surface rate 中文意思是什麼

surface rate 解釋
舵面偏轉速率
  • surface : n 1 表面；地面；水面；廣場，空地。2 外觀，外表，皮毛。3 【幾】面；切口；【航空】翼面。adj 表面的...
  • rate : n 1 比率，率；速度，進度；程度；（鐘的快慢）差率。2 價格；行市，行情；估價，評價；費，費用，運費...
  1. More meaningful comparisons can be made by comparing water loss from the potometer with that from an atmometer ( an apparatus used to measure the rate of evaporation from a porous pot or other nonliving wet surface ), which allows uncontrolled evaporation

    更有意義的是，可以比較蒸騰計的失水與蒸發計（通過有孔小罐或者潮濕表面來測量蒸發速率的儀器）的失水間的區別。
  2. The bacilliform cell penetrate into interior of the fibre to degrade the cellulose strongly and produced a mass of sticky polysaccharides. after cultured 48 hours, the bacilliform cell ' s surface of sporocytophaga have a great change. at this stage the bacilliform produce a lot of sticky polysaccharides. these sticky polysaccharides associated with the sites where the filter paper was decomposed intensively and form thorns on the surface of the bacillium. at the same time, the filter - paper weight loss is the greatest and decomposing rate is the fastest, so we think that the sticky polysaccharides are produced during the cellulose degradation

    培養48小時，桿狀細胞的表面結構發生很大的變化，此時的菌體表面已產生大量的粘性多糖，這些粘性多糖因菌體在纖維素表面滑動而在菌體表面形成突起，即在纖維素被旺盛降解部位的菌體表面產生了大量突起；而產生突起的菌體深入到纖維素分子內部，纖維素表面可以清晰地看到由於菌體嵌入纖維素分子內部而留下的凹陷。
  3. Surface dressing - specifications - rate of spread and accuracy of spread of binder and chippings

    表面修琢.規范.粘合劑和石屑攤鋪的速度和準確度
  4. Surface dressing - test methods - rate of spread and accuracy of spread of binder and chippings

    敷路料.試驗方法.粘合劑和石屑攤鋪的速度和準確度
  5. Surface dressing - specifications - part 3 : rate of spread and accuracy of spread of binders and chippings

    敷路料規范.第3部分:粘合劑和石屑攤鋪的速度和準確度
  6. Surface dressing - test methods - part 1 : rate of spread and accuracy of spread of binders and chippings

    敷路料.試驗方法.第1部分:粘合劑和石屑攤鋪的速度和準確度
  7. Surface dressing - test methods - part 1 : rate of spread and accuracy of spread of binder and chippings ; german version en 12272 - 1 : 2002

    路面敷料試驗方法.第1部分:粘合劑和石屑攤鋪速度和準
  8. When ph value < 0. 5, faster deposition rate, faster growth rate of crystallizing nucleus, which causes bigger crystalline granularity and bad surface quality of the deposits such as crassitude or darkling

    Ph 0 . 5時，沉積速度過快，晶核成長速度快，晶粒粒度較大，鍍層表面粗糙、發黑，表面質量差。
  9. A one - dimensional oceanic mixed layer model with the m - y level - 2. 5 turbulence closure schemes is employed. the rate of energy loss by breaking waves is estimated by parameterization and incorporated into the model as a source of turbulence kinetic energy ( tke ) by modifying the existing surface boundary condition of tke equation. the velocity field and turbulence energy budget are calculated under different forcing conditions ( the results given below are for a wind speed of 20 m / s. )

    採用一維2 . 5階湍封閉混合層模式，根據參數化方法對波浪破碎導致的能量耗散率進行了估計，通過改變湍動能方程的上邊界條件引入波浪破碎對湍動能生成的影響，計算了不同風應力強迫下的混合層流場結構和湍能量收支（下述給出的結果是取風速為20m s得到的） 。
  10. Charcoal canister method for measuring 222rn exhalation rate from building surface

    建築物表面氡析出率的活性炭測量方法
  11. This phenomenon was closely related to the transportation and extraction rate of carbon atoms in the surface of catalysts at different temperatures

    這種現象與不同溫度下碳原子在催化劑表面的遷移和析出速率密切相關，也即與不同溫度下催化劑的活性有關。
  12. Ym series is an epoxy - bond, two - part liquid thermal cure marking ink. it has such perfimance characters as good printing adaptability, fast curing rate excellent adhesion and insulation resistance. it is better to be used in making double surface and the multipke layers circuit boards

    Ym為雙組液型熱固化標記油墨，具有良好的印刷性，固化速度快，塗膜硬化后具有優異的附著力、耐化學性，特別適合用於雙面及多層印刷電路板。
  13. ( 1 ) it was found from the obtained results that increasing of flux will led to decrease in froude no. of the following water at the shrinking section which will reduce rate of disspated energy, this will make the protection of dam surface more difficult

    主要結論如下;隨著流量的增加，消力池收縮斷面弗勞德數減小，消力池的消能率減小。壩面平均流速增大，壩面的防護難度增加。
  14. Also the theoretical basis of the method have been checked through simple deducing simulation and the influences of various physical parameters on the method have been studied. it is shown that the method is theoretically reliable for the production oil wells without very high production rate and is more suitable in field production for oil wells ( i ) in area with bigger geothermal gradient ; ( ii ) producing fluids ( oil and water ) with distinguish thermal characteristics ; ( iii ) producing oil with lower heat capacity or water with higher heat capacity ; ( iv ) with good surface measurement accuracy, as well as the method h as certain requirements on the accuracy of the temperature and flowmeter logs sensors

    就該產出剖面方法的理論基礎進行了簡單的正演模擬和可能影響該方法的各項物理參數進行了全面的考察，結果表明，該方法對于非高產的生產油井來說在理論上是可靠的，在實際生產中適合於（ 1 ） 、油井所在地區地溫梯度較大的油井； （ 2 ） 、油水熱特性差別較大的油井； （ 3 ） 、油比熱容值偏低水比熱容值偏高的油井； （ 4 ） 、井口計量精度較高的油井，並且對井溫測井和流量測井的傳感性精度有一定的要求。
  15. The resulting brightness temperature ( tb ), hydrometeor structure, and surface rainfall rate relations show that the ice hydrometeor, espatially the ice at the top of the precipitating cloud, decreases the brightness temperature significantly at 85

    結果表明，在85 . 5ghz ，冰相水汽凝結體尤其是處于降水雲頂部的冰晶粒子由於散射輻射而使得亮溫顯著降低。亮溫與冰相粒子的含量之間有很強的相關性。
  16. The brightness temperature is highly related to the density of ice hydrometeor. since the convective cloud system is tilted, and the viewing angle is oblique, the area displacement between ice hydrometeor and the surface rainfall rate makes the relation between tb and surface rainfall rate is relatively small

    但亮溫和地面降水強度之間的相關性較弱，這是由於該對流系統為傾斜的，冰相粒子和地面降水強度之間存在著位置上的不一致，並且觀測角為傾斜的。
  17. Ru1ls : the root surface with high root caries prevalence rate are labial surfaces of incisor and canine, mandibular premolar and molar, lingual surfaces of mandibular incisor and canine and maxillary molar, distal surface of premolar and mesial surface of molar

    結果：根面齲易感性高的根面為前牙、下領前磨牙、磨牙的唇（頰）面、下前牙與上領磨牙的舌面、前磨牙的遠中面、磨牙的近中面。
  18. As a result, in the paper, considering the altitudinal effect ( topography factor ) and the influence on the temperature lapse rate by topography and latitude and longitude and moisture transfer, the study on the daily surface air mean, max and min temperature in the reaches of yangtze rive is attempted by five models, which include the gaussian weighted model, the gaussian weighted model associated with the error - modification, the gradient plus inverse distance squared model and the modified gaussian weighted model a and b that take topography - factor into account

    本文考慮海拔高度和溫度直減率受地形和經、緯度及水汽等因素的影響，通過利用高斯權重法、結合逐步訂正的高斯權重法、梯度距離權重反比法和加入地形影響項（地形因子）的兩種改進高斯權重法的方案a 、 b ，對長江流域的地面日平均、最高和最低氣溫場進行了空間化插值研究。
  19. Surface active agents. mercerizing agents. evaluation of the activity of wetting products for mercerization by determination of the shrinkage rate of cotton

    表面活性劑.絲光處理試劑.用棉花收縮率測定法評價濕性產品絲光處理的活性
  20. He eventually hopes to use rock - cutting rovs that will drive across the sea floor, grinding ore as they go and sending it to the surface via a tube at a rate of 400 tonnes per hour

    他最終希望能用可以橫穿海底的巖石開掘機rov將礦石碾碎，然後通過一條管道以每小時400噸的速度將其運至海面。
分享友人
分享到 Line

分享到臉書