surface degree 中文意思是什麼
surface degree
解釋
曲面次數-
From 1200 utc surface wind direction 150 degree south - southeasterly winds ; wind speed 15 knots ; visibility 10 km or above ; nil significant weather ; broken cloud at 2000 feet and broken cloud at 10000 feet
由1200utc開始，地面風向為150度東南偏南風，風速15海里小時能見度10公里或以上並無顯著天氣狀況2000尺有疏鬆雲層， 10000尺亦有疏鬆雲層 -
From 1200 utc surface wind direction 150 degree ( south - southeasterly winds ) ; wind speed 15 knots ; visibility 10 km or above ; nil significant weather ; broken cloud at 2000 feet and broken cloud at 10000 feet
由1200utc開始，地面風向為150度（東南偏南風） ，風速15海里小時；能見度10公里或以上；並無顯著天氣狀況； 2000尺有疏鬆雲層， 10000尺亦有疏鬆雲層 -
Temporarily between 0800 utc and 1200 utc surface wind direction 170 degree ( south - southeasterly winds ) ; wind speed 25 knots gusting to 40 knots ; visibility 1000 m in thunderstorm with moderate rain ; scattered cloud at 1000 feet including cumulonimbus cloud and broken cloud at 2000 feet
在0800utc至1200utc之間，地面風向間中為170度（東南偏南風） ，風速25海里小時，陣風達40海里小時；能見度在雷暴及和緩雨勢中為1000米； 1000尺有零散雲層，包括積雨雲， 2000尺有疏鬆雲層 -
Among myopic eyes, the incidence of conus formation and surface ratio of conus to disc increased as the myopic degree or the ocular axial length increased
近視眼中，圓錐形成的發生率和圓錐和視神經盤比值皆依近視程度或眼軸長之增加而增加。 -
Zhoushan is sea area which fertility is tiptop in our country. sea surface wind is important factor of influencing contrail of excursion oil and culturist so investigating sea surface wind of zhoushan and setting up numerical forecast model which fits this sea area can offer tool for study sea wind in this area and let us has a mensurable acquaintance ship of effect degree of physics factors which effect sea surface wind in zhoushan sea area and acquaint oneself with physic process
而海面風是影響溢油油團漂移軌跡和養殖業的重要因素，因此，對舟山海域的海面風進行研究，建立適合此區域的數值預報模式，可為研究該區域海面風作用過程提供數值預報工具，使我們對近海區域海面風場作用中物理因子的影響程度有更定量的認識，並對物理過程和影響機制有更深刻地了解。 -
( 3 ) the result showed that when ambient temperature rises to a certain degree, the frictional surface of uhmwpe and its composites melt and gelatinize
門）當環境溫度升高到一定程度， uhmwpe及其復合材料與鋼配副的摩擦界面熔融變為凝膠狀態，其摩擦系數隨摩擦時間的延長保持不變。 -
Following is the factors ideating with the surface of old concrete in different way ( including brushing surface, chiseling surface, cleaving surface ), adherence agent ( including cement slurry, cement sand slurry, cement slurry with the u expansion agent ), the freeze - thaw circulation times and air - entraining. as a result, we found that the roughness influence on the adhesion capability of the new on old concrete to a large degree. the larger rougeness is, the larger the splitting tensile strength on the adhension face is. the kind of adhesion agent is also influence on the adherence capability of new on old concrete. the circulation times of freez - thaw have a large influence on the splitting tensile strength of adherence face of new on old concrete. the analysis of tests give some advices to the practical engineering
主要考察了老混凝土表面不同處理方式（刷毛面，鑿毛面，劈裂面） 、界面粘結劑類型（水泥凈漿，水泥砂漿， u型膨脹劑水泥漿） 、凍融循環次數等對新老混凝土粘結面劈拉強度的影響，以及凍融作用下新混凝土加氣對粘結面劈拉強度的影響。試驗結果表明，粗糙度對新老混凝土粘結性能有重要影響，隨著粘結面粗糙度的增大，粘結面劈拉強度不斷增加；界面粘結劑類型對新老混凝土粘結性能有一定影響，在凍融作用下， u型膨脹劑水泥漿粘結效果不如水泥凈漿和水泥砂漿；凍融循環對粘結面劈拉強度有較大影響，加氣能明顯改善新老混凝土粘結面的抗凍能力。 -
At recent decade, accompany with surface mount technology printed - circuit board to produce fly of automation degree to soon develop, as to it ' s correspond of mass defect the inspection also put forward higher request, from in brief shoot to be like system to complicated " 3 - d " x optics to examine system, the automatic optical inspection is in great quantities adopt by the each production factory house
摘要在最近十年，伴隨著表面貼裝印刷電路板生產自動化程度的飛速發展，對其相應的質量缺陷檢查也提出了更高的要求，從簡單的攝像系統到復雜的" 3 - d " x光檢測系統，自動光學檢測系統大量被各生產廠家採用。 -
The major function of having precious metals coated with carriers is that it can provide with larger touchable square measure. therefore, it can provide the largest surface square measure and held - up time. equilibrium tight intensity can provide gas with good mixable degree and even step - down in order not to cause slanting flow
將貴金屬披覆于擔體上，主要功能為提供較大的接觸面積，因此可提供最大的表面積及滯留時間，均衡的緊密度可提供氣體好的混合程度及均勻的壓降，不致造成偏流。 -
It is found that mld based on a temperature change from the ocean surface of 0. 5 degree celsius is deeper, especially from jan. to apr., while mld based on a variable density change from the ocean surface with a temperature change of 0. 5 degree celsius is shallower
分析表明，基於溫度階躍0 . 5得到的mld較深，尤其在1 4月，這可能主要是因為沒考慮mld此時受到的鹽度變化的影響；基於溫差為0 . 5對應的密度定義的mld最淺。 -
On construction equipment of asphalt rood surface of high - degree way
高等級公路瀝青路面面層施工設備選用要點 -
Surface wind direction 130 degree east - southeasterly winds ; wind speed 18 knots
地面風向為130度東南偏東風風速18海里小時 -
Surface wind direction 130 degree ( east - southeasterly winds ) ; wind speed 18 knots
地面風向為130度（東南偏東風） 、風速18海里小時 -
The notable torsion effects of the surface ground motion above the alluvial valley are illustrated and the torsion effects become stronger as the frequency of the incidence is higher. ( 4 ) antiplane surface motion of the underground circular soft inclusion and the underground homogeneous soft interlayer is investigated in this paper. the results indicate : surface displacement amplitudes just above the soft inclusion of small depth - to - width ratio is amplified and soft interlayer of small depth - to - thickness ratio is amplified to a certain degree, and moreover, the latter is lower limit of the former
結果表明：垂直入射時，小深寬比軟夾塞上方地表位移幅值有較大的放大，小深厚比軟夾層的地表位移幅值也有一定的放大，且後者為前者的下限；波接近掠入射時，軟夾塞正上方地表點和軟夾層的中國地震局工程力學研究所碩士學位論文一地表位移幅值都沒有放大，而軟夾塞迎波面一側地表點的位移幅值會有一定的放大；軟夾塞上方的地表位移運動有較強烈的扭轉效應，且此扭轉效應隨入射波頻率的增高而增強。 -
Then a high - degree geometric continuity blending surface is obtained with transfinite interpolate method. ( e ) g3 blending surface with approximation can be constructed by lofting if geometric invariant errors are given, the surface can be converted to b - spline, nurbs form for the purpose of system aggregation
最後，為滿足曲面造型系統集成的需要，在保證曲率、曲率導數和撓率精度情況下，將上述研究結果應用於曲面放樣逼近方法，得到參數過渡曲面轉換成b樣條曲面或nurbs曲面的形式。 -
The paper made an ecological anatomy, a cultivation experiment on the lime - soil habtat and an analysis on the diurnal variation of photosynthetic an transpiration rate from three aspects of morphology, transplantation, physiology. the conclusion is that : ( 1 ) from the viewpoint of morphological anatomy, it has typical xerophyte structure such as strong root system, small leaf area, dense floss under the leaf surface, high stomatal density, the small opening degree, developed vessels and palisade tissues etc
從形態學、栽培學和生理學三方面對迷迭香進行生態解剖、石灰土上的栽培實驗以及光合蒸騰速率日進程的分析，得出以下結論： （ 1 ）在形態解剖上：迷迭香具有發達的根系，較小的葉面積，葉片下表面密被絨毛，氣孔密度大，開度小，厚的角質層和發育良好的木質部和柵欄組織等典型的旱生結構。 -
The disperse degree of the ceramic can greatly affect uniformity of the composite, which limit the poling voltage and affect the piezoelectricity. in this paper, the relationships among constitutes, microstructures, dielectric and piezoelectric properties were calculated by employing the banno unit cell mode ; pzt ceramic were synthesized by the hydrothermal method and the appropriate solution was selected according the adsorption of pvdf on the ceramic particle surface ; then, relationships between the disperse degree and the fabrication process were studied. base on these, the pzt / pvdf composites intermingled some pan were prepared and the microstructures were investigated
論文首先利用bannounitcell模型，計算了pzt pvdf壓電復合材料的組成、結構、與其壓電和介電等性能之間的關系；針對壓電復合材料存在的均勻分散性差的缺點，選用水熱法制備的粒度均勻的pzt陶瓷粉末，並採用溶液混和法與聚合物pvdf進行分散復合，重點研究了不同工藝條件下陶瓷的均勻分散性及其與材料微觀結構之間的關系。 -
This product useds for sealing completely the car paint surface ream car paint to face the instauration new car original luster increment paint face theshining degree to seal completely effective permeate the dint strong keep time long
本產品用於密封車漆表面，令車漆面恢復新車原有光澤，增加漆面光亮度，密封效果好，滲透力強，保持時間久，適用於淺色車漆。 -
The effects of reynolds number, back surface of nozzle, aft - dome configuration and degree of submergence on aft - end internal flow were studied by both cold gas simulation and numerical simulation. it is showed that the separated flow is sensitive to the change of reynolds number and aft - end cavity configuration
最後，利用冷流模擬與數值模擬相結合的方法，研究了雷諾數、噴管背壁形狀、后封頭形狀和潛入深度對燃燒室尾部流場的影響，結果表明流動的分離對雷諾數和背壁區幾何邊界的變化很敏感。 -
Add the bating agent and emulsifier de - fat agent into the same water bath after bating to get rid of the non - structured collagen and non - collagen proteins to enhance the softness of the leather and the elasticity of the surface. it may also increase the deliming effect, improve the degree of cleanness and smoothness of the leather face. the ferment is solved ( soften )
在脫灰后的同水浴中，添加酵解劑和乳化脫脂劑，以除去非組織膠原（ nonstructuredcollagen ）和非膠原蛋白質（ noncollagenproteins ） ，以促進皮質的柔軟度和皮面的彈性，亦可增進脫灰的功效，改進皮面的清潔度與平滑。
分享友人