static table 中文意思是什麼

static table 解釋
靜態表
  • static : adj 1 靜止的,靜態的,靜力的。2 【物理學】天電的,靜電的。3 【無線電】靜態特性。4 固定的,不活潑...
  • table : n 1 桌子;飯桌,餐臺。2 手術臺;工作臺;游戲臺;賭臺;寫字臺。3 (飯桌上的)食物,酒菜,伙食;一...
  1. Below the water table at static equilibrium, hydrostatic pressure potential increases with increasing depth.

    當靜態平衡時,在水面以下,靜水壓力隨深度而增加。
  2. Its leading products for static and dynamic electronic truck scale short table, electronic ground value, electronic platform scales, electronic truck scale load meter, portable weighing device, bending plate sensor, pre - gauge high - speed detection, highway overweight detection system, weight fees and anti - cheating weighing system and so on

    營業執照其主導產品為靜動態短臺面電子汽車衡、電子地上衡、電子臺秤、電子汽車衡地磅,便攜式稱重儀,彎板式傳感器,高速預檢超限檢測,計重收費,防作弊稱重系統等。
  3. See standard range table for wide plus al series static liquid - level transmitter option gives an example

    見wideplus - al系列靜壓液位變送器標準量程表
  4. Based on extensive investigation of construction technique history of chinese ancient buildings, the structure method, structure developing history and seismic behavior of chinese ancient timber structure buildings are analyzed in several respects of the structural system and form. through a series of experiments on constituent parts of chinese ancient timber building structure, including the tests on the corbels and brackets called dougong subjected to low cyclic reversed loadings, the tests on the wooden frame using the tenon - mortise joints as connections of column and beam subjected to low cyclic reversed loadings, the tests on vibration isolation effect of friction and slippage between column footing and their socle base, and a series of shaking table tests on a chinese ancient timber structure palace building mode under artificial earthquake at serving conditions, destroyed conditions and reinforced conditions, many valuable results of structures such as moment - curvature hysteretic loops of dougong structure and tenon - mortise joints under low cyckc reversed loadings, the static function, the seismic performance, energy dissipation, vibration reduction, energy - loss mechanism, nechanicalmode and failure mode were studied. aplenty of valuable parameters of the structure system were obtained, such as the natural period of structure, vibration modes, damping ratio, factor of vibration isolation, oscillate amplitude of ineitial accebration, velocity and displacement, magnitude of slippage, and the mechanism of structure failure and collapse etc. based on these research, the complete analysis of ancient timber structure under earthquake were carried out in which including mechanism analysis method, calculating mode, strength analysis of members and joints, strengthening methods for serving damaged ancient timber structure buildings were also taken into account

    依照宋代《營造法式》建造了抬梁式殿堂木結構構件及結構模型,對中國古代木結構中的典型構造如:柱腳在礎石頂面平擱簡支、柱架榫卯連接、柱高不越間之廣、側腳、生起、斗拱等的構造機理及結構功能進行了量化分析和實驗研究: (一)通過木柱石礎靜摩擦試驗,測定了柱腳與石礎古鏡面間的摩擦系數及摩擦力隨上部結構荷載變化的規律; (二)通過單柱承載力試驗,測定了古建築中木柱的受力變形特徵、破壞模式、及模型材料的變形模量、極限承載力、極限變形等參量; (三)通過柱架低周反復荷載試驗,測定了柱架的抗側移剛度、柱架恢復力特性及滯回曲線、榫卯張角剛度及其變化規律、柱架及榫卯的極限承載力和極限變形、及榫卯減振參數; (四)通過斗?低周反復荷載試驗和受壓試驗,測定了古建築木構件與木構件間摩擦系數,斗?抗側移剛度,斗?恢復力特性及滯回曲線,斗?抗壓極限承載力及受力變形規律; (五)通過抬梁式殿堂間架模型振動臺試驗,測定了殿堂木構架結構自振周期,地震反應振形、阻尼特性及阻尼比;按結構分層特點對柱腳、柱頭和斗?層上的屋蓋的地震反應採用多點同步測量,對柱根滑移、榫卯變形、斗?的變形、復位、耗能減振參數等進行了定量分析。
  5. The structure of the upper platform on the simulating table that is put forward is analysed with analysis software ansys of finite element. and the mass of subjacent platform for simulating table is calculated with the method of equilibrium of moments under conditions of the simulating table is static or operating no take place overturn

    機械設計方面:設計了模擬轉臺上、下平臺的結構,並運用有限元分析軟體ansys對所提出的模擬轉臺上平臺結構進行分析,利用力矩平衡方法計算了模擬轉臺在靜止以及運動過程中不發生傾覆所需要下平臺的質量。
  6. The water that fills the pores below the water table is not static.

    充填在潛水面以下孔隙中的水不是靜止的。
  7. Base on the data collected from the field investigations, we analyzed the static life table, age structure, spatial distribution patterns of the populations of e. chloranthoides. we further studied the intraspecific competitions within the species and the interspecific competitions between the species and other concomitant species in the communities. with the helps of the logistic equation, leslie ' s matrix and the average moving law method we simulated and estimated the population dynamics of this endangered plant species

    本研究以縉雲衛矛為研究對象,通過對三個種群的野外調查,研究和分析了縉雲衛矛的種群年齡結構、種群空間分佈格局及種內和種間的競爭關系,並利用logistic方程、 leslie矩陣及移動平均法模擬和預測了三個種群的數量和結構動態,在此基礎上分析了造成縉雲衛矛瀕危的原因,提出了相應的保護措施,旨在為縉雲衛矛的保護提供理論依據。
  8. Design of control system of static inclining test table

    靜態傾斜試驗臺控制系統設計
  9. Based on the pull - out tests data between geogrids and expansive soil / sands arranged by the orthogonal table l9 ( 34 ), the following conclusions are reached : 1 ) the displacement - properties of pullout tests depend on the pullout speed. the law of factors " affecting degree, which influences the parameters between geogrids and soils in the pulling - out procedure, is obtained. with the concept of " equivalent pull - out displacement ( x ) " brought forward, the whole process of pull out tests is divided into two process - " main process ( when x 1. 0 ) " and " residual process ( when x 1. 0 ) ", and three stages - static friction resistance stage, slip friction resistance stage, and residual friction resistance stage

    基於正交設計表l9 ( 3 ~ 4 )分別安排了影響因素與土工格柵膨脹土或砂土界面相互作用參數的拉拔試驗數據,獲悉: 1 )拉拔試驗位移特性主要取決于影響因素中拉拔速率;通過分析並獲取影響因素對筋土界面相互作用參數的影響程度及其在拉拔試驗過程中的變化規律,提出了當量拉拔位移( x )的概念,並據此將拉拔試驗全過程劃分成「主過程( x 1 . 0 ) 」和「殘余過程( x 1 . 0 ) 」 ;且將影響因素對拉拔力或摩擦阻力系數的影響程度分成三階段(靜摩擦阻力階段、滑動摩擦阻力階段,殘余摩擦阻力階段) ; 2 )不同(規范)定義的筋土界面摩擦阻力系數數值相差較大,但影響因素對摩擦阻力系數影響程度及其變化規律不會因不同(規范)定義而受到影響。
  10. In this paper, on the basis of the numerical analysis with the concept of equivalent soil mass with reinforcement and shake table model test, the calculation of high loess embankment with geogrid - reinforcement in highway is carried out under static loading, and the dynamic response of high reinforced sand - gravel embankment with grogrid - reinforcement in highway is tested under earthquake. the behaviors of loess embankment are indicated as the following : ? he stress and deformation varies with reinforcement design conditions and foundation types

    本文通過將土工合成材料與土體視為加筋等效土體的數值計算方法和振動臺模型試驗,以加筋黃土高路堤和豎直擋板加筋砂礫土高路堤為研究對象,計算分析了不同堤基上不同加筋設計條件下黃土高路堤的靜應力及變形變化規律,試驗研究了不同加筋條件下砂礫土高路堤的動力反應特性。
  11. Then the author experimented them. from the simulate and experiment i can see, the static precision of three - axes of testing table can reach the request, the controlling maneuver which the

    對常用測試方法和工作原理進行分析,確定用光學自準直儀測試轉臺回轉精度和軸系垂直度的測試方法,並進行實際測試,完成數據的處理和精度分析。
  12. Unlike a table, which has a static set of columns, matrix columns can be dynamic

    與包括一組靜態列的表不同的是,矩陣列可以是動態的。
  13. By analyzing the recorded datum in the working place, the static table is regulated. the dynamic table is regulated by a fuzzy system in which the coupling factors are already fully considered

    其次對于靜態部分通過充分利用現場記錄的數據對其進行調整,動態部分利用已充分考慮耦合因素的模糊推理系統調整。
  14. The relevant transactions include data sampling, graph display, saving, alarm, and default handling, etc. the scheduling scheme in rtdbs adopts the static table - driven scheduling assisted with the other scheduling to meet the need of timing limitation of real - time affair

    相關的事務主要是數據採集事務、圖形顯示事務、存盤事務、報警事務、事故處理事務等。實時數據庫的調度策略根據組態軟體通訊特點採用靜態表驅動為主其他調度策略為輔的調度方案。
  15. In addition, the dissertation accomplishes work as follows : the basic configuration functions for flow chart is replenished and perfected based on the former this configuration software collectivity frame designs, and the application of static table - driven scheduling. accordingly, the development of this configuration software is impelled in the field of opening, integration, network availability, module structure, standardization of communication interface

    除此以外,本文還完成以下工作:在原有組態軟體總體框架基礎上,補充和完善了流程圖的基本組態功能,並對靜態表驅動在實時數據庫調度中的應用作了初步的探討,從而推動我們的組態軟體在開放化、集成化、網路化、組件化、通訊介面標準化等方面進一步發展。
  16. So a static table in shared memory is used

    ,因此將使用共享內存中的一個靜態表。
  17. To create a static table, you can add rows and cells at design time

    若要創建靜態表,可以在設計時添加行和單元格。
  18. You can add rows and columns at design time to create a static table, or you can add them at run time in code

    您可以在設計時添加行和列來創建靜態表,也可以在運行時從代碼中添加行和列。
  19. In general, if you are creating a static table one in which you will not add or change content at run time, it is better to use an html table element in place of a

    通常,如果創建的是靜態表(運行時不添加或更改內容) ,則最好使用html表元素,而不使用
  20. For the load control of the thermal power unit, the mapping table is firstly departed two parts : the static table and the dynamic table

    對於火電單元機組負荷控制這一類mimo耦合對象,首先將映射表分為靜態和動態兩部分。
分享友人