terminal called 中文意思是什麼

terminal called 解釋
被呼叫的終端
  • terminal : adj 1 終端的,終點的,結尾的;極限的。2 定期的,每期[季]的;每學期的,學期終[末]的。3 期終的;末...
  • called : 被呼叫的
  1. This velocity is often called the terminal velocity.

    這個速度常常稱為收尾速度。
  2. The paper focuses on the old bank system using multiplexer to link terminals into network that can not meet the need of the banks and advances a new terminal accessing method which is called router ' s dumb terminal accessing technology

    本文針對銀行原來的多路復用器終端接入方式不能滿足銀行業務發展的需要而提出了一種新的終端接入方式即路由器啞終端接入方式。
  3. The relation between terminal voltage and terminal current is called a terminal characteristic.

    輸出埠電壓和輸出埠電流間的關系稱為外特徵。
  4. To overcome the shortcomings of the traditional patrol work and to increase the convenience and availability of patrol work, the thesis summarizes others work and improves the original patrol management programme. and the thesis designs a system terminal called " intelligent patrol work and environmental monitoring system ( bvstm ) terminal "

    為了克服傳統巡檢工作的諸多弊端和提高巡檢工作的便捷性、有效性,本文總結了前人針對該系統所做的工作,設計了「基站巡檢及機房環境監控系統( bvstm )終端」 。
  5. But calcium in high leels within a nere cell can be toxic, so the researchers discoered another purpose for the sodium pump : powering a protein located on the nere terminal membrane called the sodium - calcium exchanger, which remoes the calcium and replaces it with sodium

    但高鈣對神經細胞具有毒性作用,因此研究人員發現鈉泵的另一個作用,是供能給位於神經末梢細胞膜上的一種稱作鈉鈣交換器的蛋白。
  6. Compared with conventional methods, the proposed method is not disturbed by reflected waves from tee joints or other resistance discontinuities, and is not influenced by fault type, and can recognize the reflected wave from the fault point even when the fault point is near to the measuring terminal ( so - called dead - zone ), and simultaneously, the method reduces the influence of wave speed uncertainty

    與傳統的行波測距方法相比,這種方法不受電纜分支接頭或其他阻抗不匹配點反射波的干擾,不受故障類型的影響,在近區也不存在無法識別反射波的問題,同時也減少了波速不確定性對測距精度的影響。
  7. The embedded dsp ethernet terminal system ' s software / hardware scheme, called as ethernet over dsp, is proposed. we present the scheme ' s hardware - circuit principles and software - realization processes in detail. at the same time, aiming at the pc ' s data exchange with the ethernet terminal, this thesis analyzes and expatiates socket mechanism, presents pc software realization methods and an expandable program frame

    論文在對ip 、 arp 、 udp等網路通信協議深入分析基礎上,對協議進行合理精簡,詳細論述了簡化后協議在嵌入式dsp終端的具體實現方法,並設計和提出嵌入式dsp以太網終端系統軟硬體方案? ? 「 ethernetoverdsp 」方案,給出該方案的具體硬體原理和軟體實現機理;同時針對pc機與終端系統的數據交互問題,剖析和闡述socket運行機制,給出實際的pc機軟體實現步驟和可擴展性應用框架。
  8. On the study of researches on performability, this dissertation integrates the performance why reliability on components ' level, and presents approaches for analyzing throughput rates of component and terminal - pair, which are just their effectiveness. they can be used for analyzing nonhierarchical and hierarchical network, and even all entwork considering the called - busying. this is just the analysis of the effectiveness of network

    此方法也可嵌入到迭代法用於分析無級網、有級網,在考慮被叫忙時的整個網路的業務性能,從而分析了網路的完成性指標有效度。
  9. In order to simulating rapidly and analyzing the dynamic behavior of the whole mems but not reducing accuracy significantly, the terminal behavior of multi - terminal components was modeled as reduced - order model ( or called macromodel ). upon the finite element model theory micro - mechanical devices or components were modeled in the spatial, which afforded theoretic foundation and technical support to mems system - level design

    為了便於在不顯著影響精度而能快速地模擬與分析mems整個系統動態行為,通過器件或組件的降階模型(或稱為宏模型)方法描述了多埠組件的埠行為,並採用有限元模型理論在三維空間內建立了微機械器件或組件宏模型,為系統級設計所需要的組件庫的建立提供了理論基礎和技術支持。
  10. Note : the bus terminal is located near the electronic appliance store called yodobashi camera. the ticket office is in the yusuda seimei building on the ground floor

    注意:公共汽車總站位於一著名的日本電器連鎖店yodobashi camera附近售票處設在yusuda seime大樓的底層。
  11. On the study of network traffic performance, this paper presents an approach for calculation the terminal - pair rate when routes may have more than two links and node may block. the method can be embedded in the recursion method for analyzing the performance of nonsidering the called - busying

    對于網路業務性能的研究,本文提出了一種計算多鏈路路由和節點可能擁塞下的節點對業務接通率的方法,此方法可嵌入到迭代法用於分析無級網、有級網,在考慮被叫忙時的整個網路的業務性能。
  12. " thank god, thank god. . i called the embassy and we were very well - received, " al - harby told saudi tv in the airport terminal

    「感謝上帝,感謝上帝… …我告訴了使館,我們獲得了優待。 」阿哈比在機場對沙特電視臺說。
  13. The mobile terminal ( mt ) having the function of ieee 802. 11 will be called enhanced mt. the enhanced mt which provides the concentrated control for other mts will be called hc, which id is usually substituted by access point ( ap )

    具有ieee802 . 11e功能的移動終端( mt )被稱為增強型移動終端,為其他mt提供集中控制的增強型mt被稱為混合協調器( hc ) , hc通常由ap來擔任。
分享友人