thermal process curve 中文意思是什麼
thermal process curve
解釋
熱力過程曲線-
Therrnogravimetric analysis at heating rates 5, 10, 15 and 20 c / min was used to study the decomposition kinetics of the pdms / pma ipn in ni and in air by using tg and dtg, and the upper limit of the temperature was 700 c. it was found that ipn began to decomposite at 350 c. the process of the thermal degradation was multiple steps, the curve of the rate of thermal decomposition had two peaks, one of which lied between 400 c ~ 420 c and the other lied between 500 c ~ 540 c, the result corresponded to the components of ipn
在熱分解動力學研究中，通過在兩種氣氛中，分別以5 、 10 、 15和20 min四種升溫速率條件下，採用tg - dtg聯動測試， ipn材料在350開始熱分解。熱分解速率存在兩個峰值，一個分解峰值在400 420之間，另一個在500 540之間，這與ipn結構中包含兩組分相對應，同時發現當緩慢升溫時，特別是在空氣氣氛中，兩個分解峰減弱，熱分解趨向於一個連續過程。 -
Path of uhpm consists of two curves, i. e., a barrette - like curve reflecting the process of cold slab subduction and exhumation cold overthrusting, and a crescent curve representing the thermal exhumation after slab breakoff
軌跡由兩部分組成，即反映板片冷俯沖冷折返過程的發夾狀曲線和指示板片斷離拆沉熱折返過程的新月形曲線。 -
In order to monitor on - line expansion difference during operation for lai cheng power plant in shandong province, this paper not only describes the realization of data acquisition, but also gives curve of rotor thermal stress according to stress caculation. furthermore improve traditional warming process. it can be observed that by means of the on - line system the start - up duration has been decreased for no. 1 unit of lai cheng power plant start up
並依據萊城電廠機組的實際情況，經過理論計算給出了機組不同溫升率下的熱應力曲線，對傳統暖機過程進行了一定的改進，可縮短啟機時間，經萊城電廠1機組大修后冷態啟動檢驗完全符合實測值，證明本系統在實際運用中具有廣泛的推廣價值。 -
In the paper, how to simulate itr is introduced in details. and with the theory, the itr of ar - kr is simulated under the temperature of 40k. at last, the simulation curve reproduces the movement process of the thermal stream in interfacial layer visually and intuitively
本文詳細的介紹了界面熱阻的分子動力學模擬原理，並模擬獲得了溫度為40k時ar - kr的界面熱阻，直觀、形象的從微觀的角度再現了該界面層的熱流變化過程。
分享友人