strain-gauge system 中文意思是什麼

strain-gauge system 解釋
應變測量系統
  • strain : vt 1 用力拉，拉緊，抽緊，扯緊。2 使緊張；盡量使用（肌肉等）。3 強迫，強制；濫用，盡量利用。4 拉傷...
  • gauge : n 1 規，量規，量器，量計，表。2 標準尺寸，標準規格；（金屬片等的）厚度，（槍炮的）口徑，（電線等...
  • system : n 1 體系，系統；分類法；組織；設備，裝置。2 方式；方法；作業方法。3 制度；主義。4 次序，規律。5 ...
  1. This paper presents the development and preliminary application works of an automatic strain gauge balance static calibration system in ecs for 1m hypersonic wind tunnel of cardc

    本文論述了cardc超高速空氣動力研究所1m高超聲速風洞配套的新型全自動六分量應變天平地軸系（ ecs ）校準系統的研製和初步應用研究工作。
  2. According to the study work of this paper, an automatic six - component strain gauge balance calibration system development scheme was put forwards : the system calibrates the balances in the ecs, and translates the loads to the bcs of the balances with measuring the balance ’ s position changes during the calibration

    本文根據1m高超聲速風洞氣動力試驗的總體要求，提出了採用天平校準載荷地軸系全自動加載、並通過天平空間位移測量將校準載荷換算到天平體軸系（ bcs ）的六分量天平校準系統總體研製方案，並確定了詳細的技術指標。
  3. Measurement amplifiers are used to make the output signal of strain gauge force transducers suitable for an attached control system

    用於固端板安裝的應變測量放大器測量放大器可以使應變測量傳感器的輸出信號適應相連接的控制系統。
  4. The strain - gauge balance must be calibrated before it ’ s using in the wind tunnel tests, and the precision and accuracy of the balance will be affected by the characters of the calibration system

    而應變天平在用於風洞試驗前，必須進行靜態校準，天平校準系統的性能指標將直接影響天平校準系數的準確性。
  5. Digtal measurement amplifiers are used to make the output signal of strain gauge force transducers suitable for an attached control system

    數字測量放大器使應變力傳感器的輸出信號適應連接的控制系統。
  6. This nsms ( nonin terference stress - measurement system ) method is an alternative to the strain gauge for moni toring rotor blade vibration

    此方法將在葉片的振動檢測中取代應變計式檢測裝置。
  7. To develop a good strain - gauge balance calibration system was been regarded as one of the most important works for most aerodynamic research institute

    國內外各大空氣動力研究機構都非常重視應變天平校準系統研製。
  8. The technique that used to measure the mechanical properties for mems is different from the traditional one considering the size scale. a uniaxial tension test system for test the mechanical property of mems materials is presented in this thesis. the strain is measured by interference strain / displacement gauge ( isdg )

    本文介紹了新近研製的用於測量微電子機械繫統mems材料的機械性能的單軸拉伸試驗系統，採用激光干涉技術測量試樣應變，得到材料從開始變形直至破壞的全歷程應力應變曲線。
  9. In the course of design the press machine tool fitting the valve guide tube onto the vehicle engine, it found necessary to design a special - purpose electric resistance strain gauge, which, considering the structure of the machine tool, is expected to send pressure numerical data to the control system of the machine tool

    根據汽車發動機壓導管專機開發研製的工作要求，並從機床設計具體結構考慮，需要設計專用電阻應變式力傳感器為機床的控制系統提供壓力數據信號。電阻應變式力傳感器的設計重點在於彈性元件的設計。
  10. This analogue measurement amplifier specially developed for very fast and accurate force measurement is used to adjust the output signal of strain gauge force transducers to make it suitable for information devices or a connected control system

    這款模擬測量放大器是特別為快速準確的力測量而設計的，可以調節應變測量力傳感器的輸出信號，使之適應信息設備或所連接的控制系統。
分享友人
分享到 Line

分享到臉書