thermosyphon 中文意思是什麼

thermosyphon 解釋
熱虹吸管
  1. The influence of the vapor amount from the controlled evaporation area to the performance of the thermosyphon is studied theoretically

    本文從理論的角度，定性地分析了受蒸發面積控制的蒸汽生成量對熱虹吸管啟動性能的影響。
  2. The optimum inclination angle is between 15 ~ 20, the length of thermosyphon will not change the phase - change heat transfer coefficient of the evaporation section and the condensation, which will enlarge heat transfer area of thermosyphon and increase the heat exchange capacity. the head - on speed of wind only stranger the heat transfer of the evaporation section and the condensation section. the experiment shows that the mathematic model closely fits to the thermosyphon, moreover, the one key to resolve the thermosyphon effect lies in decreasing the thermoresistance of evaporating section and condensation section. this study can provide directions and experience in the future research

    傾斜角越大，熱虹吸管總熱阻越大，最佳傾角在15 20之間;充液率過多或過少都會對傳熱性能產生不利影響，對于本實驗採用的1 . 75m 、 2m 、 2 . 5m 、 3m熱虹吸管，最佳充液率在20 % 35 %之間;管長對傳熱也有影響，管長不改變熱虹吸管蒸發段和冷凝段的換熱系數，只增加了熱虹吸管的換熱面積，增大換熱量;迎面風速的大小，起到強化熱虹吸管蒸發段和冷凝段換熱的目的。
  3. On the basis of present papers about semi - open thermosyphons, the heat transfer characteristics of the turbulence semi - open thermosyphon ( tsot ) were investigated both experimentally and theoretically

    在前人有關重力熱管和半開式重力熱管的試驗研究和理論研究的基礎上，本文對一種新型的熱虹吸管進行了傳熱性能研究。
  4. The main results in this paper are as follows : ( 1 ) study on starting up performance of thermosyphon : according to the study on the states before and after starting up of thermosyphon with the various filling amount, it is considered that the phase change heat transfer inside the copper - water thermosyphon with a large ratio of length and diameter is not only influenced by the boiling degree of superheat, but also controlled by evaporation and companied with the boiling of the thin liquid film

    本文的主要研究結果為： （ 1 ）熱虹吸管啟動性能的研究：通過對從不同充液量、啟動前狀態、內部汽化核心狀態對啟動的影響所進行的試驗研究，認為大長徑比的銅?水熱虹吸管管內相變不僅僅為沸騰，而是以蒸發為主，伴有薄液膜的沸騰。
  5. Abstract : visual experiment was carried out for the enhanced boiling heat transfer in evaporation region of thermosyphon. analysis had been carried out to test the results. a physical model describing an enhanced boiling heat transfer in evaporation region were proposed based on the analysis results, thus providing theory references for development of heat pipe technology

    文摘:通過對熱虹吸管蒸發段強化傳熱進行可視化實驗研究並對其結果進行分析討論，在此基礎上建立了熱虹吸管蒸發段強化傳熱物理模型，為熱管技術的發展提供理論依據
  6. According to the working condition of electronic element, a testing system established to test the temperature variety of the electronic element surface on several kinds of radiator which designed on different structure under different working condition. on the basic of the experimental results, integrated theoretical model established which include three part : heat simulation copper block, two - phase closed thermosyphon and heat sink

    根據電子器件的運行工況，建立了散熱器性能測試系統，並對所設計的不同型式的熱管型電子器件散熱器進行了在不同工況下的性能實驗，比較了在熱流密度、風速、風溫等實驗工況發生改變的情況下各型式的熱管型電子器件散熱器中電子器件表面溫度的變化規律。
  7. Experimental study of the reduced reverse circulation in thermosyphon solar water heater

    防倒流循環家用太陽能熱水器的實驗研究
  8. As a typical power electronic module, igbt has the same thermo design request as other high power electronic devices. based on consulting a number of references, the performance of thermosyphon, which is the key component of heat pipe heat sink for igbt, is studied, and the heat pipe heat sink for igbt is developed and researched with the approach of combining the theoretic analysis and the experiment study

    作為典型的大功率電子模塊igbt ，具有與其它大功率電子元器件相似的熱設計要求，本文針對igbt ，在查閱大量相關文獻的基礎上，應用理論分析和試驗研究相結合的方法，系統地研究了此散熱器中的傳熱核心元件? ?熱虹吸管的性能，並開發研製熱管式igbt散熱器。
分享友人
分享到 Line

分享到臉書