stator blade 中文意思是什麼

stator blade 解釋
定子葉片
  • stator : n. 【電學】（固）定子；【航空】導向葉片壓氣機。
  • blade : n 1 （殼、草等的）葉片，葉身，葉。2 刀片；（安全）剃刀刀片 （＝ razor blade）; 刀口，刃；刀，劍；...
  1. 4 ) in a pre - swirl rotator - stator cavities with discrete pre - swirl nozzles and blade - cooling entry holes, the influences of pre - swirl angle and flow parameter on the flow and heat transfer characteristics were numerically investigated. the correlation for average nusselt number vs rotating reynold number or non - dimensional mass flowrate were established. the results show that : advantage of per - swirl inflow is the effect of cooling the blade - cooling entry holes ; pre - swirl inflow increases heat transfer in rotating disk of pre - swirl chamber ; as pre - swirl angle increases, local nusselt number decreases in pre - swirl chamber ; the temperature of stator of inner rotator - stator chamber and per - swirl chamber decreases as rotating reynold number increases ; when the axial mass flowrate maintains constant, heat transfer in the rotating disk of inner rotator - stator cavities does n ' t change as per - swirl mass flowrate increases, while heat transfer in the rotating disk of per - swirl chamber increases ; when the pre - swirl mass flowrate maintains constant, change of the axial mass flowrate has effect on the whole cavity

    結果表明，預旋進氣的優點在於增強了葉片冷卻孔附近的對流換熱效果，局部努謝爾數隨預旋角的增大而有所減小；隨旋轉雷諾數的增加，不論是內轉靜腔室還是預旋腔室的靜盤上的溫度都不同程度的降低：當軸向中心進氣質量流量不變時，隨預旋進氣的質量流量增加，內轉靜腔室的轉盤盤面上的換熱基本沒有變化，而預旋腔室的轉盤盤面上的換熱效果增強；當預旋進氣質量流量不變時，軸向中心進氣的質量流量的改變對整個盤腔都有影響。
  2. In order to investigate the unsteady flow frequency domain performances of an axial flow compressor at different mass flow, rotating speed and blade row spacing, plus inlet flow distortion, and considering aerodynamic characteristics and stability of the compressor, the low speed research compressor ( lsc ) at college of energy and power in nuaa is used to carry out the experiment studies. a large amount of test data has been gained through dynamic pressure transducers embedded in the stator blades at the tip, middle and hub section, then fast fourier transform algorithm ( fft ) is applied to calculate the frequency data

    為探討軸流壓氣機在工作流量、工作轉速及動?靜葉排軸向間距變化時的葉片排流場非定常頻譜特性變化規律，並耦合進氣畸變的影響，同時與壓氣機氣動性能和氣動穩定性相關聯，作者利用南京航空航天大學能源與動力學院的低速大尺寸軸流壓氣機（ lsc ）試驗器，採取在靜子葉片表面埋入動態壓力傳感器的實驗方法，對葉尖、葉中和葉根三個截面的動態壓力進行了測量，獲得了大量的可靠的實驗數據。
  3. Above all, the surface of the gas turbine blade including stator and rotor heat transfer coeficience with no film cooling hole was studied with the main stream reynolds number of 150000, 200000 50000, 300000, 350000, 400000. then, the heat transfer coefficience when all cooling holes opened and only one cooling hole opened was studied partly. and it ' s studied how the mainstream reynolds number, blowing ratio and the position of holes affect the heat transfer coefficience of the surface of blade

    對導葉和動葉，都是先研究了在150000 ， 200000 ， 250000 ， 300000 ， 350000 ， 400000雷諾數下，沒有氣膜冷卻時的表面換熱系數分佈，然後研究了氣膜孔全打開和只打開單排孔時的表面換熱系數分佈曲線，重點研究來流雷諾數，吹風比和不同孔位出流對換熱系數分佈的影響規律。
  4. Variable stator blade

    可轉靜葉
  5. The compressor exists about 0. 265 rotor blade converted frequency near stall point, its intensity increases with rising of rotating speed and reducing blade row spacing. the blade row spacing would exert influences on rotor - stator interaction, stability and stall mode

    在臨近失速點處，不同工作轉速、不同動?靜葉排軸向間距均存在約為0 . 265轉子葉片摺合頻率的特徵頻率擾動，強度隨轉速的上升和軸向間距的減少而增大。
  6. The outlet flowfield and static pressure on blade surfaces of the classical turbine stator cascades with straight and - 10 、 - 20 bowed blades were measured in the linear cascade wind tunnel

    摘要在平面透平葉柵風洞中，測量了一種典型透平靜葉型直葉片葉柵和葉片彎曲角分別為- 10 、 - 20的反彎曲葉片葉柵的出口流場和葉片表面靜壓。
  7. In order to eliminate the brittle fracture of the stator blade, using the orthogonal experiment, the brittle problem of the stator blade was studied

    為了消除靜葉片的脆性斷裂，採用正交試驗對脆性問題進行了研究。
  8. The flow characteristics of rotor - stator cavity system with blade - cooling flow and disk - cooling flow was experimentally studied

    摘要採用實驗方法，對具有中心進氣、兩個出口的盤腔系統的流動特性進行了研究。
  9. The results show that the corrdlation between the alloy component and the process parameters has notable influence on the brittle of the stator blade

    結果表明，合金含量及工藝參數的交互作用對葉片脆性影響顯著。
  10. Film cooling of the surface of a gas turbine blade was studied in a large - scale low - speed opening wind tunnel according to actual requirement of the design of aero - engine. the surface of a gas turbine blade was cooled by cylindrical holes in the experiment, with the hole number of fifteen in stator and eight in rotor

    應航空發動機設計的要求，在大尺寸低速葉柵傳熱風洞中分別對發動機渦輪導向葉片和動葉表面的氣膜冷卻特性進行了研究，具體研究在不同氣膜孔出流時，在不同主流雷諾數和吹風比情況下葉片表面局部換熱系數的分佈規律。
分享友人
分享到 Line

分享到臉書