standard signal source 中文意思是什麼
standard signal source
解釋
標準信號源-
The concept of " timing " in the article is not the clock in our ordinary living, but syntheses which is made up of some frequency source in the signal generator ( such as cs atom frequency standard, rb clock & high accuracy quartz crystal oscillator ) which produces the primary frequency, the matching input interface and the matching output interface and controlling circuit etc. for example, bits is a kind of timing equipment, which is used to control the timing of some functions
本文論及的「時鐘」概念不是指日常生活中使用的鐘表，而是由產生基準頻率的信號發生器（如銫原子頻率標準、銣鐘及高精度石英晶體振蕩器等）中的某種頻率源以及相配套的輸入、輸出介面和控制電路等組成的一整套具有特定同步定時功能的綜合體。如bits就是一種時鐘設備，它提供用在通信系統中控制某些功能的定時的時間基準設備，時鐘提供的信號稱為基準信號、定時信號或同步信號。 -
Standards of digital tv broadcast has specified transmitting systems which are based on various medium such as satellite - oriented transmitting system ( dvb - s ), cable - oriented transmitting system ( dvb - c ), terrestrial - oriented transmitting system ( dvb - t ). different system adopts different methods of channel codec, modulation and demodulation, but for signal source block codec, only mpeg - 2 standard has been applied for all the systems. as a compression standard being specified in digital tv broadcast transmission, mpeg - 2 has been widely involved on compression occasion
對于數字電視信號的傳輸，數字電視廣播標準制定出基於多種媒質傳輸的傳輸系統，如衛星傳輸系統（ dvb - s ） ，電纜電視傳輸系統（ dvb - c ） ，地面廣播（ dvb - t ） ，不同的傳輸系統制定不同的通道編碼和調制解調的方法，但是對于所有傳輸系統的信源編碼則一律採用mpeg - 2這一標準。 -
The circui t construct ion and the relevan t schemes of the realization of the circuit are also provided, simultaneously, the source of errors and the compensation methods are discussed. all of analysises, calculation results and simulations demonstrate that the methods presented in the paper are feasible, the algorithm is effective, the realization of circuit is simple, the procedures of the design are standard, the circuit is easy to be fabricated on a monolithic, and the system can be used for processing middle - high frequence signal and be applied in low - voltage, low - power and at high speed
在此基礎上，本文首次提出了一種基於狀態空間對數域濾波器的一維連續小波變換實現方法、結構以及相關模塊電路實現的策略，並對該方法的誤差來源與補償措施進行了討論。論文中的理論分析與計算以及模擬結果表明，用對數域狀態空間濾波器實現一維連續小波變換的方法可行，演算法簡單、有效，電路實現簡單，設汁過程規整，易於單片集成，適合處理中、高頻信號並運用於低電壓、低功耗、高速的場合。 -
Secondly, basing on the theory of on - off gain of small signal, the raman gain coefficient for frequency shift between 0. 5 and 20 thz of standard sigle mode optical fiber is measured by pump - probe method through a super luminescent diode ( sld ) as a broadband small signal probe source. thirdly, numerical simulation analysis of gain characteristic of raman fiber amplifier for c band wdm signal light is made according to the raman gain coefficient of the fiber measured before through target and four rank runge - kutta method. at the invariability of wavelength and maximum power of each of two pumps, schematic of powers of two pumps for best flatness on c band wdm optical gain was found out, at the same time, the factors of resulting in gain saturation is analyzed, too
本文首先應用經典的電磁理論對拉曼光纖放大器的工作機制進行了分析，然後，根據小信號理論推導出的開關增益求出了光纖拉曼增益系數的表達式，採用泵浦-探測波的方法，利用超輻射激光二極體（ superluminescentdiode簡稱sld ）作為探測光源，測量了所用標準單模光纖頻移為0 . 5 - 20thz的拉曼增益系數，之後根據所測得的光纖的拉曼增益系數譜對應用該類光纖構成的放大c波段wdm光信號的拉曼光纖放大器的增益特性採用打靶法和四階龍格- - -庫塔進行了數值計算，在給定了兩個泵浦光源的波長和最大功率后，找出了反向泵浦情況下使c波段wdm光源增益最平坦的兩個泵浦的各自最佳功率，同時也分析了導致信號光飽和的原因。
分享友人