static error 中文意思是什麼
static error
解釋
靜態錯誤-
Finally, the controller working based on the combination of rbf neural networks and traditional pid control was applied to in aclinic kinetic machinery and lifting machinery of tower crane. the simulation of this controller was made using matlab, and the simulation results showed that the control system has some merits, such as quick response, little overshoot, well anti - jamming capacity, and little steady - state error, etc. both the dynamic property and static characteristic of this controller are better than traditional pid controller, and meet the tower crane
應用matlab對塔機的變幅和起升機構的運動控制進行模擬，模擬結果表明基於rbf神經網路整定pid的控制系統具有響應快、超調小及穩態誤差小等優點，其動、靜態性能優于單一pid控制，從而提高了塔式起重機工作機構的工作性能。 -
Its static error is categorized into three types : irrelative with the specific force, relative with the first - order of specific force and relative with the square of specific force
把漂移誤差分為與比力無關、與一次方成比例和與二次方成比例三類。 -
And so on, the mathematical model and transfer function of the tracking system are built, and the feasibility of the tracking control system design is demonstrated. furthermore, the static error of the system with a unit incline input is deduced. a majority of model of unit is based on analytics, so the general model can apply to other optical intersatellite communications systems
在此基礎上，將atp跟蹤控制子系統視為線性定常系統，通過解析法和實驗法對子系統的各個控制環節的單元器件進行合理建模，得出整個環路總的開環及閉環傳遞函數，論證了本課題所設計的atp跟蹤控制環路的可行性及其視軸輸入為斜坡信號時的理論穩態誤差。 -
The paper explains the control force with the center of performance index. the static error is an important index of the control system
穩態誤差是控制系統一個很重要的性能指標，在九點控制器中k _ 0是穩態時的控製作用。 -
The results of experiment show that the maximum overshoot and static error of dynamic output of fuzzy control system are more less than that of pid control system, and it also has good robustness and stability
實驗結果表明，模糊控制器動態輸出的超調量和靜態誤差均比傳統pid小，並且控制系統具有良好的穩定性。 -
Taking the spherical - wrist of robot ' s end as the target of study, a kind of static error analysis method of spherical - wrist expressed by relative posture errors has been put forward
以機器人末端的球腕為研究對象，提出了一種用相對位姿誤差表示球腕的靜態誤差分析方法。 -
In the fuzzy control method, a pi fuzzy control with nested control table is studied. experimental results show that the static error and the oscillation can be reduced
在模糊控制研究中，提出採用pi型及模糊控製表嵌套控制方法，基本上消除了常規模糊控制存在的靜差和振蕩現象。 -
So it not only achieves the real - time feedback and the regulation of speed but also eliminate the static error of speed due to the integral action of pi regulator when the system is in a steady state
這樣不僅可以做到速度的實時反饋和調整，而且由於pi調節器的積分作用，可以使系統在穩態時做到速度無靜差。 -
Finally, the simulations of regulation control and trace control are carried out respectively. the simulations illustrate that the fuzzy autopilot control system has good control effect and fast response and small static error, if the parameters are adjusted properly
對于調節控制和跟蹤控制，自動舵的控制效果和系統響應進行了模擬研究，其結果表明，在初始均衡好的情形下，模糊控制器控制參數如果調整合適，模糊控制自動舵有較好的控制效果，響應較快，靜差比較小。 -
In nine - points controller control system, it utilizes k _ ( 0 ) control force achieving the static error requirement. the condition of ko = 0 could fit the second order in most control environments
對于模型不明確的系統，我們可以同意設置k0 = 0 ，利用此時的k _ 3控製作用，把穩態誤差限制在誤差零帶的范圍內。 -
Moreover, we put forward many schemes to erase errors such as static error, dynamic error, or make them little. especially we dicuss how to deal with the phase - shifting cell ( pzt ) and interferogram. in the end we bring forward two methods to estimate the contour of piano : one is traditional parameter, the other is power spectral density ( psd )
提出從兩方面對面形進行評價，一是用傳統光學像質評價指標，二是利用psd從頻譜角度評價面形，從而為高精度檢測和控制大口徑光學元件表面面形（波前）提供了依據。 -
In this thesis, i built the mathematical model of 2r robot firstly, and designed the robot follow track pid control system. it could eliminate effectively the system static error
文中首先建立了兩關節機器人的數學模型，並構造了機器人軌跡跟蹤的pid控制系統，它能有效的消除系統的穩態誤差。 -
Because of high stability, the voltage loop gain is set high, so the static error is very small and dynamic performance is enhanced
由於內環的高度穩定性，所以電壓環的增益可做得很高，使系統的靜態誤差非常小且動態性能得到了提高。 -
To ensure the high precision of the on - line measuring system, the static error and the dynamic capability of the whole system must be good enough
要實現高精度在線檢測，首先要保證有足夠高的靜態精度，然後在此基礎上，保證其動態特性能滿足在線檢測的要求。 -
The meassure to reduce the static error when manufacturing axial parts on a hydralic profiling tool slide is deduced in theory with positive feedback adjusting method
本文應用順饋校正的方法，從理論上導出了在車床上用液壓仿形刀架加工軸類零件減小穩態誤差的措施。 -
Then a fuzzy control system is designed on the basis of the characteristic of boiler, though the dynamic quality is improved, there is static error
在此基礎上結合鍋爐對象的特點設計了水位控制的模糊控制系統，雖然系統動態品質得到明顯改善，然而系統存在穩態誤差。 -
After the system is demarcatted, its performance is as follows : the stress resolution is 99pa ; the range of measure is 24kpa ; the static error is less than 2 % ; 4
對實時採集系統進行定標后，發現系統的應力分辨力為99pa ，量程為24kpa ，靜態誤差小於2 % ，重復性好，穩定性好。 -
Abstract : the meassure to reduce the static error when manufacturing axial parts on a hydralic profiling tool slide is deduced in theory with positive feedback adjusting method
文摘:本文應用順饋校正的方法，從理論上導出了在車床上用液壓仿形刀架加工軸類零件減小穩態誤差的措施。 -
At the same time, the principle which taking searching motor maximum - speed point as control object for mppt ( maximum power point tracking ) is put forward and the static error of tracking is analyzed in detail. chip jl3, a kind of micro - controllers of 68hc08 series, is used as control unit of the system, with which we complete the designs of the periphery hardware circuit and the control software
對于電機控制，提出了採用虛擬中心點的方法代替傳感器實現電機轉子位置檢測，以完成電機準確換相，並在理論上證明了其正確性；對于光伏陣列工作點最大功率跟蹤問題，提出了一種以尋求轉速最大點為控制目標實現tmppt的思想，並進行了穩態跟蹤誤差分析。 -
The paper regards the middle hollow electrohydraulic servomotor as studying object and build the mathematical model, the stability and the frequency response of opened - loop and closed - loop system are analyzed. this paper discusses the influences of steady error and static error on system precision in detail
文章以中空電液伺服馬達為研究對象，建立了電液位置伺服系統數學模型，分析了系統的穩定性、開環和閉環的頻率特性，詳細探討了系統的穩態誤差和靜態誤差對系統精度的影響。
分享友人