superheat 中文意思是什麼

superheat 解釋
vt. 及物動詞 使過（度加）熱；【化學】使（液體不蒸發而）加熱到沸點以上。
n. 名詞 -er 過熱器。

  1. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  2. The absence of both high and low side service valves precluded measurement of superheat and subcooling correctly

    在上面和下面都應該安裝檢修閥，以便溫度過高和過低時能夠準確的測量
  3. Based on the refrigerant state, divides a heat exchanger into three zones with zoned lump method, i. e. superheat, two - phase and subcooling zones, works out the temperature difference and heat transfer coefficients of the three zones

    採用分區參數法將換熱器按製冷劑狀態分為過熱、兩相、過冷三區，分別計算了各區的換熱溫差、傳熱系數等。
  4. Suction gas pressure goes up as the compressor run at the lower speed in the lower burthen, and this is beneficial to lower systems energy - consume. when the system is controlled by wvf, the discharge change of the evaporator is not linear ; the electronic expansion valve is adopted to regulate the system superheat degree, and the controlled object is parameter time varying, accordingly, the time varying controller should be adopted

    在負荷較小時，壓縮機採用低速運轉，吸氣壓力升高，這對系統降低能耗是有利的；變頻控制時，蒸發器製冷劑流量的變化並非線性；系統中採用電子膨脹閥進行過熱度控制，被控對象具有參數時變的特性，相應地宜採用變結構的控制器。
  5. So tell me, what happens when you superheat rubber

    那麼告訴我，如果超高溫加熱橡膠會怎麼樣？
  6. Development of study on alloy melt superheat treatment

    圖形化技術在納米器件製造中的應用研究進展
  7. Bonus boling nuclear superheat reactor

    沸騰式過熱核反應堆
  8. Boiling nuclear superheat reactor

    核過熱沸騰反應堆
  9. Uncontrolled superheat boiler

    不可調式過熱蒸汽鍋爐
  10. Comparison of calculation methods of limit of superheat temperature of liquid helium

    液氦極限過熱度計算方法比較
  11. Research on casting microstructure of a356 aluminum alloy by low superheat pouring

    356鋁合金低過熱度澆注的鑄造顯微組織研究
  12. Has designed one boiler superheat vapor temperature online fuzzy pid double model control method based on this, and has given the detailed design proposal

    基於此設計一種鍋爐過熱蒸汽溫度在線模糊pid雙模控制方法，並給出詳細設計方案。
  13. Student : sir, you can have lots of heat, even more heat, superheat, mega heat, white heat, a little heat or no heat. but we don ' t have anything called cold

    學生：先生，你可以有許多熱能，甚至更多熱能，過熱，超多熱能，白熱，一點熱能或沒有熱能。但是沒有『冷』 。
  14. Abstract : based on the analysis of the mathematics models of saturation steam density and superheat steam density the paper states that the deviation of the detection on temperature highly affects the accuracy of intelligent flow totalizer. especially for saturation steam ， the accuracy of the temperature detection circuit shall be designed higher than the accuracy of the instrument. thus a temperature detection circuit based on ratio method with high accuracy is introduced

    文摘:在分析飽和蒸汽和過熱蒸汽密度的數學模型的基礎上指出，溫度檢測的偏差對智能流量積算儀的精度影響極大，尤其是飽和蒸汽，測溫電路的精度應設計為遠高於儀表的精度，同時引入一種基於比率法的高精度測溫電路。
  15. The main results in this paper are as follows : ( 1 ) study on starting up performance of thermosyphon : according to the study on the states before and after starting up of thermosyphon with the various filling amount, it is considered that the phase change heat transfer inside the copper - water thermosyphon with a large ratio of length and diameter is not only influenced by the boiling degree of superheat, but also controlled by evaporation and companied with the boiling of the thin liquid film

    本文的主要研究結果為： （ 1 ）熱虹吸管啟動性能的研究：通過對從不同充液量、啟動前狀態、內部汽化核心狀態對啟動的影響所進行的試驗研究，認為大長徑比的銅?水熱虹吸管管內相變不僅僅為沸騰，而是以蒸發為主，伴有薄液膜的沸騰。
  16. We make a theoretical analysis of the experimental results and draw some conclusions as follows : the saturated temperature r290 - oil mixture is higher than that of pure r290 at a same pressure. the temperature difference, which is called superheat temperature of refrigerant - oil mixtures, increases as the oil concentration and the vapor quality are increased at a certain saturated pressure and pressure has negligible effect on the superheat temperature of the mixture. ( oil concentration is 0. 43 ? - 5. 28 ? )

    並根據實驗結果進行理論計算，得出以下結論：天然製冷劑r290含油混合物的飽和溫度高於相同壓力下純工質的飽和溫度，這個溫度差，也就是本文中提到的所謂製冷劑含油混合物的過熱溫度隨混合物質量含氣率、含油濃度的增加而增加，而飽和壓力對過熱溫度的影響不大（含油率0 . 43 ? - 5 . 28 ? ） 。
  17. The conclusions reached are as follows : 1. the saturated temperature of refrigerant - oil mixture is higher than that of pure refrigerant at a same pressure. the temperature difference, which is called superheat temperature of refrigerant - oil mixture, increases as the oil concentration and the vapor quality are increased at a certain saturated pressure and pressure has negligible effect on the superheat temperature of the mixture

    得出以下結論： 1 、相同壓力下，製冷劑hc600a含油混合物的飽和溫度高於純工質的飽和溫度，這個溫度差，在就是文中稱為的製冷劑含油混合物的過熱溫度，它隨混合物質量含汽率、含油濃度的增加而增加，而飽和壓力對過熱溫度的影響不大。
  18. The conclusions reached are as follows : ( 1 ) the saturated temperature of refrigerant - oil mixture is higher than that of pure refrigerant at a same pressure. the temperature difference, which is called superheat temperature of refrigerant - oil mixture, increases as the oil concentration and the vapor quality are increased at a certain saturated pressure and pressure has negligible effect on the superheat temperature of the mixture

    得出以下結論： （ 1 ）製冷劑hc290含油混合物的飽和溫度高於相同壓力下純工質的飽和溫度，這個溫度差，也就是文中所謂的製冷劑含油混合物的過熱溫度隨混合物質量含汽率、含油濃度的增加而增加，而飽和壓力對過熱溫度的影響不大。
  19. ( 3 ) the saturated temperature of refrigerant - oil mixture has different definitions because of the superheat temperature of the mixture. one is the real saturated temperature of the mixture and the other is the saturated temperature of pure refrigerant corresponding to the tested pressure of the mixture. in this paper, the heat transfer coefficients based on the two different saturated temperatures are compared and the results showed the latter is larger

    （ 3 ）由於製冷劑含油混合物過熱溫度的存在，使其具有兩種不同的飽和溫度定義，一種是所測實際溫度，另一種是所測壓力對應純工質的飽和溫度，文中就這兩種飽和溫度定義下的冷凝平均換熱系數進行了比較，發現後者大於前者。
  20. The analysis by sampling data of no. 2 caster bao steel shows that the integrated heat transfer coefficient is independent of the width of slabs, and the effect of superheat is not clear, but the effect of casting speed is very obvious

    摘要對寶鋼2號連鑄機現場數據的采樣分析結果表明：連鑄坯在線寬度對結晶器綜合傳熱系數沒有影響。
分享友人
分享到 Line

分享到臉書