temperature dependent 中文意思是什麼

temperature dependent 解釋
隨溫度而變的,溫度依賴性的
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  • dependent : adj. 1. 依靠的，依賴的。2. 從屬的，隸屬的，【語法】從屬的。3. 由…決定的。4. 下垂的，懸吊的。n. 1. 受贍養者，靠人生活的人。2. 扈從，侍從。3. 依存[從屬]物。
  1. Human liver glutathione - s - transferase m1 gene cloning and temperature - dependent expression in e. coli

    1基因的克隆及在大腸桿菌的溫控表達
  2. We obtained a high quality zno thin film with the pl fwhm of 94 mev at 900. the free exciton binding energy deduced from the temperature - dependent pl spectra is about 59 mev at 900, suggesting that the film quality can be improved by annealing process

    當退火溫度為900時獲得了高質量的氧化鋅薄膜，光致發光譜的半高寬為94mev ，通過變溫實驗得到激子束縛能為59mev ，表明退火過程提高了薄膜的質量。
  3. After our careful analysis, we find that there are finite part which is temperature dependent in this zero - point energy. so we have separated this part and discussed its influence to the effective nucleon mass. the result shows that this part has remarkable contribution at high temperature

    但經仔細分析會發現，零點能中含有與溫度相夫的有限部分，我ilte它分離出來並討論了其xde子有效質量的影響，發現在高溫下，這一零點s眶正有著顯著的貢獻
  4. A mixture of three amino acids ( arg, gly, glu ) labeled with fluorescein isothiocyanate ( fitc ) was separated in pdms microfluidic chip, the separation voltage is 200v / cm, the separation time is less than 120 seconds ; according to ccd fluorescence images, two distinct physical processes - stacking and destacking during sample injection were studied qualitatively ; rhodamine b, a kind of temperature - dependent fluorescence dye, was used as probe to develop a temperature - fluorescence intensity equation, then temperature - color map in microchannels was constructed, and temperature trait in microchannels on the pdms microfluidic chip was analysed. according to the results, we conclude that the electric field applied to the pdms microfluidic chip should not exceed 400v / cm

    利用pdms微流控晶元對fitc標記的精氨酸、甘氨酸、谷氨酸混合物進行了電泳分離，分離電壓為200v cm ，分離時間不到120秒；通過拍到的熒光顯微圖像對電泳注樣過程中復雜的樣品分子積聚與解聚現象作定性的分析；以熒光染料rhodamineb為溫度熒光探針，建立了pdms微流控晶元上的溫度-熒光強度的關系公式，並利用matlab圖像處理工具箱構建出微流體溝道內的溫度色圖，對pdms微流控晶元的微流道溫度特性進行了分析，根據實驗結果，我們認為對于pdms微流控晶元來說，在進行需要外加電場作用的試驗時，外加電場不應超過400v cm 。
  5. The dynamics is described by the glauber - type stochastic progress with the single - spin transition meehanism and disposed approximately by weighted average method in which we add a corresponding weight to each possible configuration. we obtain not only the exact analytical solutions of the time dependent magnetization and equal time spin - pair correlation functions, but also the analytical temperature dependent dynamical relaxation function

    通過採用加權平均的近似處理方法，也就是對各種可能出現的躍遷幾率賦一個相應的權重，我們不僅可以得到隨時間演化的磁化強度和等時對關聯的解析解，還得到了系統馳豫時間的溫度解析函數。
  6. The capacity factor, which governs resolution, retention times, and column efficiencies of components of the test mixture, is also temperature - dependent

    容量因子與柱溫有關，決定分離度，保留時間和柱效。
  7. The temperature dependent pressure change of this instrument is taken through a capillary tube to a display unit

    儀器中用一根毛細管將溫度產生的壓力變換傳遞到顯示單元。
  8. Plasticity and temperature - dependent character of material properties were employed, the deformation and stresses of the specimens were analyzed using the finite element method ( fem )

    在有限元分析中，考慮材料的塑性變形以及物理性質隨溫度變化的情況，模擬實驗過程中應力和應變的時空分佈，模擬結果與實驗觀察現象和結果吻合良好。
  9. Triggering element is a semiconductor temperature sensor, whose temperature - dependent altered signals bring about changes in the switching state with the help of amplifiers and or electronics

    觸發元件是一個半導體溫度傳感器，隨溫度變化發出信號，並通過放大器或者和電子信號改變開關狀態。
  10. We first expand the nonlinear temperature - dependent convective and radiative heat transfer coefficient about the ambient temperature by taylor - series method, and then the crystal temperature and the pull rate as well as the bulk melt temperature are determined by the perturbation techniques in a simply analytical manner

    分析之過程為首先將隨溫度變化之對流系數及輻射系數做泰勒級數展閉，再以攝動理論之技巧，同時求解晶圓棒之溫度、拉伸速度及溶解液之溫度。
  11. So this question must be solved at first. a variety of factors which influence cte mismatch induced thermal stresses such as fiber array, temperature dependent material properties, composites fabrication temperature and pressure has been discussed. on the other hand, the temperature gradient induced thermal stresses is also analysed and factors such as heat treatment conditions, composites fabrication temperature and pressure to influence the stresses are investigated

    本文首先利用ansys模擬基體材料分別處于理想彈性應力狀態和理想彈塑性應力狀態時，各種因素諸如纖維排布模式、模量等性能參數是否隨溫度變化以及復合材料制備溫度和壓力對熱膨脹系數不匹配誘導熱應力的影響；另外，我們也對溫度梯度誘導熱應力進行了一定的研究，分析了各種熱處理工藝以及材料制備溫度、壓力對它的影響。
  12. Temperature dependent material properties as tabulated data, an excel equation, a c c, fortran or basic function or subroutine, abaqus or ansys formats

    -國內從事材料科學技術研究和產業的科技工作者和單位成立的全國性非營利性法人社會團體。
  13. 4. photolumescence and micro - photoluminscence of cdznse qw / znse / cdse qds with different znse barrier thickness was studied to investigate the influence of tunneling on excitonic combination in quantum well and quantum dots. we studied the temperature dependent of the excitonic recombination

    通過cdse量子點znse cdznse量子阱結構在不同壘層厚度情況下的發射譜和變溫激子發射譜，研究了激子隧穿過程對量子點和量子阱中激子復合的影響。
  14. Then the mathematical problem of nonlinear heat diffusion with temperature dependent thermal conductivity has been derived during laser irradiation of two - layer structures. to solve this problem, a kirchhoff transformation and further time variable transformation has been used

    於是，文中還用有限容積法將溫度場定解問題離散化，選擇合適的空間網格和時間網格，通過matlab編程實現對四維溫度場的數值模擬。
  15. The temperature - dependent change in volume of an inert gas is transferred via a capillary line to a spiral bourdon spring, which by means of defined bending causes a pointer to be rotated

    惰性氣體隨溫度變化而產生的體積變化通過一個毛細管傳導至一個螺旋波登彈簧，它的彎曲導致指針的轉動。
  16. An improved formula based on huang ' s empirical formula was proposed to calculate the effective permittivity of chemical reaction at any temperature and reaction time by means of the temperature dependent number of molecules per unit volume of reaction solution

    基於反應溶液中單位體積內的分子個數隨溫度變化的情況對黃卡瑪提出的經驗公式進行了改進。
  17. Incubation lasts anywhere from 24 - 28 days, and seems to be temperature dependent

    孵化期為24 ? 28天，具體取決于溫度條件。
  18. The morphology of znte : cu is also cu concentration and annealing temperature dependent

    Znte （ znte ： cu ）薄膜的形貌依賴于摻銅濃度和退火溫度。
  19. A low temperature option using liquid nitrogen is available, the nitrogen consumption is minimized by employing a temperature dependent control of the nitrogen flow

    氮損耗的最小量是通過利用溫度依賴對氮流量進行控制的。
  20. In the light of the interaction of oil ， pipeline and ambient media and their unstable heat transmission ， considering temperature dependent on physical properties and phase change of oil ， a mathematical model for thermal calculation is presented

    針對加熱原油管道停輸后油品、管道及周圍介質的相互關系和它們的不穩定傳熱，提出了熱力計算的數學模型。
分享友人
分享到 Line

分享到臉書