top inlet 中文意思是什麼

top inlet 解釋
頂部進氣道
  • top : n (opp bottom foot)1 頂,頂部,頂端。2 頭,頭頂;尖端;樹梢,樹頂;(事物的)上層部分。3 最高位...
  • inlet : n. 1. 進口,入口。2. 【電學】引入,輸入,輸入線。3. 水灣,小港。4. 插入物,鑲嵌物。vt. (inlet, inletting)1. 引進。2. 嵌入,插入。
  1. On top of one of the fast - opening ends that closed to the pig receiver & launcher shall assemble vent valve, safety valve and pressure gauge, and at the bottom shall assemble drain valve, sideway inlet and vent valve to take out medium from the main pipe as the power of forcing pig and conveyance medium

    靠近收發球筒快開盲板一端上部應設防空閥、安全閥及壓力表、下部設排污閥、側面設進、出油(氣、水)閥,以便從干管中取介質作為驅動清管器的動力及輸出介質。
  2. The urinal flush valve is able to be connected with top or rear water inlet urinal ceramics

    吉博力小便沖洗閥可與上進水或后進水的小便器相連。
  3. In order to producte qualified inlet manifold casting, top gating system with lip riser and shell core made of precoated sand is used

    為了獲得合格的進氣歧管鑄件,採用壓邊頂鑄澆注系統和覆膜砂殼芯製作工藝。
  4. As one of the three main parts of the dujiangyan irrigation system, it controls the water that flows into the baopingkou water inlet and discharges flood and sand with its top graphical feature

    巧妙利用河道地形的泄洪排沙工程,為控制內江進水量的關鍵所在,是都江堰渠首工程三大主體之一。
  5. As an inlet structure, the forbay is an important part of the pumping station. the pressurized forbay, close in top structure, is a kind of particular forbay in which water is pressurized. based on the integral hydraulic model test of shanghai changqiao waterwork ' s water - transport pumping station, some research on the hydraulic characteristics of the pressurized forbay has been done in the paper. the main content is listed as follows : l. the hydraulic characteristics of the pressurized forbay in different water supply combination and different pump unit combination without divertion measure, and the reason of the poor flow state. 2. the hydraulic characteristics of the pressurized forbay with diversion pier, and the reason why the flow state can be improved. 3. the experimental research on the critical air suction condition of the pressurized forbay

    本文基於上海長橋自來水廠改造工程送水泵站整體水力模型試驗,對有壓前池的水力特性進行了研究,研究的主要內容如下: 1 、無導流措施的有壓前池在不同供水組合及不同機組開機組合條件下的水力特性,並分析了流態較差的原因; 2 、加設導流墩後有壓前池的水力特性,以及加設導流墩流態改善的原因; 3 、有壓前池進氣臨界條件的試驗研究; 4 、水泵進氣以後水泵性能的討論。
  6. Open the inlet water valve and press the top discharge valve to discharge the air in the filter at the same time

    打開進水閥門,同時按下頂上排氣閥,使濾器內空氣排出即可。
分享友人