target approach point 中文意思是什麼
target approach point
解釋
目標進入點-
This paper investigates the approach to estimate the maximum detection range of an infrared point - target against sky background based on the minimum resolved contrast ( mrc ) criteria
摘要基於最小分辨對比度準則，研究了天空背景下紅外點目標的最大探測距離估計方法。 -
First through poor quality analysis, conclude that it is necessary to strengthen quality inspection and quality control so as to reduce internal and external failure cost ; second through sorting and analysis of all non - conformance records happened before quality sustainable improve approach, make us understand it is crucial to strengthen quality sense, enhance bottom management and improve process capacity ; third through analysis of previous year compound quality level before quality sustainable improve approach, point out the compound quality level gap between byq tank shop and counterpart, make us feel quality crisis ; last in connection with byq company production volume development target, conclude it is inevitable for byq company to select the development pattern of reducing cycle time and improve output
首先是運用質量成本分析法指出油箱車間加強質量檢查和質量控制以減少內部和外部故障成本的必要性；其次是將油箱車間質量持續改進前一年所發生的所有產品不合格記錄進行了整理分析，使我們看到增強質量意識、加強基礎管理和提高工藝能力的迫切性；接下來計算分析了油箱車間質量持續改進前一年的綜合質量水平，找出了油箱車間與同行業者的質量水平差距以及與世界級製造商們的差距，使我們意識到質量危機感；最後針對整個byq公司以後的生產量發展目標，指出減少過程周期時間或增加過程產出是byq公司發展的必然選擇。 -
According to scattering phenomenology, we point out that the commonly used point scattering models fails to accurately describe the complex scattering behavior of real target. for that reason, based on the theory of effective scattering centers, researches are taken on more accurately physical - relevant description of target scattering and on approach that is more effective to characterizing and extracting target scattering features by means of time - frequency analysis and scattering centers modeling
全文以此為線索，以光學區散射中心理論為基礎，分別從目標二維像的散焦效應、二維像的時頻分析、以及二維散射中心的模型化這三個角度，探討對目標復雜散射特性進行更為合理的描述和分析，並提取可用於識別的目標結構特徵。 -
In this approach, an target pressure distribution is developed using a set of control point and require only global parameters as input. the chordwise locations and pressures of these points are then aptly adjusted during process to satisfy the flow and geometric constraints
本文根據總體設計參數用一系列控制點來生成目標壓力分佈，在設計過程中這些控制點的位置和大小可以適當調節以滿足流動和形狀約束。
分享友人