stack temperature 中文意思是什麼

stack temperature 解釋
煙道溫度
  • stack : n 1 （麥桿等的）堆，垛；乾草堆。2 積材，層積，堆積；〈英國〉一堆〈木材等的計量單位，＝108立方英尺...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. An integrated process of wastewater treatment and utilization is presented. the process is made up of heating the soft water of room temperature by high temperature printing and dyeing wastewater via heat exchangers, reusing the low level base decrement wastewater of water washing for dust control and desulphurizing of stack gas and anaeration - aeration biological treatment of printing and dyeing wastewater. this process has fair economical benefit on the principle of so called waste control by waste itself. this might be an ideal process for printing and dyeing wastewater treatment and disposal, the effluent of this process is quite enough to meet the requirement of urban sewer collector. additionally also many advantages are attractive such as the complete return of biological sludge to digestion, no chemicals dosage and free of secondary pollution

    介紹了高溫印染廢水通過熱交換加熱常溫軟水、低濃度堿減量水洗廢水用於煙道氣除塵脫硫、厭氧-好氧處理一般印染廢水等印染廢水綜合處理技術，該技術具有較好的經濟效益，達到了以廢治廢的目的，生物污泥全部迴流硝化，不加任何藥劑，無二次污染，處理后水質達到城市截污管網標準要求，是一種較為理想的印染廢水處理工藝。
  2. There is a chemical reserve zone in the stack. in this zone the fe is present as feo, and the gas component is close to the balance composition of fe0. 947o / fe. so there is a part of longitudinal section, in which : l ) gas keeps its component, as ascending. 2 ) the composition of the gas is close to the equilibrium composition of the fe0 947o + co - " 0. 947fe + co2 under the temperature of the thermal reserve zone of about 1200 + 100k

    根據冶煉理論，高爐在爐身一定高度上有一個「化學貯備區」 ，在該區，含鐵物料實際上都是浮氏體，並且煤氣成分接近fe _ （ 0 . 947 ） o fe平衡時的成分，這樣，高爐內存在高爐熱控制模型開發一個縱向區域，在該區內：二）煤氣上升時，成分不變。
  3. It is also found that replacement of substrate and adjustment of film stack structure would lead to the change of drift, this will enhance the temperature stability of filter

    同時經過計算分析發現通過更換膜系基板和調整膜系結構可以改變濾光片中心波長的漂移，這個結果有助於提高濾光片的溫度穩定性。
  4. Ceramic material had better performance than steel and copper and the shorter the stack, the lower the initial temperature for oscillation

    而從熱聲振動的方式來看，強制振動比自激振動具有更低的起振溫度。
  5. Studying the heat - mass transfer and multi - spices electric - chemical reaction, a dynamic temperature model was deduced for molten - carbonate fuel cell stack. the thermal radiation, shift reaction, and the change of gas spices were considered in this model. establishing momentum equation, the paper has developed a 3d temperature and flow fields model for mcfc stack based on cfd technique

    建立了熔融碳酸鹽燃料電池堆內部單體的暫態溫度模型，並考慮了電堆的輻射換熱、轉換反應、反應氣體組分變化對溫度場的影響；根據mcfc的微分控制方程組，考慮氣體組分的熱力學性質及動量變化的影響，利用數值分析方法求解熔融碳酸鹽燃料電池堆的三維流場與溫度場，分析了各作用因素對熔融碳酸鹽燃料電池堆溫度分佈的影響機制。
  6. Please request for viewing closed stack materials, maximum 3 items, at least one day in advance, as some materials available for viewing are kept on closed stack in temperature and humidity conditioned stores

    因部份可供借閱的館藏需保存於有適當溫濕標準的閉架倉庫中，請最少於一天前申請索閱閉架藏品。
  7. In addition, the effects of stack structure and material property on the performance of the thermo - acoustic engine in terms of the critical temperature ratio were examined

    結果表明，合理設計板疊的結構和合理選擇板疊的材料，可以使得系統在較低的溫度下起振。
  8. Influence of stack method on the temperature field of cargoes in hold - over plate refrigerated vehicles

    冷板冷藏車中貨物堆碼對其溫度場的影響
  9. The goal of this thesis is to give a scheme on the application of wireless sensor network system indoor. first of all, we have a deep research on the ‘ telos ’ node, secondly, we build up a stack system structure of wireless sensor network to monitor the temperature of the building intellectively, design and realize the network stack including physical layer, data link layer, network layer and application layer. finally, we debug the software in order to verify the network layer and the application layer

    本文以智能樓宇溫度監測應用為設計目標，以em2420射頻晶元和atme128l單片機為設計載體，在詳細研究telos節點方案基礎上，對面向設計目標的室內無線傳感器網路節點的物理層、數據鏈路層、網路層和應用層之間的網路協議棧進行了實現性設計，建立了立足設計目標的無線傳感器網路協議體系，並在avrstudio4 . 11調試環境下對網路層和應用層設計正確性進行了調試驗證。
  10. The transfer of the carrier in photoconductor is anisotropy owing to the column structure of the film is anisotropy. on the basis of the new concept suggested in this paper, the maximum diffusion length in the lateral direction of the photo - carrier in the photoconductor ( which is related to the resolution of lclv directly ) as function of conductivities of both in lateral and normal directions in the film can be obtained as the expression as following. the nc - si / a - si : h photoconductor of lclv deposited and crystallized at low temperature of exactly 250 c stack column structure by al inducing a - si : h

    本文根據柱狀結構存在各向異性的特點，並根據半導體物理知識，推出光導層光生載流子橫向最大擴散長度（該擴散長度與液晶光閥光導層解析度直接相關）與薄膜橫向和縱向電導率關系的表達式為：由於a - si ： h在al金屬的誘導作用下在不高於250的溫度下即開始晶化，本文對用金屬al誘導非晶硅晶化制備的nc - si a - si ： h薄膜進行研究。
分享友人
分享到 Line

分享到臉書