surface-equivalent 中文意思是什麼
surface-equivalent
解釋
水面當量- surface : n 1 表面；地面；水面；廣場，空地。2 外觀，外表，皮毛。3 【幾】面；切口；【航空】翼面。adj 表面的...
- equivalent : adj 1 相當的，相同的，同等的。2 【化學】等價的，當量的；【數學】等價的；等量的；等勢的；【物理學...
-
A conclusion is reached that the surface porous metal plate excels flat metal plate at equivalent absorptivity on the same condition
分析得知：多孔板等效吸收率高於同等條件下光滑板的吸收率。 -
The stresses acting over the surface of the body must produce tractions which are equivalent to the loads being applied to the body.
作用在物體整個表面上的應力所產生的面力，必須與作用在物體上的載荷相等。 -
The critical concentration and critical particle surface area in constant rate section is studied. the floc density pa and the floc equivalent diameter da are calculated on the basis of experimental data and theoretic analysis
研究了等速段的臨界濃度、臨界顆粒表面積；分析計算了絮團密度_ 、泥沙絮團當量直徑d _ 。 -
Illuminance level on a surface. the hydraulic equivalent is represented by the amount of water falling onto the surface in question, within the time unit
重要?何?推? ， ?照度的定? ?得， ?是很有用的可以去了解光在空?中的?散情形。 -
The diffusion carrier concentration profile and junction depth were measured and compared with conventional furnace processing diffusion ( cfd ). it presented following conclusions : 1 ) the temperature distribution in quartz chamber of rtd furnace is uniform because square resistance is uniform after rtd ; 2 ) the diffusion velocity of rtd furnace by a factor of three compare to conventional furnace processing diffusion ( rtd ) ; 3 ) if diffusion temperature and doping phosphorus are equivalent, doping phosphorus of rtd are more than of cfd in equivalent distance to the silicon surface
實驗研究了快速熱擴散（ rtd ） ：通過旋塗磷膠和印刷磷漿兩種方式考查了2 4和103 103單晶硅的快速熱擴散特性，發現： 1 ）此樣機的溫度場在空間分佈上是均勻的； 2 ）快速熱擴散可以比傳統擴散快3倍的速度進行擴散； 3 ）在擴散溫度和摻雜磷源相同的條件下，與傳統擴散相比，快速熱擴散將雜質向結更深的地方推進。 -
The bleaching experiment of loess by iodine tungsten lamp and the equivalent dose ( de ) of loess estimated by sar from the earth ' s surface indicate that loess can be easily bleached by sunlight, and osl is suitable for the dating of loess. 2. equivalent dose estimated by sar, when each natural or regenerated dose osl measurement is corrected for changes in sensitivity using the osl response to a subsequent test dose and the recycling ratio is around 1, implies that sensitivity changes have been properly corrected
用單片再生劑量法（ sar ）測定黃土樣品的d _ e值時，用固定的實驗劑量釋光信號校正後，再循環比（ recyclingratio ）都在1左右，說明對釋光靈敏度的變化起到了很好地校正作用；校正後， ogy再生劑量釋光信號與自然信號的比率都在5以下，信號的回復可以忽略不計。 -
Measurement of mine surface air leakage rate with equivalent method
等值法測定礦井外部漏風率 -
This method utilizes near - field data to determined an equivalent magnetic current source over a fictitious surface which encompass the em radiation source. this magnetic current, once determined, can be used to ascertain the near and the far field
將近場的測量數據用來確定一個等效磁流源，該等效磁流源位於包含電磁源輻射口面的假設平面上，當確定了這個等效磁流源以後，利用它計算出輻射源的近區場和遠區場。 -
3. the fundamental principle of loading of influence surface for straight - bridge is expounded by using the mixed method of dynamic programming and exhautive taking, and which is extended to the loading of influence surface for curved - bridge by quoting the idea of equivalent influence surface
應用動態規劃法和窮舉法並舉的混合法思想，闡述了直橋影響面加載的基本原理，並引入等代影響面的概念將此理論推廣應用於彎橋影響面加載。 -
The pinning of the surface fermi level at 0. 29 ev above its initial value, equivalent to a variation of schottky baxrier height of 0. 67 ev is observed upon deposition of ~ 0. 6 ml er onto the clean p - type si ( 00l ) ( 2xl ) surface at room temperature
通過對測得的硅和鉺的芯能級和價帶的分析，得到了以下結論：隨著鉺覆蓋度的增加至約為0 6單層，表面fermi能級被釘扎在其初始值0 -
In this paper, the traffic surveys and analysis of typical heavy - load road were performed firstly ; also the characteristics of traffic, load and distribution of axle load were studied. the deficiencies in the calculation method of surface equivalent modulus of foundation in present specification of cement concrete pavements design for highway were analyzed. based on the elastic multi - layer theory and principles of displacement equivalence, and a great amount of computing data, a calculation method was established
本文首先從典型重載交通道路的交通調查與分析入手，研究了重荷載交通道路的交通量、軸載分佈及荷載特徵，針對現行設計規范中關于基層頂面當量回彈模量值計算公式存在的不足，利用彈性層狀體系理論，按照彎沉等效原則，通過大量的計算分析，回歸出了精度較高、適用范圍更廣的基層頂面當量回彈模量計算公式。 -
A modified definition of polarization resistance calculated from the equivalent circuit of eis make its value dependent on the grain size. in anodic polarization test ( sweeing and stair - steps ), the maximum ( critical ) current density increases while the passivation potential and breakdown potential lowers with the reduction of the grain size. fegsem images showed the grain growth and pitting corrosion of the nc copper surface, uniform corrosion in the mc copper surface and the broken passivation layer in both surfaces
在陽極極化實驗（包括掃描法和臺階法）中，致鈍電流雖晶粒尺寸減小而增大，而致鈍電位和擊穿電位都隨著晶粒細化而降低。 fegsem照片發現了納米晶銅的晶粒長大和孔蝕，微米晶銅表面的均勻腐蝕，和兩種銅表面破碎的鈍化膜。 -
Surface hardness is equivalent or better than to 4h pencil
表面硬度相當于甚至好於4h鉛筆。 -
By doing single fracture drainage experiments, this paper has successfully presented the logarithm function relationship between ratio of drainage discharge through upward and plumb drainage hole and the ratio of their equivalent diameters. the drainage effect will be the best when the included angle between drainage hole and fracture surface is 21 ~ 36
4 、通過單裂隙排水試驗，建立了傾斜孔和垂直孔的排水量之比與其交界線的等效直徑比之間的自然對數關系式，排水孔排水量基本隨其與裂隙面的交角減小而增大；對單組裂隙排水的初步分析表明，排水孔與裂隙面的夾角在21 ~ 36范圍內排水效果最佳。 -
Abstract : based on equivalent liquid surface descending method ( elsdm ) and isolated melting zone method, a multi - hot - spot and simultaneous shrinkage - feeding method was established to predict the shrinkage cavities of steel casting during solidification simulation. the shrinkage in each hot spot can be simulated and fed dynamically and simultaneously by itself using this method. then two practical steel castings were analyzed by this method
文摘:本文在等效液面收縮法和孤立域法基礎上建立了預測鑄鋼件縮孔的新方法? ?多熱節和即縮即補方法，該法實現了對模擬鑄件各熱節的內部動態瞬時補縮，並採用該方法對兩個實際鑄鋼件進行了縮孔分析。 -
In addition, the mom - po hybrid method is proposed to dissect radiation from radome - enclosed antennas and the correction impedance matrix upon which the solution to equivalent currents of radome ' s surface depend is built. a comparative analysis of those methods is finally presented to examine respectively their accuracy as well as computational efficiency
最後，對矩量法物理光學法的混合演算法分析問題的過程進行討論，給出混合演算法分析帶罩天線輻射問題的具體解決方案，建立混合演算法求解天線罩表面等效電磁流的校正矩陣。 -
Abstract : it was deduced that the shapes of magnetic particle indicationsof point - type defects on workpiece surface depended on the resistance of carrier medium, and their dimensions depended on the volume of the defect equivalent cuboid, the magnetising characters of workpieces and magnetic particles, the strength of magnetic field, the lengths and sections of magnetic particles and the resistance character of carrier medium
文摘:推斷出工件表面點狀缺陷磁痕的形狀取決于磁粉載體的介質阻尼力，磁痕大小取決于缺陷等效長方槽的體積、工件和磁粉材料的磁化特性、磁場強度、磁粉長度和橫截面積以及載體介質的阻尼特性等。 -
Through simulation, found the influence rule on existed structure by shield construction, discussed construction factors such as soil deformation modulus, different thickness of and different elastic modules of equivalent circle zone, control soil pressure, initial stress release rate influence on the surface settlement and structure deformation, studied the reasonable parameter value scope
通過數值模擬，研究了盾構施工對既有結構的影響規律。討論了地基變形模量、等代層厚度和參數、圍巖應力初期釋放率、盾構正面土壓力等施工因素對地表沉降和筏板基礎沉降的影響，研究了穿越結構物時參數的合理取值范圍。 -
The article describes the shape of wind load on the radome surface and analyzes the internal force of the radome with nonmomental theory of shell, stresses and stability with theoretic formula, equivalent modulus of elasticity and thickness of a - sandwich - composite structure
摘要針對雷達罩易受風荷載作用發生破壞的情況，本文從截球形雷達罩表面的風荷載分佈形態出發，採用無矩理論對雷達罩內力進行了分析計算，從理論上對模型進行了強度和穩定性分析，並著重闡述了a型復合材料夾芯結構的等效彈性模量和厚度的計算方法。 -
Based on the transfer - matrix method, the general expressions of equivalent four - terminal network parameters of varying section torsional horn are derived, the relations between frequency equation and both the rotational velocity amplification and that of the surface tangential velocity of stepped type torsional ultrasonic horn with transitional section of cosine - like type are obtained
摘要基於傳遞矩陣演算法，推導出了變截面桿扭轉振動時等效四端網路參量的一般表達式，研究了帶類餘弦過渡段階梯形變幅桿扭轉振動頻率方程與角速度放大倍數及外表面切向速度放大倍數等的關系。
分享友人