steady mass transfer 中文意思是什麼
steady mass transfer
解釋
定常質量轉移-
The quasi - steady two - dimension model of brick - drying is established by the analysis of heat and mass transfer of brick - drying
摘要通過對磚坯乾燥傳熱傳質過程的分析，建立了磚坯乾燥的準穩態二維數學模型。 -
According to the theory of engineering thermodynamics and phase change, heat - transfer process of the special working fluid heat - pipe stove is analyzed. some hypotheses are postulated and with the help of equation of mass - conservation, energy - conservation, the dynamic concentrative parameter model is built, the change of each parameter is prescribed at any stage from starting to stopping. with the thermodynamic calculation of burnable process, the parameter of device, such as heat - transfer coefficient / thermal efficiency etc, are achieved under steady state ; based on theoretic calculation, observing the actual running circumstance of the heating stove in person, with some performance comparison between the new and the old, the high efficiency and reliability of heat - pipe stove is proved, the project which expend it in the oil - filed is feasible
對充入該工質的熱管加熱爐，本文根據工程熱力學和相變傳熱學及相關知識，對其進行了傳熱分析，經過適當假設，運用質量守恆和能量守恆定律，建立了裝置動態集中參數模型，描述了加熱爐從開機到穩定運行這一動態過程各參數的變化情況，同時對燃燒過程也進行了熱力計算，最終得到了穩態工況下裝置的換熱系數、熱效率等熱力參數；在理論計算的基礎上，親赴現場觀察該爐的實際運行情況，通過與原有的加熱爐的各項性能進行對比，最終證明新爐的高效性和可靠性，為其在油田中推廣的可行性提供了依據。 -
Compared to heat transfer in the external region of borehole, mass and heat capacity of materials inside the borehole are insignificant and negligible. thus, heat transfer inside the borehole is approximated as steady - state heat transfer except for analyses of short times ( a few hours )
與鉆孔周圍區域傳熱過程相比，由於鉆孔內材料的熱容量較小，因此除了討論短時間（數小時）的瞬變傳熱問題以外，可以忽略鉆孔內材料的熱容量，把該部分的傳熱近似作為穩態傳熱處理。 -
4 were calculated in curved tube with permeable arterial wall and effects of parameters, such as shear stress, mass flux of arterial wall, on mass transfer were studied. it was found that steady laminar flow become unsteady with the increase of de. the concentration in inner section of transverse section of the tube is higher than other areas, and with the increase of de and pe, the concentration there increase obviously. it indicates that for the permeable arterial wall, the macromolecules are likely to gather in the areas where axial velocity and shear stress are relatively low, thus indicates why location of atherosclerosis frequently occurs at inner side of curved tube
4 ，在可滲透邊界條件下彎曲血管內的濃度場分佈，並分析了諸如壁面剪應力及跨壁流量等參數對傳質的影響。計算表明隨著dean數的增加，定常層流開始失穩。血管截面內側區是濃度分佈較高區域，並且隨著dean數和peclet數的增加，內側區濃度明顯增大。
分享友人