steam cycle 中文意思是什麼

steam cycle 解釋
蒸汽循環
  • steam : n 1 蒸汽，水蒸氣，水氣，霧，蒸氣壓力。2 〈口語〉精神，精力，氣力；怒氣。3 輪船，乘輪船旅行。vi 1 ...
  • cycle : n 1 循環，周期，一轉。2 周時，周年，年紀。3 （詩、故事等的）始末。4 自行車，三輪車，摩托車。5 【...
  1. The key to that is a so - called rankine cycle engine, which captures waste heat from the car ' s exhaust and puts it back to work to heat water, which gets converted to steam to power an electric generator, which in turn charges the car ' s battery pack

    這項技術的關鍵是被稱為「林肯循環引擎」 ，它抓住了廢熱從汽車的尾氣排出，使它重新投入工作，以熱水轉化為蒸汽，啟動電動發電機。
  2. Application of the contrasting method in lecturing the steam power cycle

    對比法在講授蒸汽動力循環時的應用
  3. Steam turbine procurement for combined - cycle plants

    燃氣蒸汽聯合循環設備采購.汽輪機
  4. Review of the combine dsupply of heat coll electricity by gas - steam combined cycle

    電聯供在我國的發展
  5. The contamination phenomenon of condensate water resulting from condenser leakage in operation of condensating steam turbine with open cycle cooling system by sea - water has been presented, the causes leading to condenser leakage being analysed, and leakage searching method as well as leakage preventing method under operation condition being given

    摘要介紹海水開式循環冷卻的凝汽式汽輪機在運行中因凝汽器泄漏導致的凝結水污染現象，分析凝汽器發生泄漏原因，並給出運行狀態下凝汽器的查漏方法及其防泄漏措施。
  6. The article takes a 600mw natural cycle drum boiler ( soot blow using steam ) as investigating object, establishes soot accumulation loss and soot blowing energy loss models for its water cooling wall, superheater, economizer and air preheater respectively, set up instructions for soot blower operating. simulating calculation results are compared with site data to verify usefulness of key models. the article introduced the operation optimizing design of soot blowers of yanzhou no2 power plant based on theoretical research

    本文以600mw汽包自然循環鍋爐（蒸汽吹灰）為具體分析對象，分別建立其水冷壁、過熱器、省煤器、空預器的積灰損失和各受熱面吹灰能量損失的模型，建立相應的吹灰器運行規則指導，對設計中的關鍵模型問題，通過模擬計算及與現場數據作比較的方法，驗證其可用程度。
  7. Main products of nanjing turbine & electric machinery ( group ) co., ltd are heavy - duty gas turbine generating unit, steam turbine generating unit, gas - steam combined cycle unit, co - gen. steam turbine unit and generator as well as large & medium sized synchronized / asynchronized motors

    南京汽輪電機（集團）有限責任公司主產品有重型燃氣輪發電機組及燃氣/蒸汽聯合循環發電設備、熱電聯供汽輪發電機組和大中型同步、異步交流電動機。
  8. Steam curing cycle

    蒸氣養護循環
  9. The integrated system of smelting reduction ironmaking - gasolinesynthesis - electric - ity generation, in which the coal gas produced inthe ironmaking module is first cleaned and then used as the fuel for theelectricity generation module or raw material of the gasoline synthesismodule, can resolve the problem of utilization of tail gas in thesmelting reduction ironmaking and the large investment of gasificationin the integrated gasification combined cycle and gasoline synthesis. taking efficiency, scale and product structure into consideration, the processes of the two - stage smelting reduction ironmaking - combined cycleelectricity generation with coal gas, the two - stage smeltingreduction ironmaking - steam cycle electricity generation with coal gas, the one - stage smelting reduction ironmaking - combined cycleelectricity generation with coal gas, and the one - stagesmelting reduction ironmaking - gasoline synthesis with coal gas - steamcycle electricity generation with tail gas are techno - economicallyfeasible and have the promise of being industrialized

    將熔態還原煉鐵產生的煤氣在凈化后發電或經改質后合成汽油的集成系統可以解決熔態還原煉鐵的尾氣利用問題及聯合循環發電和煤基汽油合成造氣投資成本高的問題.從效率、規模和產品結構各方面考慮，過程模擬結果顯示:二段法熔態還原煉鐵-煤氣聯合循環發電、二段法熔態還原煉鐵-煤氣蒸汽發電、一段法熔態還原煉鐵-煤氣聯合循環發電、一段法熔態還原煉鐵-煤氣合成汽油-尾氣蒸汽發電流程，有實現產業化的可能
  10. The main equipment selecting of gas and steam combined cycle for power produce regulation and heat supply integrated

    蒸汽聯合循環調峰熱電廠的主機設備的選擇
  11. The thermal efficiency analysis of low heat value fuel in the gas - steam combined cycle installation

    蒸汽聯合循環的低熱值燃料熱經濟性分析
  12. Analysis of the thermodynamic featurs of gas - steam combined cycle generating unit and the thermodynamic economy of gas turbine

    蒸汽聯合循環發電裝置的熱力特性及燃氣輪機熱經濟性分析
  13. Application and development prospect of gas - steam combined cycle cogeneration

    蒸汽聯合循環熱電聯供的應用及發展前景
  14. Two kinds of representative cc - repowering ( feed water heating repowering, full firing repowering ) are study in this paper. the concise performance expressions and typical data are analyzed for the combined cycle and for repowering the existed steam power station

    本文針對兩種典型的聯合循環系統（排氣助燃型和給水加熱型）進行了研究，給出了這兩種聯合循環及其在用以增容改造已有的蒸汽輪機電廠時的性能簡明示式和典型數據。
  15. The stress analysis and the fatigue life loss calculation of steam drum are carried out in this article. a simplification formula is proponed to calculate the main stress and is used in configuration of dcs. the rain - flow method is used to count the fatigue cycle, which can satisfy the need of on - line monitoring

    本文對其進行了應力分析和疲勞壽命損耗的計算，並提出主應力計算的簡化公式用於dcs組態，採用雨流法作為在線計算的疲勞計數方法，滿足了壽命損耗在線監測的要求。
  16. After a brief introduction of the utilization of combined cycle generation technology, a review of types, current research and development of combined cycle generation technology were given first. the development, technical features, projects and research organizations of igcc and pfbc - cc are mainly introduced. at the same time, coal combustion combined cycle technologies and the program, features and current research of steam - electric - gas in china are also introduced

    在對聯合循環發電的技術及利用意義簡要介紹的基礎上，本文首先對聯合循環發電技術的類型及其研究發展現狀進行了綜述，主要針對整體煤氣化聯合循環、增壓流化床聯合循環的系統的發展、技術特點以及示範工程等基本情況進行了介紹；同時對我國的燃煤聯合循環發電技術及熱電氣「三聯產」技術的工藝流程、特點及研究現狀進行了介紹。
  17. This essay, which researches into huaneng chongqing gas turbine power plant ( 108. 25mw ) as its object of study, carries out calculations on the variable rated performance of the steam - gas turbine combined operation, utilizing an integrated method of theoretic analytics and artificial neural net. a set of software system applicable to monitoring of plant performance has been developed based on the calculations, which is used to raise the efficiency of a combined cycle plant to achieve largest possible economic profit

    本文以華能重慶燃機電廠（ 108 . 25mw ）為研究對象，應用理論分析和人工神經網路相結合方法，對蒸汽- -燃氣輪機聯合循環進行變工況性能計算，並以此為基礎開發出一套適用於工況監測的軟體系統，以提高聯合循環電站的營運水平，獲取最大經濟效益。
  18. Based on sufficient investigation of relative field at home and abroad, combined with actual state of engineering, aimed at the characteristics of low temperature waste heat power generation, under adequate consideration of economical efficiency, the thermodynamic system models on the base of rankine - cycle, which mainly consisted of evaporator, ehd condenser and steam turbine - generator group with r11 as working fluid, were constructed after comparing the current low temperature waste heat power generation systems

    文中在對國內外相關領域進行了充分調研的基礎上，結合工程實際狀況，針對低溫余熱發電特點，充分考慮經濟性的前提下，對現行的低溫余熱發電系統進行比較，選擇了以具有低沸點的r11為工質，由蒸發器、 ehd冷凝器、汽輪機-發電機組等主要部件組成的有機朗肯循環熱力系統模型。
  19. The paper discusses the selecting principle of pinch point and approach temperature point which belongs to the hrsg ( heat recovery steam generator ) of minitype combined gas - steam cycle

    摘要論述小型燃氣蒸汽聯合循環中，余熱鍋爐節點溫差和接近點溫差的選取原則。
  20. And it illuminates the difference between mini - type and middle or big combined gas - steam cycle ' s bottom cycle

    闡明小型或微型燃氣蒸汽聯合循環與中等型或大型燃氣蒸汽聯合循環在蒸汽底循環中的差別。
分享友人
分享到 Line

分享到臉書