steady running condition 中文意思是什麼
steady running condition
解釋
穩定運轉工況-
Second, the starting and stopping behaviors under disturbed condition are analyzed and calculated by using the dynamic concentrative parameter model, which gives some advice to better prescribe refrigeration system and set theoretic foundation for carrying out automatic control of refrigeration system. third, the normal running process is analyzed and calculated by means of rational matching theory, which gives some advice on how to better understand the parameter change under steady state and the affection of inlet - parameter on evaporator. fourth, the simulation software with dynamic characteristic is designed, which can be applied to calculate thernio - parameter of cryogen, air humidity and frost thickness under different initial and boundary conditions, and to carry out dynamic simulation under conditions of dryness, wetness and frostiness, at the same time, to achieve detection and simulation at any stage from starting to stopping
本文的主要內容如下： 1 ）對翅片管蒸發器結構特點進行分析，選取適當的微元控制體，就干、濕和霜工況下對每個微元分別進行傳熱傳質分析，基於經驗關系式確定霜的有關參數，對于霜工況下的霜生長建立模型，經適當假設，運用質量守恆、能量守恆和動量守恆方程建立適合動態模擬的蒸發器數學模型，為系統模擬奠定基礎； 2 ）對蒸發在大擾動下的開、停機過程，運用動態集中參數模型進行分析和計算，為更好地描述製冷系統運行的全過程奠定基礎，同時也為製冷系統實現自動控制提供一定的理論基礎； 3 ）對蒸發器正常運行過程，運用動態分佈參數和參數間定量耦合的觀點來分析和計算，為更好地了解穩態工況下各點參數的變化情況及各入口參數對蒸發器動態特性的影響即蒸發器性能對各參數變化的敏感性； 4 ）編寫翅片管蒸發器動態特性模擬計算程序，可以計算不同邊界條件和初始條件下的製冷劑熱力參數、空氣溫濕度和霜厚度分佈場，實現對翅片管蒸發器在干、濕和霜工況下的動態模擬。 -
The simulation methods and content about the mesh generation, the boundary condition of rotating wheels and moving ground of single car, and about the steady study on the two car running in row and overtaking process has shown the calculation results reliability and the numerical simulation methods feasibility. based on the comparison and analysis of mesh strategy, the descartes mesh strategy and the tetrahedron + prism mesh strategy are chosen. the continuous unsteady overtaking process of the vehicles, traveling with constant but unequal speed is replaced by a finite numerber of steps ; in each the relative position of both vehicles changes
最後利用滑動交接面技術和動網格技術進行了瞬態的轎車超過某國產大型運輸車的數值模擬研究，在此之前國內外對此項技術均未有系統的研究和可借鑒的結論，以側向間距0 . 5倍轎車車寬為典型，用定性和定量兩種方法對比分析了超車過程中的轎車和運輸車與其單車情況及前文穩態模擬的異同，並將六種側向間距的瞬態結果與單車情況和穩態模擬結果進行了對比分析。
分享友人