test voltage 中文意思是什麼

test voltage 解釋
測試電壓
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  • voltage : n. 【電學】電壓，電壓量，伏特數。 the working voltage （電氣的）耐壓限度。
  1. The lightning impulse breakdown and steep - front impulse breakdown test of silicone rubber are also performed, which give a reference for other so lid materials. the result of this research also will give a reference to revises the standard of steep - front wave impulse voltage test

    為了配合本課題的研究還做了硅橡膠材料的雷電沖擊耐受強度和陡波沖擊耐受強度試驗，這兩個試驗對了解其它固體材料的雷電沖擊系數和伏秒特性也具有參考價值。
  2. Insulating liquids - determination of the breakdown voltage at power frequency - test method

    絕緣液體.電源頻率擊穿電壓的測定
  3. Single range voltmeters are normally calibrated at cardinal points ( maximum 10 test points ). for multi - range voltmeters, the basic calibration will include measurements at full ranges and linearity check at 5 voltage levels for one range. linearity check for other ranges can be offered at extra cost

    單量程電壓表一般以基點（最多十個測試點）進行校正；多量程電壓表的基本校正則會包括全量程測量及按五個電壓量位為一個量程進行線性檢查。
  4. Anti - seismic characteristic test for high - voltage switchgear

    高壓開關設備抗地震性能試驗
  5. Diesel generator voltage characteristic test

    柴油發電機電壓特性試驗。
  6. A motor that is be directly coupled to a fan - blade or blower - wheel load is to be operated at the applicable test voltage and under no - fan, no - load conditions with the shaft running free

    直接耦合到一個風扇葉片或鼓風機葉輪負荷的馬達，將在適用的試驗電壓下做無風扇，無負荷，軸空轉狀態的運行。
  7. It compares and analyses the equipment test voltage emendated to standard atmosphere conditions with the equipment nominal withstanding voltage. and then it concluded that : the emendation value educed by " humidity ratio " integrated emendation method is basically equal or close to the equipment nominal withstanding voltage ; but the values by two traditional emendation methods are mostly higher. it also proves that, " humidity ratio " integrated emendation method is more perfect than any other methods, and it can reflect the influence degree of atmospheric parameters on electrical equipment outer insulation discharge voltage actually

    文中選擇「比濕」綜合校正法和兩種傳統校正法，分別對西高所為羊八井、拉薩、羊湖110kv變電所設備所做的人工氣候室模擬試驗數據及雲南中試所做的zs - 110工頻放電電壓試驗數據進行校正計算，將試驗電壓的校正值與試驗設備的標稱耐受電壓水平進行比較分析；認為： 「比濕」綜合校正法的校正值與設備耐受電壓水平基本相等或接近，而兩傳統校正法的校正值大多高於設備耐受電壓水平；進一步證明， 「比濕」綜合校正法是目前諸多校正法中較為完善的，能真實地反映大氣參數對電氣設備外絕緣放電電壓的影響程度的校正法，在高海拔電力工程設計中應推廣應用。
  8. Ohmic resistance measured between the connecting lines and the transducer s deformation body, with statement of the test voltage used

    在使用校驗電壓時測得的連接線路和轉換器變形體之間的電阻歐姆。
  9. Inductive voltage dividers ( ivd s ) will be calibrated by comparison with the laboratory s 8 - dial ivd, normally at specific frequencies of 400 hz, 1 khz and 10 khz with an input test voltage of 25 v. the calibration normally involve measurement of voltage ratio ( magnitude ) of the output voltage related to the input voltage of the ivd

    感應分壓器一般按400hz 、 1khz及10khz等指定頻率及25v的輸入測試電壓，透過與本所的八刻盤感應分壓器對比而進行校正。校正工作一般包括測量該感應分壓器輸入電壓與相對輸出電壓的電壓比（幅值） 。
  10. To test passive components, the tester places a test voltage across the component under test and measures the current

    在測試無源器件時，測試設備對被測試的器件施加一個測試電壓后，測量電流。
  11. Test voltage terminal to case : 2000vac for 60s

    額定電流的130 %試驗電壓：
  12. Insulating test voltage

    絕緣試驗電壓
  13. Spark test voltage values given by thepotential difference between the test electrode and the conductor of the coreor cable under test shall be specified in the cable standard

    火花試驗時，電極與被測試電線或電纜之間的電位差的值在電線標準中有明確規定。
  14. On the base of the iec standard of dc suspension insulators, we designed a new ion migration test for 500kv dc ceramic support insulators, including the regulation between the bulk resistance and the temperature, the test samples, the test voltage and the temperature for long - term ion migration test, and the amount of accumulative charges

    以懸式絕緣子離子遷移試驗標準為基礎，完整的設計了500kv直流支柱式瓷絕緣子離子遷移試驗，其中包括研究了試品體積電阻隨溫度場強變化的規律，成功的設計了試驗試品，確定了長期離子遷移試驗電壓（ 40kv ）和試驗溫度（ 130 ） ，計算了50年累計電荷量（ 0 . 173c ） 。
  15. Clients may specify their required test voltage between 100 v and 1 kv

    客戶可在100v至1kv內指定其所需的測試電壓。
  16. Measurement of resistance of the same resistor at each additional test voltage

    按每一額外測試電壓，測量同一電阻器的阻力。
  17. Measurement of each voltage ratio at an additional test voltage and at one polarity

    按一額外測試電壓及電極，測量每一電壓比。
  18. Calibration for the same range at a different output test voltage ( 5 test points )

    校正同一量程的不同輸出測試電壓（五個測試點） 。
  19. Calibration for each additional range at the same output test voltage ( 5 test points )

    校正同一輸出測試電壓的每一額外量程（五個測試點） 。
  20. Measurements of voltage ratios are generally made at rated voltage of the divider but the maximum test voltage will be limited to 30 kv

    電壓比測量工作一般按分壓器的額定電壓進行，但最高測試電壓不得超過30kv 。
分享友人
分享到 Line

分享到臉書