static members 中文意思是什麼
static members
解釋
靜態成員-
Based on extensive investigation of construction technique history of chinese ancient buildings, the structure method, structure developing history and seismic behavior of chinese ancient timber structure buildings are analyzed in several respects of the structural system and form. through a series of experiments on constituent parts of chinese ancient timber building structure, including the tests on the corbels and brackets called dougong subjected to low cyclic reversed loadings, the tests on the wooden frame using the tenon - mortise joints as connections of column and beam subjected to low cyclic reversed loadings, the tests on vibration isolation effect of friction and slippage between column footing and their socle base, and a series of shaking table tests on a chinese ancient timber structure palace building mode under artificial earthquake at serving conditions, destroyed conditions and reinforced conditions, many valuable results of structures such as moment - curvature hysteretic loops of dougong structure and tenon - mortise joints under low cyckc reversed loadings, the static function, the seismic performance, energy dissipation, vibration reduction, energy - loss mechanism, nechanicalmode and failure mode were studied. aplenty of valuable parameters of the structure system were obtained, such as the natural period of structure, vibration modes, damping ratio, factor of vibration isolation, oscillate amplitude of ineitial accebration, velocity and displacement, magnitude of slippage, and the mechanism of structure failure and collapse etc. based on these research, the complete analysis of ancient timber structure under earthquake were carried out in which including mechanism analysis method, calculating mode, strength analysis of members and joints, strengthening methods for serving damaged ancient timber structure buildings were also taken into account
依照宋代《營造法式》建造了抬梁式殿堂木結構構件及結構模型，對中國古代木結構中的典型構造如：柱腳在礎石頂面平擱簡支、柱架榫卯連接、柱高不越間之廣、側腳、生起、斗拱等的構造機理及結構功能進行了量化分析和實驗研究： （一）通過木柱石礎靜摩擦試驗，測定了柱腳與石礎古鏡面間的摩擦系數及摩擦力隨上部結構荷載變化的規律； （二）通過單柱承載力試驗，測定了古建築中木柱的受力變形特徵、破壞模式、及模型材料的變形模量、極限承載力、極限變形等參量； （三）通過柱架低周反復荷載試驗，測定了柱架的抗側移剛度、柱架恢復力特性及滯回曲線、榫卯張角剛度及其變化規律、柱架及榫卯的極限承載力和極限變形、及榫卯減振參數； （四）通過斗?低周反復荷載試驗和受壓試驗，測定了古建築木構件與木構件間摩擦系數，斗?抗側移剛度，斗?恢復力特性及滯回曲線，斗?抗壓極限承載力及受力變形規律； （五）通過抬梁式殿堂間架模型振動臺試驗，測定了殿堂木構架結構自振周期，地震反應振形、阻尼特性及阻尼比；按結構分層特點對柱腳、柱頭和斗?層上的屋蓋的地震反應採用多點同步測量，對柱根滑移、榫卯變形、斗?的變形、復位、耗能減振參數等進行了定量分析。 -
Static and dynamic behavior of three - span continuous prestressed concrete rigid framed arch bridges without spandrel members
三跨連續無腹桿預應力混凝土剛架拱橋的靜動力特性 -
Enclosing type parameters should not be referred to inside static members
不應在靜態成員中引用封閉類型參數。 -
Initialize static class members with static constructors
使用靜態構造器初始化靜態類成員。 -
The main work of this paper was as fellows : ( 1 ) generalized the development of pre - stressed steel structure in our nation and abroad, and pointed out the main problem in practice ; ( 2 ) presented the mechanism of pre - stressed steel structure and revealed its applicable range ; ( 3 ) established the optimization design model for pre - stressed steel structure, which accounts for constraints on stresses and displacements of structure ; ( 4 ) brought forward the optimization design method, which combined linear programming and the principle of full restriction, through which we can obtain the magnitude of each time pre - stress and the optimized sections of each members of structure ; ( 5 ) analyzed the best times of pre - stress and pointed out that 2 ~ 3 times is preferable ; ( 6 ) conducted optimization design on large - space steel roof, horizontal parallel steel truss with local cables, horizontal parallel steel truss with global cable, and ultra - static steel truss, the result of which indicated that the multiple pre - stress structure is very economic ; ( 7 ) compared different schemes of cable placement for horizontal parallel steel truss, and the results showed that the local cable only unloaded the second girders, but had no response on the first girders and stomach poles, while global cable could unload the second girders and the stomach poles outside of turning point of cable, thus proving that global cable is more economic than local - cable
本文的主要工作是：對國內外預應力鋼結構的發展歷史及現狀作了綜述和總結，指出當前預應力鋼結構工程實踐中存在的主要問題；闡述了預應力鋼結構的受力機理，並指出預應力鋼結構的適用范圍和特點；在考慮結構應力和變位約束的條件下，建立預應力鋼結構優化設計模型；提出多次預應力鋼結構優化設計方法和步驟，採用線性規劃和滿約束準則相結合的優化方法，可優化設計出施加的每一級預應力的大小，並得到結構各部分的優化截面；對多次預應力最佳的施加次數作了分析，並建議以2 3次為宜；為驗證文中理論和方法，分別對大跨多次預應力鋼屋架、局部布索的水平平行弦鋼桁架、整體布索的水平平行弦鋼桁架和局部布索的超靜定鋼桁架等算例進行了優化設計，經濟效益明顯；對水平平行弦鋼桁架的幾種施加預應力的方案進行比較，對于局部布索，預應力只對下弦起到卸載作用，對上弦和腹桿基本不起作用；而整體布索預應力除對下弦卸載外，對索折點以外部分腹桿也起到卸載作用，經濟效益好於局部布索。 -
Lognitudinal and transversal members of grillage, regarded as cuved - beam element and straight - beam element, are analyzed by finite element method, and the module for grillage static analysis is formed, by using table of information of nodal point restraint to assemble stiffness matrix for structure in restraint
將梁格縱橫構件分別按曲梁和直梁兩種單元進行有限元分析，引入結點約束信息表進行約束結構剛度矩陣的組集，形成了曲桿梁格靜力分析模塊。 -
Static members in inherited classes are not included
靜態成員；不包括繼承類中的 -
Those static data members have the same lifetime as the jsp server container
那些靜態數據成員具有與jsp服務器容器相同的生命期。 -
To include static members up the hierarchy
Bindingflags . flattenhierarchy可包含層次結構上的靜態成員。 -
Ltd founded in 1999, is a new high technology enterprise, specialized in researching, developing, manufacturing and selling of elevator weight - load system, elvator ic intelligent management system and the like of elevator dynamic static state data record management system and the like of elevator fittings. there are more than 100 experienced staff members including r d perpons, engineers and adminstrators who do their utmost to offer prompt, efficientand overall services for customers. our company manufactures six kinds of productions that hold autonomous. our company manufactures six kinds of production that hold autonomous intellectual property rights and has established long - term friendly cooperation with over one hundred ecactly elevator manufacturtures in china and abroad
秦皇島開發區前景光電技術有限公司成立於一九九九年，是一家專業從事研製開發銷售電梯重量載荷控制系統電梯ic卡智能管理系統電梯遠程自動報警安防管理系統和永磁同步電梯專用變頻器等電梯配件產品的高新技術企業。我公司擁有經驗豐富的科研工程技術管理人員一百余名，竭力為客戶提供迅速優質全面的服務。公司生產擁有自主知識產權的九項專利產品，並與百余家整梯生產企業建立了長期的友好合作關系。 -
Static members are often used to represent data or calculations that do not change in response to object state ; for instance, a math library might contain static methods for calculating sine and cosine
靜態成員通常用於表示不會隨對象狀態而變化的數據或計算；例如，數學庫可能包含用於計算正弦和餘弦的靜態方法。 -
The class list is used only by instance - based members, not static members
該類列表僅適用於基於實例的成員，而不適用於靜態成員。 -
Classes definitions can now include static members ( properties ), accessible via the class. common usage of static members is in the singleton pattern
類定義現在包含了靜態成員（屬性）的定義，並通過類訪問它們。通常靜態成員用於單獨的部分。 -
Do not specify static members in the classes list
不要在「類」列表中指定靜態成員。 -
Creating a static class is therefore much the same as creating a class that contains only static members and a private constructor
因此創建靜態類與創建僅包含靜態成員和私有構造函數的類大致一樣。 -
It is commonly used in classes that contain static members only
它通常用在只包含靜態成員的類中。 -
Class contains static members to assist in manipulating absolute and relative path strings, whereas the
類包含能輔助操作絕對和相對路徑字元串的靜態成員，而 -
Indicating that it contains only static members
的，以指示它僅包含靜態成員。 -
Class has static members to obtain certain paths, such as
類具有獲取某些路徑的靜態成員，如 -
Object by accessing its static members to display information about the
對象的靜態成員來顯示關于
分享友人