stack pressure 中文意思是什麼

stack pressure 解釋
煙囪壓力
  • stack : n 1 (麥桿等的)堆,垛;乾草堆。2 積材,層積,堆積;〈英國〉一堆〈木材等的計量單位,=108立方英尺...
  • pressure : n 1 壓;按;擠;榨。2 【物理學】壓力,壓強;大氣壓力;電壓。3 精神壓力,政治[經濟、輿論等]壓力。4...
  1. Piezoelectric - stack can give more output displacement and pressure and have more rate of conversion and more stability than bimorph type. it has been used to all kinds of driving places. design of displacement amplification we design displacement amplification because of the little displacement output of the piezo - stack. this paper analyses the disadvantage and advantage of all sorts of amplification, and proposes a new type of displacement amplification based on

    鑒于壓電疊堆輸出位移小的特點,引入柔性鉸鏈位移放大機構,分析了各種放大機構的優缺點並結合實際問題,設計出基於三角形放大原理的橢圓形放大機構,利用有限元分析軟體ansys對放大機構的主要結構參數進行了分析,得出影響放大機構放大倍數的規律。
  2. Too much embankment of filled soil will result the destroy of road surface or instability of high - stack soil ; soil pressure at the top of culvert is the key parameter of culvert structure design, more or less of the parameter will result in economic waste or failure of structure

    堤頂沉降過大,輕者破壞路面,重者路堤失穩,涵洞頂部土壓力是涵洞結構設計的控制指標,計算過大導致經濟浪費,過小導致涵洞開裂,影響其使用壽命。
  3. Culvert under high - stack soil is a ubiquitous phenomena in road constructions in mountain, self - compression of high - stack soil can not be ignored, soil pressure at the top of culvert is affected by many factors, including the height of high - stack soil, section size of culvert, width of the bottom of valley, grade of valley, property of filled soil, construction procedure and techniques

    高路堤下埋設涵洞是山區公路建設的一種較為普遍的現象,高路堤自身壓縮較大,不可忽視,涵洞頂部土壓力的大小又受很多因素的影響,包括填土高度,涵洞截面尺寸,溝谷底部寬度,溝壁坡角,填築體性狀,施工工序與工藝等。
  4. Performance for a piezoresistive transducer pressure sensor to thermal and pressure environments can be predicted by finite element method. a simplified 1 / 8 model, considering silicon dioxide and nitride process as well as stack anodic bonding and adhesive bonding processes, was developed. the fem results were found to be comparable to experimental data. case studies suggested that pyrex stack induces certain amount of non - linearity, while it isolates hard epoxy nonlinear effect. flexible epoxy bonding or soft adhesive bonding is preferred to the packaging process. the viscoelasticity and viscoplasticity of bonding material will result in hysteresis and drift errors to sensor output. however, soft adhesive s influence on sensor can be ignored under relative stable environments. more over, detailed design and process information will help to improve modeling application

    熱、壓環境下壓阻變換壓力傳感器的性能可以通過有限元方法預測.這里研究了簡化的1 / 8模型,模型考慮了二氧化硅和氮化硅生成過程及堆陽極鍵合和膠粘結合過程.結果發現有限元預測結果和實驗數據具有可比性.範例研究表明,硼硅堆導致產生一定的非線性,但它隔離了硬環氧樹脂的非線性.在包裝過程中最好使用柔性環氧黏合或軟黏膠性結合.黏合材料的黏彈性和黏塑性將會導致傳感器輸出的滯后和漂移誤差.然而,在相對穩定的環境下,軟黏合劑對傳感器的影響可以忽略.此外,詳細的設計和過程信息有助於提高模型的適用性
  5. The slurry is pumped under pressure into a vessel that is fitted with a stack of vertical leaves that serve as filter elements

    過濾機葉片外表層用特殊結構的細濾網精製而成,中間夾有支撐網,過濾精度高
  6. The piezoelectric - pump driven by piezoelectric - stack is a newly development trend, it can accommodate frequency and pressure in a large scale and control the output flux in precision. this pump will widely apply to transfusion, feed oil and clean the equipment in industrial automation, and scientific research, lab, chemical preparation and cooling of cpu etc. driven theory of piezoelectric - stack because the piezoelectric - stack is the core part of the pump that we designed, we should pay more attention to driven principle of the piezo - stack so that we can using it correctly. this paper introduces piezoelectric material and interrelated parameter, output characteristic and driven principle and driving type of piezoelectric - stack

    壓電疊堆泵是一種以壓電疊堆作為驅動元件的微型泵,它是隨著mems的發展而發展起來的。本文提出利用壓電疊堆與柔性鉸鏈放大機構配合來驅動微型泵的橫隔膜,以達到泵送流體的目的。本文在查閱國內外大量文獻的基礎上,總結了國內外壓電疊堆泵的研究現狀,分析了壓電疊堆的動靜態特性,提出一種以壓電疊堆作為驅動源的壓電流體泵的構想。
  7. Investigations have been made on the influence of the heating power, working pressure, stack packing ratio, and the opening of the orifice valve and the double - inlet valve on the performance of the system

    以氦氣為工質,獲得了119 . 7k的脈管無負荷製冷溫度,在國內首次用熱聲機械進入低溫溫區。
  8. The vent pipe runs in parallel to the soil stack and is connected to the branch soil pipe from a bathroom on the fourth floor. it serves to equalize the air pressure between the main soil stack and the branch soil pipe

    污水排氣管與污水管平衡敷設,並與四樓一浴室的支污水管連接,作用是平衡主污水管及支污水管之間氣壓。
分享友人