thermal properties 中文意思是什麼

thermal properties 解釋
熱特性
  • thermal : adj. 1. 熱的,熱量的,溫熱的;由熱造成的。2. 溫泉的。n. 【航空】上升暖氣流。adv. -ly
  • properties : (特性)命令修改特性
  1. Methods of testing plastics - thermal properties - determination of the thermal stability of polyvinyl chloride by the congo red method

    塑料試驗方法.第1部分:熱性能.試驗方法130a :剛果紅法測定聚氯乙烯熱穩定性
  2. Study of the thermal properties of the epoxy resin cyanate ester co - curing system

    氰酸酯共固化體系熱性能的研究
  3. Study on the thermal properties of industrial hemp

    大麻纖維性能及其產品的研製生產
  4. We consider the macroscopic thermal properties of the gas throughout the interstellas region ionized by an exciting star or group of stars.

    我們將考察被一顆或一群激發星電離的星際區域中各種氣體的宏觀熱力學性質。
  5. The thermal properties of medium silicon - molybdenum vermicular iron are about three times of that of normal vermicular iron, so it is an ideal material for producing manifold

    中硅鉬蠕鐵的抗熱疲勞性能為普通蠕鐵的3倍,因而是製造排氣歧管的理想材料。
  6. Method of testing to determine the thermal properties of insulated heating tubes hot water circulation procedure

    測定隔熱管熱性能的試驗方法
  7. For understanding thermal stabilities of woo - montmorillonite ( mmt ) composite ( wmc ), thermal properties of wood, wood - phenol formaldehyde resin composite ( wpc ) and wmc were analyzed and compared using thermal analysis ( ta )

    摘要為了了解木材蒙脫土復合材料的熱穩定性,本文利用熱分析方法對木材、木材酚醛樹脂復合材料、木材蒙脫土復合材料進行了對比分析。
  8. While successfully used in measuring the thermal properties of solid material, such as bulk samples and thin films, 3 method is seldom applied to the fluid

    摘要3法已成功應用於體態、薄膜等材料導熱系數的測量,但還很少應用於流體領域。
  9. Methods of testing plastics - thermal properties - cold crack temperature of film and thin sheeting

    塑料試驗方法.第1部分:熱性能.試驗方法150d :薄膜與薄片冷裂溫度
  10. Tem images revealed that the phase morphology of pls composites were influenced by the interaction among the matrix, the compatibilizer and organo - mmt. hence, a novel mesophase " " silicate sheet cluster " was also found in ldpe / eaa / mmt nanocomposite. the mechanical, barrier and thermal properties results of ldpe / mmt composites indicated that,

    對ldpe mmt納米復合材料的力學性能、透氣性能以及熱力學性能的研究結果表明,插層型或剝離型pls納米復合材料的力學性能取決于基體、相容劑在硅酸鹽片層表面的相容性。
  11. Eev should be selected for various refrigeration systems according to the thermal properties of refrigerants ; the discharge coefficient of eev is sensitive to the aperture and impulse quantity of eev ; when the eev structure is made, the discharge coefficient goes up with the lowering of evaporation temperature or goes down with the hoisting of the condensation temperature. it is le

    對于不同工質的冷藏集裝箱製冷系統,電子膨脹閥應該根據具體製冷劑的熱力性質選取;電子膨脹閥流量系數對孔徑和脈沖數比較敏感;在結構固定時,流量系數隨蒸發溫度的降低而升高,隨冷凝溫度的增加而增大,受過冷度變化的影響較小;電子膨脹閥的容量受孔徑影響最大。
  12. Methods of testing plastics - thermal properties - determination of the thermal stability of polyvinyl chloride by the conductometric method

    塑料試驗方法.第1部分:熱特性.方法130c :聚氯乙烯耐熱性的電導測量方法
  13. Point heat pulse method for measuring thermal properties of bio - fluids

    點熱源熱脈沖法測算生物流體的熱物性參數
  14. Traditional hydronic sizing methods can be used for selecting pumps, expansion tanks, heat exchangers, and air removal devices, as long as the heat transfer liquid ' s thermal properties are considered

    傳統的液體循環加熱體量法在泵、蒸發器、熱交換器和空氣移動裝置的選擇中可以應用,在考慮載熱流體的熱血特性的情況下。
  15. Methods of testing plastics - thermal properties - flammability of a small, inclined test piece exposed to an alcohol flame laboratory method

    塑料試驗方法.熱性能.小型傾鈄試片置於酒精火焰上的可燃性
  16. The following definition to thermal properties and introduction to the theory of heat transfer are not intended to give an exhaustive treatise of these subjects.

    下面引入的某些熱性質定義和傳熱理論的初步概念都不準備作無止境的論述。
  17. Thermal properties of various bentonites

    我國各地膨潤土的熱性質
  18. Study on thermal properties of mg zn al hyrotalcite - like materials and the hydration of their decomposition products

    類水滑石的熱性質和水化性能研究
  19. The heat conduction and combustion of polymer materials are reviewed ; the relationship between the thermal properties and flame retardancy of the polymer are discussed

    摘要概述了聚合物的熱傳導及燃燒;討論了熱性質與聚合物阻燃的關系。
  20. 1100 1902 - 503 methods of testing refractory materials - refractory and thermal properties - determination of thermal expansion horizontal method to 1100 c method 1902 - 503

    耐火材料試驗方法.第5部分:耐火和耐熱性.第3節:熱膨脹性測定
分享友人