steam cooling 中文意思是什麼

steam cooling 解釋
蒸汽冷卻（法）。

  • steam : n 1 蒸汽，水蒸氣，水氣，霧，蒸氣壓力。2 〈口語〉精神，精力，氣力；怒氣。3 輪船，乘輪船旅行。vi 1 ...
  • cooling : n. ,adj. 冷卻（的）。
  1. As to simple turbine, steam discards directly into atmosphere, or into condensator for cooling, then goes back to boiler for use

    在簡單的渦輪機中，蒸汽被排入大氣，或進入冷凝器冷凝成水后流回鍋爐。
  2. The method of concentrating the decoloration solution of tylosin is usually carried out by thin film vacuum concentration. in this experiment, the concentration process is modified by using the nanofiltration membrane technique which is free from corrosive due to the extractant solvent and in the same time, heating and decomposition of the antibiotic are eliminated, the concentration course ia also distinctly shortened. in this process the small molecule can be filtered by water, and the quality of the product such as, the tyramine content, the solubility of the product, improved significantly. in addition, the membrane filtration process could save consumption of steam and cooling water

    泰樂星提煉過程中原工藝脫色液用薄膜真空濃縮，本試驗改進為耐溶媒納濾膜濃縮，料液不需要加熱即可濃縮，防止了料液的高溫分解破壞，濃縮收率明顯提高在濃縮的同時，部分小分子雜質可以隨水分子一起通過納濾膜而除掉，成品質量明顯提高，解決了用原工藝成品酪胺、溶解度不合格的質量問題省去了原工藝濃縮中費用較高的蒸汽、冰鹽水，經濟效益可觀。
  3. According to the question of using natural cooling will prolong the period of opening cylinder for overhaul, we expound three modes for the steam turbine quickly cooled after being stopped, these are vacuum and aeration - cooling, pressure - air cooling and steam 1ing, then analysis and contrast them

    摘要針對汽輪機採用自然冷卻方式會延長機組檢修開缸時間的問題，提出了汽輪機停機后的三種快速冷卻方式：抽真空通汽冷卻法、壓縮空氣強迫冷卻法和蒸汽冷卻法，並對這三種方式進行了比較和分析。
  4. Standing tall on a wide stretch of land, the chimneys and cooling stacks took a break from belching out smoke and steam in the southeast of beijing

    煙囪和冷卻塔高高矗立在廣闊的大地上，在北京的東南方向也暫時看不到煙霧的冒出了。
  5. The contamination phenomenon of condensate water resulting from condenser leakage in operation of condensating steam turbine with open cycle cooling system by sea - water has been presented, the causes leading to condenser leakage being analysed, and leakage searching method as well as leakage preventing method under operation condition being given

    摘要介紹海水開式循環冷卻的凝汽式汽輪機在運行中因凝汽器泄漏導致的凝結水污染現象，分析凝汽器發生泄漏原因，並給出運行狀態下凝汽器的查漏方法及其防泄漏措施。
  6. The article takes a 600mw natural cycle drum boiler ( soot blow using steam ) as investigating object, establishes soot accumulation loss and soot blowing energy loss models for its water cooling wall, superheater, economizer and air preheater respectively, set up instructions for soot blower operating. simulating calculation results are compared with site data to verify usefulness of key models. the article introduced the operation optimizing design of soot blowers of yanzhou no2 power plant based on theoretical research

    本文以600mw汽包自然循環鍋爐（蒸汽吹灰）為具體分析對象，分別建立其水冷壁、過熱器、省煤器、空預器的積灰損失和各受熱面吹灰能量損失的模型，建立相應的吹灰器運行規則指導，對設計中的關鍵模型問題，通過模擬計算及與現場數據作比較的方法，驗證其可用程度。
  7. Mid - range steam applications. throttling and balancing of hydronic heating and cooling systems

    中檔蒸汽應用。熱水供暖和冷卻系統的節流和平衡。
  8. For manufacture water cooling panels, coal - saving devices, reheaters, superheaters and steam pipelines of boilers

    用於鍋爐水冷壁、省煤器、再熱器、過熱器和蒸氣管道的製造。
  9. This paper studies the structure optimization of 300mw unit thermodynamics system, including the drain - back system, the vacuum extractor system, the cooling spray system, the recovered system of the blow down water, and the accessory steam system

    本文從結構上對300mw級火電機組熱力系統進行了優化研究，主要包括：回熱系統、真空抽氣系統、給水噴水減溫系統、排污回收利用系統以及輔助蒸汽系統。
  10. Based on the conclusions that have been admitted, the paper improves the drain - back system optimization theory, studies the different vacuum extractor system, builds a optimum model of the cooling spray system, optimizes the recovered system of the blow down water with a new structure, converts the accessory steam system and proves it in theory

    本文在總結已有研究的成果的基礎上，完善了回熱系統結構優化的理論，研究了不同真空抽氣系統的優劣，建立了噴水減溫系統的優化模型，引入新的結構對排污回收利用系統進行優化，改造了輔助蒸汽系統並從理論上進行證明。
  11. This condensate discharge from the condensers ( feed water ) is pumped back to the steam generator in the nuclear island to be converted into steam again. cooling water for the condensers is taken from the sea via the seawater pumps in the pump house

    從冷凝器流出的凝結水（即給水）會泵回核島內的蒸汽發生器，然後再次轉化為蒸汽。在這過程中，蒸氣會將渦輪發電機作高速轉動（
  12. It is important for the design of air cooling steam turbine and the performance and stability of turbine to study unsteady flow mechanism in design and off - design state

    深入了解透平葉片在設計狀態和高背壓條件下的非定常流動機理，能更好設計空冷汽輪機以及提高葉輪機械的性能和穩定性。
  13. Osbl experience must include several of power generation and distribution, steam generation, instrument / plant air, cooling water, raw water treatment, waste water treatment, fire water, pressure storage, atmospheric storage, flare systems, polymer warehousing, liquid loading / unloading systems

    在osbl上的經驗必須包括幾個電力生產和配送，蒸汽生產，儀表/工廠空氣，冷卻水，原水處理，廢水處理，消防水，壓力存貯，常壓存貯，火炬系統，聚合物儲藏，液體裝卸系統。
  14. Strong air - cooling condensed system can draw out oil steam and water vapor for cooling which avoid inconvenience of water cooling

    強風冷凝系統，使真空抽出的油蒸汽水蒸汽快速降溫冷卻，免除了用水冷卻給用戶帶來的不便。
  15. Concentric jacket pipe surrounded the test condenser. steam was generated in the boiler, flowed upward to the inlet of connection pipes, then flowed downward into the condenser tube, the cooling water flowed countercurrently through the annulus. the experiment covered the range of the pressure 1. 0 ~ 3. 0bar, heating power 2. 0 ~ 15. 0kw, steam mass flow rate 0. 001 ~ 0. 004kg / s, air mass flow rate 0. 0 ~ 0. 00163kg / s, and cooling water temperature 20 - 60 ?

    在系統壓力為0 . 1 0 . 3mpa ，加熱功率為2 15kw ，蒸汽質量流量為0 . 001 0 . 004kg s ，空氣質量流量為0 . 0 0 . 00163kg s ，二次側冷卻水溫度20 60的范圍內，系統研究了豎直下降管內含有空氣的蒸汽冷凝特性，獲得了不同壓力、不同空氣含量和不同加熱功率下，冷凝段的溫度分佈和局部熱流密度的數據。
  16. Apply to such industry as petroleum, chemical industry, textile, metallurgy, electron and atomic energy, etc., is it filter, charge dust, gas not to spread, is it steam take, catalysis reflect, electrolytic, eliminate noise, damping, hinder fire and sweat function of cooling etc. to flow to have

    應用在石油化工紡織冶金電子及原子能等工業中，有過濾收塵氣體擴散流蒸化催化反映電解消聲阻尼阻火及發汗冷卻等作用。
  17. 1 the rolls are made of chilled alloyed cast iron, their working surfaces are of high hardness and wear - resistant. the working temperature of the bored rolls is controllable by steam or cooling water that pass through them thus, to meet the requirements of milling process

    1輥筒用合金冷硬鑄鐵製成工作表面具有較高的硬度，耐磨耐用。輥筒內腔可通如蒸汽或冷卻水以便調節輥筒的工作溫度，以滿足煉膠工藝的要求。
  18. There are several important issues to that attention should be paid in the design of test bed, such as the measurement of the temperature difference between the inlet and outlet of test section and the temperature of cooling water in the inlet and outlet of condensing tubes, filled volume of the steam boiler and its level control, the determination of the natural acting head of high temperature tank and design of the cooling water flow of measuring tank

    試驗臺由高溫工質自然循環子系統、冷卻水機械循環子系統和計算機監測控制子系統構成，試驗段進出口溫差及冷凝管進出口溫度的測試、蒸汽鍋爐充注量及液位控制、高溫水箱自然作用水頭的設計、冷卻水流量計量水箱的設計等是試驗臺設計中值得重視的問題。
  19. Humidifiers, steam spray, water spray, ultrasonic humidifiers, cooling humidification, etc

    加濕器、蒸氣噴霧、水噴霧、超聲波加濕器、冷加濕等
  20. This cleaned, hot gas, having been piped to an oil cooler for flash cooling from 850 c down to ambient temperature, is set to drive the gas engines which in turn power generators for the production of electricity, and augment the fuel for the boilers to generate the steam for more thermal treatment and electricity

    清潔的熱氣體輸送到機油冷卻器，氣體迅速從850 c冷卻至室溫，同時開始驅動氣體發動機並使其成為產生電能的發電機，增加鍋爐燃料以生成蒸汽用於進行更多的熱處理並生產更多的電能。
分享友人
分享到 Line

分享到臉書