時與小汽車流的相互影響關系，提出了交通方式分類方法，以此分類法為基礎，建立了聯合多方式劃分和交通分配模型，進行了等價性和唯一性證明，給出了模型演算法。
分享友人
分享到 Line

分享到臉書