tap transformer 中文意思是什麼

tap transformer 解釋
抽關變壓器
  • tap : vt 1 輕打[拍，敲]。2 補鞋底，打鞋掌；打（著做）出〈如用發報機打出電訊〉。3 選舉，選擇。vi 輕敲，...
  • transformer : n. 使變化的人[東西]；【電學】變壓器；變換器；互感器。 polarity of transformer 變壓器繞線方向。
  1. The main operating transformer connected by a adscititious tandem on - load - tap - changing one is the important mode. about this question readers can get a correct and detailed answer from this paper

    通過基本定義和有關名牌值進行了計算和分析，認為在正負極限檔，外加串聯調壓變的阻抗值相對額定檔的偏差很小，所以可不必在意這種變壓器整體阻抗的偏差值。
  2. Comprehensive identification and field treatment for common faults of load tap changer of power transformer

    基於概率神經網路的電力變壓器故障診斷
  3. If the filament transformer has a center tap, don ' t use it

    如果變壓器燈絲繞組有抽頭，請不要使用它。
  4. 66kv double windings, on - load tap - changing transformer

    66kv雙繞組有載調壓變壓器
  5. 110kv three windings, on - load tap - changing transformer

    110kv三繞組有載調壓變壓器
  6. 220kv three windings, on - load tap - changing transformer

    220kv三繞組有載調壓變壓器
  7. 66kv double windings, off - load tap - changing transformer

    66kv雙繞組無載調壓變壓器
  8. 500kv three windings, on - load tap - changing transformer

    500kv三繞組無載調壓變壓器
  9. 110kv double windings, on - load tap - changing transformer

    110kv雙繞組有載調壓變壓器
  10. 220kv double windings, on - load tap - changing transformer

    220kv雙繞組有載調壓變壓器
  11. First the paper use the different four network operating condition as the primary given conditions and set the 330 / 220kv transformer tap changer position in the standard position, adding the paralleled capacitor bank sets one by one into the network to change the amount of the input reactive power, thus obtained four sets of the 330kv and 220kv bus voltage and the active and reactive power losses changing curves

    進而研究了在每一確定並聯補償電容器組投入量條件下，隨聯變調壓檔位變化而產生出的一組並聯補償量、母線電壓與損耗的變化曲線。進而選出了隴南電網在四種選定電網運行方式下、有功損耗最小條件下的最優綜合控制組合曲線。
  12. Then the paper uses the same typical four network operating conditions as the primary given conditions and when adding one set of the parallel capacitor bank, changing the 330 / 220kv transformer tap changer position step by step to change the transformer ration, through this study methods this paper found out all the optimized combination of the tap changer position and the amount of input reactive power, also obtained four sets of the 330kv, 220kv and hokv s / s bus voltage and the active and reactive power losses changing curves. through analyzing the optimized combination control curve and the network power flow, the paper generalizes the rules as following : the chief measure of coordinative control is inputting shunt reactor in chengxian s / s in winter time both in the planning year of 2010 & 2005 ; in summer time in planning year of 2010 the chief measure is to input proper shunt capacitor

    本研究通過分析所獲得的最優綜合控制組合曲線及電網潮流，總結出了如下規則：隴南電網在2005年及2010年冬大、以及2005年夏小運行方式下，綜合控制應以成縣變投入適量並聯補償電抗器作為主要措施；在2010年夏小運行方式下則投入適量並聯補償電容器作為主要措施，再輔助以選擇合適的主變有載調壓分接頭來調節，達到控制網內無功潮流分佈合理、各變電站母線電壓在理想的范圍內時電網有功損耗最小，從而也提高了電網安全運行水平及供電質量。
  13. For the algorithm of reactive power optimization, presented in this paper, in order to found the linear programming model equations, the objective function is minimum total power losses, the controlled variables include the compensating capacity of reactive power, generator bus voltages and transformer tap positions, the state variables include reactive power of the generators, and the voltage amplitudes in the ends of transformers

    本文研究的電力系統無功優化演算法是以整個網路的損耗最小為目標函數，以無功補償設備出力、發電機端電壓和可調變壓器變比為控制變量，以發電機的無功出力和變壓器端電壓幅值為狀態變量建立了線性規劃模型方程。
  14. Based on examples, the problems in reinstallation process of oil pump, tap - changer and bushing after transformer maintenance overhaul are analyzed. the measures to prevent the problems are presented

    摘要以實例分析了變壓器大修后潛油泵、無勵磁分接開關、套管回裝過程中存在的問題，提出了防止類似問題發生的措施。
  15. The study bases on the four operating conditions of which the longnan network will be implemented in the year of 2005 and 2010. first, this paper calculates the power flow distribution that including the line charging reactive power and input of the low - voltage shunt reactor in chengxian s / s. assumed that the bus voltage of tianshui s / s and bikou power plant to be constant, the study count the voltage level of the 330kv and 220kv bus - bar when the 330 / 220kv transformer in standard tap changer position. in order to set control rules

    本文基於隴南電網在規劃發展水平年2005年及2010年的四種可能的運行方式下及潮流條件，計算出了計入線路充電無功及投入成縣變低壓並聯電抗器后的潮流分佈，在設定甘肅大網側及碧口電廠側母線電壓恆定條件下，計算了330kv及220kv主變在有載調壓標準分接頭變比下的330kv及220kv母線電壓水平。
  16. The transformer that use solid state relay to realize automated regulation is explored in this issues, it change the winding turn of once side according to the voltage of second side by on - load tap - changer. thus the purpose to realize automatic steady voltage

    本課題研製的應用固態繼電器實現的有載自動調壓變壓器，通過自動有載調壓分接開關根據變壓器二次側的電壓自動改變變壓器一次側的匝數，從而實現自動穩壓的目的。
  17. 220kv three windings, off - load tap - changing transformer

    220kv三繞組無載調壓變壓器
  18. 500kv three windings, off - load tap - changing transformer

    500kv三繞組有載調壓變壓器
  19. This paper mainly discusses a control method of substation voltage and reactive power. in order to get suitable decision for one day 24 hours tap - transformer ' s step switch and shunt capacitor switch, an approach of substation voltage and reactive power control on the basis of the combination of artificial neural network ( ann ) reactive power forecasting and evolutionary programming optimal decision - making is put forward

    論文主要研究變電站的電壓/無功控制決策問題，為了確定一天24小時內合適的有載調壓變壓器分接頭位置和並聯電容器投切狀態，提出一種基於人工神經網路的無功負荷預測和進化規劃優化決策相結合的變電站電壓和無功的綜合控制決策。
  20. The multiple tap transformer is the most common, because it is usually the least expensive

    多孔變壓器是最常用的方法，因為成本最低。
分享友人
分享到 Line

分享到臉書