tissue thickness 中文意思是什麼

tissue thickness 解釋
組織厚度
  • tissue : n. 1. 薄絹，薄紗羅（等織物）。2. 薄紙，棉紙 （＝tissue-paper）。3. （編造的謊話等的）一套，一連串。4. 【攝影】碳素印像紙。5. 【生物學】組織。
  • thickness : n 1 厚；粗；厚度；粗大。2 濃度，濃厚，黏稠。3 密度；稠密。4 模糊不清，多煙霧，混濁。5 愚笨；遲鈍...
  1. Get 4 right anterolateral femoral flaps and 4 left scapular flaps which were dyed obviously after 3 days, dehydrate by graded ethanol, vitrification and paraffin embeded, horizontally and vertically sliced continuously, thickness is 15, 20 and loojtim respectively, he dyed, observed under microscope. results : ( 1 ) direct cutaneous artery or musculo - cutaneous artery, in the procedure of common integument tissue being shallowed up step by step, continuously sending out branches to deep fascia layer, superficial fascia layer, hypodermis layer, hypopapilla layer and papilla layer to form the five - grade cutaneous microcirculation " blood vessel tree " of the skin blood vessel network that can be identified

    結果門）亙接皮動脈或肌皮動脈，在體被組織逐步淺出的整個行程中，不斷發出分支並分別在深筋膜層、皮下組織（淺筋膜）層、真皮下層、乳頭下層和乳頭層內形成五級具有鑒別特徵的皮膚微循環血管網（血管樹） 。 （ 2 ）體被組織靜脈血管網由淺入深分為五層：皮膚乳頭層。乳頭下層、真皮下層、皮下組織層和深筋膜層。
  2. Thickness of upper and lower epidermis of leaves, width of xylem and phloem of annual and biennial branches, ratio of late wood to early wood, periderm thickness of biennial branches, and length of xylem ray present decreasing trends with latitude ascending ; while ratio of palisade tissue to spongy tissue, epidermis thickness of annual branches, and cortex thickness of biennial branches show unobvious variations with latitude increasing

    葉的上下表皮厚度、 1和2年生枝木質部及韌皮部寬度、晚材早材比值、 2年生枝的周皮厚度、木射線長等均隨緯度升高而呈下降趨勢；而葉的柵欄組織和海綿組織比值、 1年生枝表皮厚度、 2年生皮層厚度等解剖結構隨緯度變化沒有明顯規律。
  3. Drought resistances of leaves of 13 rasberry and blackberry were measured based on 7 xeromorphic indexes, including thickness of leaves, ratio of palisade tissue thickness to cutis tissue, thickness extent of palisade cell density, thickness of cuticular, thickness of two sides of cutis

    摘要選取7項葉片旱生結構指標（葉片厚度，柵欄組織厚度葉肉組織厚度，細胞密集度，角質層厚度，上、下表皮厚度） ，觀察測定了13個樹莓和黑莓品種的葉片的相關指標。
  4. Birth weight prediction for ultrasonic measurement of fetal thigh soft tissue thickness

    超聲測量胎兒股骨皮下組織厚度預測胎兒體重的臨床應用
  5. Birth weight prediction by ultrasonic measurement of fetal thigh soft tissue thickness

    超聲測量胎兒股骨皮下組織厚度與預測出生體重的相關性探討
  6. Tissue paper and tissue products - part 3 : determination of thickness, bulking thickness and apparent bulk density

    薄紙和薄紙製品.第3部分:厚度膨鬆厚度和表觀體密度的測定
  7. Tissue paper and tissue products - part 3 : determination of thickness, bulking thickness and apparent bulk density iso 12625 - 3 : 2005 ; german version en iso 12625 - 3 : 2005

    薄紙和薄紙製品.第3部分:厚度膨鬆厚度和表觀體密度
  8. The results showed that the differences of leaf thickness, cutin layer thickness, stockade tissue thickness, sponge tissue thickness, ratio of stockade tissue thickness to sponge tissue thickness, tightness of leaf tissue structure, sedimentation of leaf tissue structure and stoma density were significant, while the differences of the sizes of upper epidermis and lower epidermis were not

    葉片厚度、角質層厚度、柵欄組織厚度、柵欄組織與海綿組織厚度的比值、葉片結構緊密度和氣孔密度等值越大的含笑，受旱危害愈輕，其抗旱性就越強。
  9. The trees with thick cutin layer, high stoma density, thick stockade tissue, high ratio of stockade tissue thickness to sponge tissue thickness, and high sedimentation of leaf tissue structure are of greater drought resistance

    葉片厚度、尤其是角質層的厚度和海綿組織厚度是評價供試含笑抗旱性的重要解剖指標。
  10. 7 within the range of 0 - 200mm nacl concentration, the ratio between cortical thickness and root got lower ; the growth of stele was stimulated ; vessel dm decreased evidently. in stele, conducting tissue was reduced while the growth of pith was stimulated

    隨鹽濃度升高，在0億00inmnaci范圍內根皮層半徑的比重降低，維管束在根中的比重逐漸增加，但輸導組織的比重呈下降趨勢，具貯存功能的髓的發育得到促進，導管口徑變小。
  11. Use varying levels of pressure for each palpation from light to deep, to examine the full thickness of your breast tissue

    觸摸乳部每一部位時，要用不同程度的壓力，先用輕微的壓力作小圓圈的動作觸摸，再用中等壓力，然後加強壓力，直到手指觸摸到肋骨。
  12. Aim : to analyze the mechanism, thermadynamic theoretical basis, dynamic mechanism and influencing factors of thermally induced phase separation ( tips ) in order to completely grasp the factors affecting the size, distribution and form of pores, so that the adjusted range of pore can be widened and the preparation of porous membrane can be repeated and controlled. methods : considering from the structural characteristics of tissue engineered materials, the methods of preparing porous membrane using tips technique, the hermadynamic theoretical basis, dynamic mechanism and influencing factors were analyzed, the problems and investigative directions in the future were also analyzed. tips technique is a process of phase separation of polymer homogenous solution under quenching, and it is suitable for diameter and structural form of the micropore materials prepared using tips are closely correlated with the kind and dispensing proportion of polymer attrnuant, polymer concentration and polymer molecular mass, etc. conducted, including determination of polymer - solvent system phase diagram, study of form and appearance of porous membrane of different thickness, study of form and appearance of porous membrane prepared with systems of different x, which is the parameter of polymer - solvent interaction

    目的:分析熱致相分離成膜過程的機理、熱力學理論基礎、動力學機制以及影響因素，以便充分掌握影響孔度大小、分佈、形態的因素，使孔度調控范圍得以拓寬，使多孔膜的制備能重復可控.方法:從組織工程材料結構特點出發，分析熱致相分離聚合物多孔膜的制備方法及該法成膜的熱力學理論基礎、動力學機制以及影響因素.並分析實驗中存在的問題及今後的研究方向.結果:以熱致相分離法可制備聚合物多孔膜.熱致相分離法制備多孔膜是高聚物均相溶液在淬冷條件下發生相分離的過程，它適用於上臨界共溶溫度型聚合物一稀釋劑二元體系.熱致相分離法成膜的過程，可以認為是旋節線機理佔主導地位.熱致相分離法制備的微孔材料，其孔隙率、孔徑大小、結構形態與聚合物稀釋劑的種類、組成配比、聚合物濃度、聚合物分子量等因素密切相關.結論:可採用熱致相分離技術制備多孔膜，通過改變不同的成膜條件可獲得一系列不同孔徑尺寸和孔徑分佈的多孔膜材料.對熱致相分離成膜過程中聚合物-溶劑體系的相圖測定，不同厚度的多孔膜形貌研究，不同x （聚合物-溶劑相互作用參數）體系所制備的多孔膜形貌等需深人研究
  13. In this procedure, a standard model of tibia and fibula was scaled and positioned according to the thickness of soft tissue at patellar tendon and fibular head, and then nodes and elements could be generated automatically according to the preference of user. soft tissues modulus in fe models was obtained with in - vivo measurement of the individual, the socket rectification was simulated by applying radial displacements to corresponding nodes

    在有限元應力分析部分，本文建立了專門針對膝下假肢的有限元建模方法，包括自動骨定位和自動網格劃分，建模時對前人的模型做了優化，考慮了骨和軟組織材料的影響，同時也滿足了臨床使用的快捷、方便的要求。
  14. 2 leaflets from plants grown in the increasing salt concentrations ( up to 200mm ) became smaller and thicker, leading to the smaller ratio between superficial area and mesophyll tissue volume. in the same process, the cuticle became thickness significantly increased while stomata became less in number and smaller in area

    （ 2 ）隨鹽濃度增加，葉片整體逐漸變得小而厚，葉表面積與體積的比值小，從而減少蒸騰面積，同時角質層變厚，單位面積上的氣孔數目減少，氣孔器面積減小，都可以使植物盡量降低蒸騰速率，減少體內水分散失。
  15. Parameters were the shade of color and hardness of the scar tissue, thickness and size of scar, and subjective symptoms

    療效評估參數為：疤痕組織的色澤和硬度，疤痕的厚度和大小以及主觀癥狀。
  16. Patients with full - thickness burns or after excision of large areas of skin usually suffer from a sub - stantial loss of dermal tissue ? in general, these wounds are repaired with split - skin grafts

    摘要皮膚損傷常見于各種外傷或疾病，倒如挫傷、燒傷、燙傷、糖尿病、褥瘡、傷口久不愈合等。
  17. Tissue paper and tissue products - determination of thickness, bulking thickness and apparent bulk density

    薄紙和薄紙製品.厚度膨脹厚度和表觀體密度的測定
分享友人
分享到 Line

分享到臉書