temperature control loop 中文意思是什麼

temperature control loop 解釋
溫度控制迴路
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  • control : n 1 支配，管理，管制，統制，控制；監督。2 抑制（力）；壓制，節制，拘束；【農業】防治。3 檢查；核...
  • loop : n 1 （用線、帶等打成的）圈，環，匝，框，環孔，線圈；【醫學】（常 the loop）宮內避孕環。2 環狀物，...
  1. Presents the steady - state programming with constant coolant average temperature and constant live steam pressure, an ideal programming for marine nuclear power plant ( npp ), under which, both the coolant average temperature and the live steam pressure of nuclear steam supply system ( nsss ) are constant when the steady state operating condition is varied, and points out that in comparison with the steadysate programming with constant coolant average temperature, the ideal programming can improve the overall operating performance of npp effectively, especially in low - load range, for instance, raise the heat efficiency of npp, decrease the operating noise of main coolant pump, and improve the conditions of design, operation and control of the secondary loop system

    雙恆定運行方案是船用壓水堆核動力裝置的理想運行方案.在這種運行方案下，當裝置穩態功率變化時，冷卻劑平均溫度與蒸汽壓都保持不變，與通常採用的冷卻劑平均溫度恆定運行方案相比，有效地改善了核動力裝置的總體運行性能，特別是在低負荷運行時，可以提高裝置經濟性、降低主泵運行噪聲、改善二迴路系統的設計、運行和控制條件，這對于提高船用核動力裝置的運行可靠性和安全性具有實際意義
  2. For example, the general system loop for a steam autoclave under computer control could consist of temperature / pressure sensors connected to a microprocessor which transmits commands to steam / vacuum control valves

    例如，計算機控制的蒸汽高壓滅菌器的常規系統迴路包括，連接到微處理器的溫度/壓力傳感器，來把命令傳遞給蒸汽/真空控制閥。
  3. This paper describes the designing principle and method of hardware and software of this system, especially discusses the precise control of the temperature and pressure in theory. we adopted the new method of intelligent pid parameters auto - tuning - - relaying pid auto - tuning. this kind of parameters auto - tuning technique fully abandons the operation of modeling and sub - modeling, and directly tune the parameters by investigating the close - loop capacity

    論文就該系統的硬體設計原理、軟體設計原理作了論述，特別對溫度和壓力的精確控製作了理論上的研究，採用了新型的智能pid參數自整定策略? ?繼電型pid自整定，這種控制器參數自整定技術完全摒棄了建模與建子模的運算，通過對閉環性能的測試，直接進行整定參數的操作。
  4. The closed - loop control of barrel temperature of precision injection molding machine

    精密注塑機料筒溫度的閉環控制
  5. In the matter - in - loop simulation experiment of aero - engine control system, the turbine outlet temperature, which characteristics with high and quick change, is hard to be simulated

    航空發動機控制系統半物理模擬試驗中，渦輪出口氣體溫度高、變化快，難以模擬。
  6. This new fuzzy optimization control method was applied to a superheated steam temperature control system, and simulation results verify the satisfactory closed - loop performance of the proposed fuzzy control system

    將這種新型模糊優化控制方法應用於過熱汽溫控制系統進行模擬，結果表明可以獲得非常滿意的閉環控制效果。
  7. 3. double closed - loop system for current and voltage, the protective circuits used to overvoltage, overcurrent, lack phase and water pressure, the closed - loop control for temperature can be achieved

    3電流電壓雙閉環系統，帶有過流，過壓缺相，水壓等保護，可實現溫度閉環控制。
  8. Secondly, during the braising offline temperature control loop of the oil production - lixiviating procedure, the controlled object, which is hard to build the extract model, has the characteristics of large inertial, big time - delay. the control strategy of the combination of fuzzy logic arithmetic and normal pid arithmetic is introduced in this paper, the basic principle and actualization method of fuzzy - pid are analyzed. the design model is simulated in matlab and the result proves good control performance

    其次，玉米油生產浸出工序的蒸脫機溫度控制迴路中，被控對象具有難以建立精確的數學模型，且具有大慣性、大滯后的特點，研究運用模糊控制演算法和經典pid控制演算法相結合的控制策略，分析了模糊pid控制演算法的原理和實現方法，並運用matlab軟體對設計的系統進行模擬，模擬結果表明，達到較好的控制指標。
  9. The air - fuel ratio closed loop control adjusts the air - fuel ratio near the theoretical value by controlling the supplementary air of supplementary valve based on the signals of oxygen sensor, running speed and water temperature and which is necessary condition for three - way catalyst converter to work more efficiently

    空燃比閉環控制是根據氧傳感器、轉速和水溫信號，控制化油器后補氣閥補氣將空燃比控制在理論值附近，為三元催化轉換器高效工作準備必要條件，使其最大限度降低尾氣排放。
  10. We provided acc and apc two modes for the close loop controlling of current. parameter fuzzy - pid is used to control the temperature

    鑒于溫度和驅動電流變化對激光器性能的影響，測試時需保證恆溫恆流。
  11. Double - loop digital light column display controller adopts advanced microprocessors for smart control, and it is suitable for display and control for many variables such as temperature, humidity, pressure, liguid level, instantaneous flow, speed, and so on, as well as can carry out the linear calibration with high accuracy for various non - linear input signals

    智能數字光柱顯示控制儀採用先進的微處理器進行智能控制，適用於溫度濕度壓力液位瞬時流量速度等多種物理量檢測信號的顯示及控制，並能對各種非線性輸入信號進行高精度的線性校正。
  12. The control system was modified two separate installations for performing tests on the test - bed. the control parameter of each device is complete same, as to temperature, pressure, rev and test time. the control mode of temperature, pressure and rev was closed loop

    它被改造為在主機上有兩個獨立的試驗裝置，它們的控制參量是完全相同的，分別為溫度、壓力、主軸電動機的轉速和性能試驗時間，其中溫度、壓力、轉速採用閉環控制的方式。
  13. By use plc, system can complete function as follow : this auto - control system be applicable to the temperature and smoke and dust the deal the variety quick, control the process is difficult with the operation is ; by the temperature controlor can automatically follow to the wet tower " exit temperature, error in the ? 3 v including ; by to automatically spray fog to lower the electric resistance, with the function for full the electricity equipment accepting the dust ; because of adopting feedback closed loop, and come to a to respond to the speed quick, constant temprature control the accuracy is high ; because of adopting the sensors, and make the system circumstance to leak water quick ; system have many control parameter can set exit control temperature and adjust value low limit by key ; can communication with remote computer and have remote control

    通過使用plc ，使該自控系統可以完成如下功能：適用於溫度及煙塵量變化快、控制過程難以操作的場合；通過溫控表自動跟蹤增濕塔出口溫度，誤差達到3以內；通過自動噴霧來降低粉塵比電阻，以此充分發揮電收塵器的作用；由於採取了閉環反饋迴路，達到了響應速度快，恆溫控制精度高；通過使用各種檢測傳感器，使得異常情況泄水快；該自控系統具有多套控制參數，增濕塔出口控制溫度及調節閥下限值可通過按鍵設定；可與上位機通訊，具有「現控遠控」功能。
  14. Study of stirling cryocooler temperature closed loop control system

    斯特林製冷機溫度閉環控制系統的探討
  15. The design had friend human - computer interfaces to monitor the field situation, realized the high precision temperature control with the pid - fuzzy control method, realized the high precision control for motor combining plc with closed - loop control and tension - monitor on - line of variable frequency drives, avoid the hard border and overlapping yarn by four grades stroke modification and changing winding angle incessantly

    利用友好的人機交互界面，實現強大的監控管理功能；利用pid模糊控制實現熱箱溫度的精確控制；採用plc結合變頻器閉環控制和在線張力監測實現電機的高精度控制；通過四級動程修正和持續改變卷繞角，防止硬邊和疊絲。
  16. Based on the characteristics of the giant magnetostrictive material, this article designs giant magnetostrictive micro - displacement actuator, and primary research contents are as follows : establishing drive magnetic field structure, designing closed loop control system, constant current source, temperature control system, magnetic field perceptual system and doing experiment testing

    本文根據其工作特性設計了一種基於超磁致伸縮材料的微位移驅動器，主要研究內容包括:建立閉環控制系統、設計驅動磁場結構、恆流源驅動電路、溫控系統和磁場感知系統以及系統性能的實驗測試。
  17. Secondly, a close - loop controller based on pid control rule is designed. open - loop model identification, close - loop experiments of the temperature simulation system and aero - engine model tracing experiments are accomplished

    其次，論文設計了基於pid控制規律的閉環控制器，初步開展了溫度模擬系統開環模型辨識、閉環試驗以及發動機模型溫度跟隨試驗。
  18. The design of the software and hardware of both the measurement of temperature, air flux and pressure and the open loop control is finished in this thesis

    對溫度、流量和壓力測量的軟、硬體進行了設計，對目標溫度和流量的開環控制的軟、硬體進行了設計，成功的實現了開環調節。
  19. In addition to the normal control of angle - executor ， the controller combines the measuring of temperature or pressures with the control of the angle - executer to form two closed - loop

    除了完成對角驅動器的一般控制外，還把對角驅動器的控制和對溫度或壓力的測量結合起來，形成兩個閉環控制迴路。
  20. Aiming at drawbacks that environment simulate test laboratory ( estl ) ' s control precision is being dropped, the system digital simulation, the system characteristic analysis is proceeded ; basing on it, intelligence pid control processor, integral desaturation pid control processor, leading adjust control processor ( leading adjust of point of inflection of curve ) is planned, double loop control processors of low temperature system is consummated, so, the new control scheme and control program is formulated ; moreover through control program " simulate debugging and environment simulate test, 18 experimental curves and 19 experimental items is fulfilled totally. it proved that estl ' s control system and control program are successful. experimental result makes it known that the new control plan solves the problem of low control precision

    本論文針對環模室原控制系統存在的控制精度下降等問題，進行了系統模擬及環境模擬系統特性分析，在此基礎上，設計了智能pid控制器、抗積分飽和的控制器、預估補償控制器、完善了低溫系統的雙迴路控制，制定了新的控制方案和控製程序組態，並對其控製程序進行模擬調試及結合實際試驗對其控制系統進行驗證；共計完成了18條曲線， 19個項目的試驗，對其控制系統及控製程序進行了充分的考驗。
分享友人
分享到 Line

分享到臉書