thickness of bed 中文意思是什麼
thickness of bed
解釋
地層厚度-
Downhole temperature profiles have been simulated under different conditions of fluid output, production time, off production time, formation parameters, geothermal gradient, bed thickness, welibore radius and so on, and simulation results are analyzed and discussed
本文模擬了產液量、生產時間、停產時間、地層參數、地溫梯度、層厚及井筒半徑等不同條件下的井下溫度場分佈，並對模擬結果進行了分析和討論。 -
The relation between outcrop width and thickness depends on the dip of the bed, the slope of the ground, and the direction of traverse.
露頭寬度與厚度的關系取決于巖層的產狀、地面坡度和路線方向。 -
Through the analysis we found that the effect will become more obviously with the increase of thickness or width of superstratum and the decrease of the coefficient of foundation bed ; ( 3 ) anisotropy and nonlinear elastic f. e. m. model has been established and the effect of stress dispersion in compound two - layer foundation was analyzed on the base of the model. from the analysis we can conclude that the coefficient of subsidiary stress dispersion will amplify with the increase of thickness or width or stiffness of back - up coat ; ( 4 ) the formula which can be used in conventional calculation has been deduced for calculating the coefficient of subsidiary stress dispersion and it also has been affirmed to be reasonable through the checking calculation ; the whole theory of compound two - layer foundation has been brought forward in this paper and it ' ll enrich the theory of composite foundation
針對以上問題本文做了以下一些工作並得到若干結論： （ 1 ）提出了「復合雙層地基」的概念，並通過工程實例證明此概念的提出有其合理性和必要性； （ 2 ）用彈性地基梁理論證實了復合雙層地基確有應力擴散效應，且擴散效應隨上覆硬層厚度、剛度的增加而增大，隨下臥層基床系數的增大而減小； （ 3 ）建立了非線彈性、各向異性有限元模型，並以此為基礎分析了復合雙層地基的應力擴散效應，得到附加應力系數隨加固層厚度、寬度、剛度的增加而增大的結論； （ 4 ）推導了可用於常規計算的復合雙層地基應力擴散系數公式，並代入工程實例進行了驗證。 -
While the thickness of inter - bed is less than / 4, we lost visual resolution, we can solve this problem through muti - attribute analysis
但當地層厚度小於4時，視覺解析度消失，可以利用屬性綜合分析解決。 -
It is found that the appropriate lowering of the chamber temperature of water gas producer and the thickness of coal bed is favorable to controlling the volume fraction of o2 and co in the recovered flue gas
通過試驗與分析，發現適當降低水煤氣發生爐爐溫與煤層厚度，有利於控制回收煙氣中o2及co的體積分數。 -
Thickness of mortarat bed joint
水平灰縫厚度49 -
With practical engineering examples, this paper deals with the collection of surface wave signal along with seismic refraction exploration, the utilization of surface wave components to make analysis during data processing, the thickness division of overburden bed, strongly - weathered bed, intermediately - weathered bed and weakly - weathered bed in combination with the refraction data, and mutual reflection and interpretation of the burial condition of the bedrock surface
筆者結合工程實例，介紹了在地震折射勘探中同時採集面波信號，在資料處理時利用面波組份進行分析，配合折射資料對測區覆蓋層、強風化層、中風化層及弱風化層厚度進行劃分，同時相互映證解釋基巖面的埋藏情況。 -
By means of stress - strain feature of upper and lower strata of fold neutral plane in the course of longitudinal fold formation, the differences between the upper coal bed and lower coal bed of fold neutral plane are analyzed from the coal thickness, coal structure, coal body structure, coalbed gas occurrence and diversities etc., revealing the cause of these appearances
摘要利用縱彎褶皺變形中中和面上下巖層的不同應力與應變特點，分析了處于褶皺中和面上下各煤層在背斜與向斜部位煤層厚度、煤層構造、煤體結構及煤層瓦斯的賦存規律與差異性，揭示了這些現象產生的原因。 -
In this paper, high heat penetration into a moving particulate bed is described mathematically with a comprehensive heat and mass transfer model. the distribution of gas velocity and pressure, the temperature field of gas and solid in the moving particulate bed are examined for different conditions. the results show that thermal penetration into the moving packed - bed particles by fluid flow in porous media is high only in the position near the gas entrance. the thermal penetration thickness tends to increase with the fluid flow velocity and decrease with the particle moving velocity. in the region of thermal penetration, the porosity of solid bed has significant effect on gas field and pressure loss. it is feasible to reduce the gas pressure loss by a larger width / height packed bed in design and operation. the correspondence between thermal infection depth and particle bed height would be helpful to keep high oapacity of reactor and reduce the cost of operation
針對移動顆粒床中物料層內的高溫氣體滲流傳熱現象，考慮滲流與傳熱的相互作用，採用局部非熱平衡假設建立了多孔介質滲流傳熱物理數學模型並進行了數值計算.研究了不同情況下床內填充多孔介質中的流速、氣固溫度和床層壓力損失.計算結果表明，高溫熱氣對移動床顆粒料層的熱滲透主要發生在滲流入口端區域，增大入口滲流速度以及減小床層物料下移速度將導致物料溫度沿床高慢速下降，熱滲透深度擴大，熱滲透作用區域內的物料溫度水平提高.在熱滲透作用區域，孔隙率對流場和壓力損失有很大的影響.研究結果對于移動顆粒床反應器的設計與運行具有一定的參考作用 -
Exaggerated sections distort the shapes of folds as well as bed thickness.
比例放大的剖面歪曲褶皺的形態和巖層厚度。 -
The experiments show that the main origins of causing the oil and water zones complicated in the study area on the one hand is pore structure, fine particle size and shale content high, resulting in saturation of irreducible water of the reservoirs varying greatly, on the other hand is mud invasion influence, resulting in the reservoir receptivity decreasing, and the third is the thin bed is restricted by logging resolution, resulting in measure value influenced by the bed thickness
研究得出，研究區復雜油水層主要成因一是儲層孔隙結構復雜，巖性細，泥質含量高，導致儲層束縛水飽和度變化大；二是泥漿侵入影響，導致油層電阻率降低；三是薄層受測井分辨能力的限制，其測量值受層厚影響。 -
To design thickness of ballast bed is based on the required strength of track structure and partly the experience in national railway
現行的地鐵設計規?對道床厚度的選擇僅根據軌道強度要求和國鐵的經驗確定。 -
Through analyzing bed ' s response to wave, in the condition that super - stratum is more hard and second - stratum is more soft in region of interest, super static interstitial hydraulic pressure amplitude die away rapidly between stratums, before in sight of boundary between hard and soft stratum, plane effective pressure increase to max. shear stress reach peak value when bed thickness is approximately 2. 7 meters, then it will decrease to the minimum on the place where the flexible soil has a common boundary with the rigidity, so the boundary is the most destroy plane on engineering. on the basis of reconnaissance in situ, in normal situation of sea, the structure slides to the basin along the boundary
通過對底床在波浪下的響應分析，對于研究區底床上層較硬而第二層較軟的情況，超靜孔隙水壓力幅值在層間交界處迅速衰減，在臨近硬、軟地層交界處前，水平有效應力增至最大，剪切應力在底床厚度大約2 . 7米左右達到峰值，然後減小，到硬、軟層土交界位置，達到最小，因此這個界面就是最容易發生破壞的工程軟弱面，現場勘查證明，即使在正常海況下，構築物也會沿坡以此交界面為滑動面，緩慢向「盆」底滑動。 -
The conclusions are as follows : ( 1 ) high - pressure water - atomization can be used to produce a pre - alloyed steel powder with high apparent density, high green strength, size - stability after sintering and low hydrogen - loss content ; ( 2 ) the higher smelting temperature and / or water pressure, the finer particle size of steel powders ; ( 3 ) when the atomization angle holds in a reasonable value ' s range the obtained powder will have a better particle size distribution ; ( 4 ) an optimum atomization technological parameters : liquid steel flux, water pressure and water prick angle was obtained ( 5 ) reduction variables ( temperature, holding time, material - bed ' s thickness and reducing gas flux ) have a significant effect on the particle agglomeration and properties of final powder was given ( 6 ) different alloying methods were developed to modify properties of ferrous powder materials and hence to broaden its applications in ferrous powder metallurgy industry
本文系統研究了水霧化預合金鋼粉生產工藝及合金化方法對鐵基粉末冶金材料性能影響，詳細研究了冶煉、霧化、還原工藝參數對預合金鋼粉化學成份和物理性能影響，並得出如下結論： （ 1 ）採用高壓水霧化技術可用於生產高密度、高強度、尺寸穩定性的低氫損含量的水霧化預合金鋼粉。 （ 2 ）冶煉溫度越高，高壓水壓力越大，所得生粉顆粒粒度越細。 （ 3 ）水錐角調整在一個適當角度范圍內可獲得粒度組成較好的生粉。 -
( 2 ) study on the mechanics mechanism of the calamity caused by the cave of the highway : based on the investigation in detail along the line of the highway in shan - gan loess plateau, the distribution law, the classification and characteristic of hazard of highway cave are presented ; the calamity mechanism of highway cave opposite side slope and road bed is discussed, especially the mechanism of collapsing of the hidden cave in road bed. propose " the effect of hidden corrosion ", etc. 10 kinds send to mechanism of collapsing. based on the principle of limit balance, the formula of the critical treating thickness of hidden cave is put forward as follows : according to different stratum, different size and depth, the calculation of the critical thickness of the hidden cave of roadbed has been carried on
（ 2 ）公路洞穴的致災力學機理研究：在對陜甘黃土高原區公路沿線黃土洞穴詳細調查基礎上，研究了公路洞穴分佈規律、危害分類及致災特點；公路洞穴對邊坡及路基的致災機理，重點是路基暗穴致塌機理，並提出了「潛蝕效應」等十種致塌機制；利用極限平衡原理導出路基暗穴臨界處理厚度計算公式如下：針對不同地區不同地層，對不同尺寸和埋深的暗穴，進行了路基暗穴臨界處理厚度的計算。 -
Study on formation of biofilm and biofilm thickness in a three - phase bio - fluidized bed with external loop
外循環三相生物流化床載體掛膜的研究 -
The result shows that the electric property and position and occurrence of anomalous body, the resistivity of bed rock, can be obtained correctly however only the composite value of resistivity and thickness of anomalous body can be determined because of equivalence
反演結果可準確反映圍巖電阻率、異常體的電性、位置和產狀；而由於同層等值現象，反演結果只能確定異常體的厚度和電阻率的組合值。 -
In this paper, we applied the vapor - liquid - solid three - phase circulating fluidized bed evaporator to condense glucose solution considering its advantage. in the experiment, we changed the parameters such as evaporation temperature, difference in temperature of the fluid heating and heated, liquid flux, liquid thickness and the ratio of inert particles to analyze and study this kind of equipment ' s heat transfer properties in different operational conditions
通過改變蒸發溫度、傳熱溫差、料液流量、料液濃度以及惰性粒子的體積分率等參數，研究了其在不同操作條件下的傳熱性能，並給出了汽-液-固三相循環流化床蒸發器沸騰傳熱的數學模型，模型預測值與實驗值吻合較好。 -
Analyzed the bad engineering geological character and its reason. according to the red - bed rock ' s embedment depth, thickness of the weathered zone and its mechanical strength, the zone of hefei city ' s red - bed were made
根據合肥紅層的分佈、埋深、風化帶厚度、巖石的強度等特徵對合肥市進行工程地質分區和巖體工程地質分區。 -
The borehole ultrasonic imaging method can precisely reflect the smoothness of the borehole wall, and then judge the weathering degree of the rock and determine thickness of the weathering bed
摘要鉆孔超聲成像方法能精確地反映井壁的光滑情況，進而判斷巖石的風化發育程度，確定風化層的厚度。
分享友人